RESUMO
OBJECTIVES: Reconstruction of a three-dimensional jaw position determined by a bite recording is an important aspect of prosthetic therapy. Different materials are used for this purpose. In the dental technical workflow, recordings are used to mount a lower jaw cast in a patient-like spatial position relative to the upper jaw cast. We evaluated the accuracy of positioning under the influence of different jaw positions and materials. MATERIALS AND METHODS: In an experimental setup, comprising an articulator, a pair of metal casts, and an optoelectronic measurement system, the spatial position of the incisal point and two condylar points were measured. To evaluate the accuracy of repeated repositioning of casts in the technical workflow, 324 measurements were taken from 108 recordings, consisting of silicone bite-stops made of addition curing silicone with 95 shore hardness, acrylic wafers, and wax recordings. The recordings were obtained in four jaw relations differing in vertical and protrusive components. RESULTS: Of the three materials/material combinations examined, silicone showed the most consistent results across all measurements, followed by the acrylic wafer system, and then wax recordings. Generally, recordings with smaller gaps between the jaws and no protrusive components showed greater deviations compared to jaw positions with greater protrusion and higher vertical dimensions. CONCLUSIONS AND CLINICAL RELEVANCE: To achieve reliable model mounting with high accuracy, recordings should include the use of a frontal jig and four small recording platelets made of silicone, especially if only a slight elevation of the vertical dimension is needed.
Assuntos
Articuladores Dentários , Mandíbula , Humanos , Registro da Relação Maxilomandibular/métodos , Dimensão Vertical , SiliconesRESUMO
BACKGROUND: Jaw clenching improves dynamic reactive balance on an oscillating platform during forward acceleration and is associated with decreased mean sway speed of different body regions. OBJECTIVE: It is suggested that jaw clenching as a concurrent muscle activity facilitates human motor excitability, increasing the neural drive to distal muscles. The underlying mechanism behind this phenomenon was studied based on leg and trunk muscle activity (iEMG) and co-contraction ratio (CCR). METHODS: Forty-eight physically active and healthy adults were assigned to three groups, performing three oral motor tasks (jaw clenching, tongue pressing against the palate or habitual lower jaw position) during a dynamic one-legged stance reactive balance task on an oscillating platform. The iEMG and CCR of posture-relevant muscles and muscle pairs were analysed during platform forward acceleration. RESULTS: Tongue pressing caused an adjustment of co-contraction patterns of distal muscle groups based on changes in biomechanical coupling between the head and trunk during static balancing at the beginning of the experiment. Neither iEMG nor CCR measurement helped detect a general neuromuscular effect of jaw clenching on the dynamic reactive balance. CONCLUSION: The findings might indicate the existence of robust fixed patterns of rapid postural responses during the important initial phases of balance recovery.