RESUMO
The atomic layer thin geometry and semi-metallic band diagram of graphene can be utilized for significantly improving the performance matrix of integrated photonic devices. Its semiconductor-like behavior of Fermi-level tunability allows graphene to serve as an active layer for electro-optic modulation. As a low loss metal layer, graphene can be placed much closer to active layer for low voltage operation. In this work, we investigate hybrid device architectures utilizing semiconductor and metallic properties of the graphene for ultrafast and energy efficient electro-optic phase modulators on semiconductor and dielectric platforms. (1) Directly contacted graphene-silicon heterojunctions. Without oxide layer, the carrier density of graphene can be modulated by the directly contact to silicon layer, while silicon intrinsic region stays mostly depleted. With doped silicon as electrodes, carrier can be quickly injected and depleted from the active region in graphene. The ultrafast carrier transit time and small RC constant promise ultrafast modulation speed (3dB bandwidth of 67 GHz) with an estimated Vπ·L of 1.19 V·mm. (2) Graphene integrated lithium niobite modulator. As a transparent electrode, graphene can be placed close to integrated lithium niobate waveguide for improving coupling coefficient between optical mode profile and electric field with minimal additional loss (4.6 dB/cm). Numerical simulation indicates 2.5× improvement of electro-optic field overlap coefficient, with estimated V π of 0.2 V.
RESUMO
Atomic vacancies related to structural disorder and doping variation influence carrier transport in monolayer transition-metal dichalcogenide devices. Here, we investigate the effect of hydrogen plasma exposure (HPE) on monolayer MoS2 field-effect transistors (FETs). We observe that a 1% increase in sulfur vacancy after HPE results in incremental 0.06 eV of the Schottky barrier. Short-range scattering from the sulfur vacancies reduces the carrier mobility of monolayer MoS2 by 2 orders of magnitude. Despite the defects and grain boundaries formed during the chemical vapor deposition and transferring process, the surface desulfurization induced by the proton exposure and thermally accelerated oxidation can be blocked by monolayer graphene cladding with a van der Waals contact distance of 2.5 Å. The material-level study indicates a promising route for a low-cost and robust fabrication of smart sensor circuits on a monolithic MoS2 wafer, where the bare MoS2 FETs can serve as proton sensors, with their electronic readout processed by a logic circuit of graphene-protected pristine FETs with a high on/off ratio.
RESUMO
Passivation of the interface defect states is crucial to mitigate the recombination losses in silicon solar cells. In this work, we have investigated the role of hydrogen plasma treatment (HPT) to passivate the interfacial defects between crystalline (c-Si) and hydrogenated amorphous silicon (a-Si:H) in silicon heterojunction (SHJ) solar cells. For the first time, we have found a correlation between the dynamic properties of hydrogen plasma and passivation quality of the films by using in situ optical emission spectroscopy and quasi-steady state photoconductance measurement. The optimum condition for saturation of the dangling bonds by HPT has been studied in detail by tuning the excited hydrogen (H) species and ion bombardment energies by controlling physical parameters like plasma current and chamber pressure. We have investigated the role of annealing after HPT to redistribute the H in the post-treated a-Si:H film and have obtained an i Voc of 755 mV, minority carrier lifetime (τeff) of 4.6 ms, and SRV of 1.5 cm/s on test structures having only an 10 nm intrinsic a-Si:H layer on textured silicon wafers. The H bond configuration at the interface of a-Si:H and c-Si has been investigated by Fourier transform infrared spectroscopy, which demonstrates improved monohydride bonding in the films after HPT derived from the analysis of microstructure parameter and H concentration values. Raman spectroscopy shows the absence of the nanocrystalline fraction after HPT and verifies reduced coordination defects due to annealing after HPT. The proof of concept has been validated by fabricated SHJ solar cells having a Voc of 729 mV and efficiency of 18.7% after HPT, with the best cell efficiency reaching 20.2% after doped layer optimization. The decrease in reverse saturation current and ideality factor after HPT verifies that the improvement in performance is from reduced recombination losses at the interface due to passivation of defects in midgap states.
RESUMO
Metasurfaces can be programmed for a spatial transformation of the wavefront, thus allowing parallel optical signal processing on-chip within an ultracompact dimension. On-chip metasurfaces have been implemented with two-dimensional periodic structures, however, their inherent scattering loss limits their large-scale implementation. The scattering can be minimized in single layer high-contrast transmitarray (HCTA) metasurface. Here we demonstrate a one-dimensional HCTA based lens defined on a standard silicon-on-insulator substrate, with its high transmission (<1 dB loss) maintained over a 200 nm bandwidth. Three layers of the HCTAs are cascaded for demonstrating meta-system functionalities of Fourier transformation and differentiation. The meta-system design holds potential for realizing on-chip transformation optics, mathematical operations and spectrometers, with applications in areas of imaging, sensing and quantum information processing.