Assessment of artefacts produced by metal posts on CBCT images.

AIM: To evaluate artefact intensity in cone beam computed tomography (CBCT) images of two alloys used in metal posts scanned using different exposure parameters. METHODOLOGY: The sample consisted of 20 single-rooted teeth divided into two groups for use with either a NiCr post or AgPd post. All teeth were scanned with and without their corresponding metal posts and with and without the presence of an extra restored tooth in the arch. The samples were scanned using CS 9000 3D scanner with two exposure protocols: 85 kV 6.3 mA and 85 kV 10 mA. Voxel size and FOV were fixed at 0.100 mm and 5 cm × 3.75 cm. The presence of artefacts was assessed qualitatively by two calibrated observers using the CBCT volume and paired 2D images, and quantitatively by one trained observer, using ImageJ software. Wilcoxon's signed rank, Mann-Whitney, kappa and chi-square tests were used for qualitative analyses. Two-way anova and Tukey's tests were used for quantitative analyses. All analyses were conducted considering the 95% confidence level (α < 0.05). RESULTS: For the CBCT volume qualitative analysis, significant differences were observed between the metal alloys in the presence of an extra restored tooth, with higher artefact intensity for AgPd when assessing hypodense halos and lines (P = 0.006). Images with two restored teeth had significantly more hypodense and hyperdense lines (P = 0.033). When evaluating exposure parameters and number of restored teeth, the paired image quality analysis revealed significant disagreement between observers for diagnostic image quality (P = 0.001). Quantitative artefact analysis revealed higher artefact intensity for the AgPd posts in the presence of two restored teeth. CONCLUSION: Although the exposure parameters tested did not interfere with artefact intensity, post alloys with a higher atomic number and the presence of another metal structure in the arch increased artefact intensity and impaired the diagnostic quality of CBCT images.

Digital radiographs displayed on different devices: effect on the detection of vertical root fractures.

AIM: To evaluate whether the type of display device affects the detection of vertical root fractures (VRFs) on digital radiographs in unfilled canals and canals with fibreglass posts. METHODOLOGY: Forty single-rooted human teeth were decoronated, and the root canals were prepared. The teeth were divided into 2 groups: controls (20 teeth) and with VRF (20 teeth). The VRFs were induced using an universal testing machine. Periapical radiographs of all teeth, with canal unfilled or with a fibreglass post, were obtained using the parallel technique in 3 directions (ortho-, mesio- and distoradial) on storage phosphor plates (VistaScan®). All images were evaluated and re-evaluated after 30 days by 3 examiners on a 5-point scale using 4 different devices (notebook display with full high definition resolution, desktop display with a standard resolution, 8-inch Android(™) tablet with high definition resolution and a 9.7-inch iPad® tablet with Retina resolution). Areas under ROC curves, sensitivity, specificity and accuracy values were compared by anova. RESULTS: The weighted kappa values for intra- and interobserver reproducibility were 0.55-0.88 and 0.31-0.65, respectively. There was a significant difference (P < 0.05) in relation to the area under the ROC curve, specificity and sensitivity when unfilled canals were compared with canals with a fibreglass post; however, no difference was observed for the different devices studied. CONCLUSIONS: The type of display device did not affect the detection of VRFs. Thus, the detection of VRFs can be performed using different screen sizes and resolutions.