An evaluation of source apportionment of fine OC and PM2.5 by multiple methods: APHH-Beijing campaigns as a case study.

This study aims to critically evaluate the source apportionment of fine particles by multiple receptor modelling approaches, including carbon mass balance modelling of filter-based radiocarbon (14C) data, Chemical Mass Balance (CMB) and Positive Matrix Factorization (PMF) analysis on filter-based chemical speciation data, and PMF analysis on Aerosol Mass Spectrometer (AMS-PMF) or Aerosol Chemical Speciation Monitor (ACSM-PMF) data. These data were collected as part of the APHH-Beijing (Atmospheric Pollution and Human Health in a Chinese Megacity) field observation campaigns from 10th November to 12th December in winter 2016 and from 22nd May to 24th June in summer 2017. 14C analysis revealed the predominant contribution of fossil fuel combustion to carbonaceous aerosols in winter compared with non-fossil fuel sources, which is supported by the results from other methods. An extended Gelencsér (EG) method incorporating 14C data, as well as the CMB and AMS/ACSM-PMF methods, generated a consistent source apportionment for fossil fuel related primary organic carbon. Coal combustion, traffic and biomass burning POC were comparable for CMB and AMS/ACSM-PMF. There are uncertainties in the EG method when estimating biomass burning and cooking OC. The POC from cooking estimated by different methods was poorly correlated, suggesting a large uncertainty when differentiating this source type. The PM2.5 source apportionment results varied between different methods. Through a comparison and correlation analysis of CMB, PMF and AMS/ACSM-PMF, the CMB method appears to give the most complete and representative source apportionment of Beijing aerosols. Based upon the CMB results, fine aerosols in Beijing were mainly secondary inorganic ion formation, secondary organic aerosol formation, primary coal combustion and from biomass burning emissions.

Analysis and determination of secondary organic aerosol (SOA) tracers (markers) in particulate matter standard reference material (SRM 1649b, urban dust).

Secondary organic aerosol (SOA) accounts for a significant fraction of particulate matter (PM) in the atmosphere. Source identification, including the SOA fraction, is critical for the effective management of air pollution. Molecular SOA markers (tracers) are key compounds allowing the source apportionment of SOA using different methodologies. Therefore, accurate SOA marker measurements in ambient air PM are important. This study determined the concentrations of 12 key SOA markers (biogenic and anthropogenic) in the urban dust standard reference material available from the National Institute of Standards and Technology (NIST) (SRM 1649b). Two extraction procedures, sonication and QuEChERS-like (quick easy cheap effective rugged and safe), have been compared. Three research laboratories/institutes using two analytical techniques (gas chromatography/mass spectrometry (GC/MS) and ultra-high-pressure liquid chromatography/tandem mass spectrometry (HPLC/MS-MS)) carried out the analyses. The results obtained were all in good agreement, except for 2-methylerythritol. The analysis of this compound still seems to be challenging by both GC/MS (large injection repeatability) and HPLC/MS-MS (separation issues of both 2-methyltetrols: 2-methylthreitol and 2-methylerythritol). Possible inhomogeneity in the SRM for this compound could also explain the large discrepancies observed. Sonication and QuEChERS-like procedures gave comparable results for the extraction of the SOA markers showing that QuEChERS-like extraction is suitable for the analysis of SOA markers in ambient air PM. As this study provides, for the first time, indicative values in a reference material for typical SOA markers, the analysis of SRM 1649b (urban dust) could be used for quality control/assurance purposes. Graphical abstract.

Characterization of products formed from the oxidation of toluene and m-xylene with varying NOx and OH exposure.

Aromatic volatile organic compounds (VOCs) are an important precursor of secondary organic aerosol (SOA) in the urban environment. SOA formed from the oxidation of anthropogenic VOCs can be substantially more abundant than biogenic SOA and has been shown to account for a significant fraction of fine particulate matter in urban areas. A potential aerosol mass (PAM) chamber was used to investigate the oxidised products from the photo-oxidation of m-xylene and toluene. The experiments were carried out with OH radical as oxidant in both high- and low-NOx conditions and the resultant aerosol samples were collected using quartz filters and analysed by GC × GC-TOFMS. Results show the oxidation products derived from both precursors included ring-retaining and -opening compounds (unsaturated aldehydes, unsaturated ketones and organic acids) with a high number of ring-opening compounds observed from toluene oxidation. Glyoxal and methyl glyoxal were the major ring-cleavage products from both oxidation systems, indicating that a bicyclic route plays an important role in their formation. SOA yields were higher for both precursors under high-NOx (toluene: 0.111; m-xylene: 0.124) than at low-NOx (toluene: 0.089; m-xylene: 0.052), likely linked to higher OH concentrations during low-NOx experiments which may lead to higher degree of fragmentation. DHOPA (2,3-dihydroxy-4-oxo-pentanoic acid), a known tracer of toluene oxidation, was observed in both oxidation systems. The mass fraction of DHOPA in SOA from toluene oxidation was about double the value reported previously, but it should not be regarded as a tracer solely for oxidation of toluene as m-xylene oxidation gave a similar relative yield.

Modelling aerosol molecular markers in a 3D air quality model: Focus on anthropogenic organic markers.

We developed and implemented in the 3D air quality model CHIMERE the formation of several key anthropogenic aerosol markers including one primary anthropogenic marker (levoglucosan) and 4 secondary anthropogenic markers (nitrophenols, nitroguaiacols, methylnitrocatechols and phthalic acid). Modelled concentrations have been compared to measurements performed at 12 locations in France for levoglucosan in winter 2014-15, and at a sub-urban station in the Paris region over the whole year 2015 for secondary molecular markers. While a good estimation of levoglucosan concentrations by the model has been obtained for a few sites, a strong underestimation was simulated for most of the stations especially for western locations due to a probable underestimation of residential wood burning emissions. The simulated ratio between wood burning organic matter and particulate phase levoglucosan is constant only at high OM values (>10 µg m-3) indicating that using marker contribution ratio may be valid only under certain conditions. Concentrations of secondary markers were well reproduced by the model for nitrophenols and nitroguaiacols but were underestimated for methylnitrocatechols and phthalic acid highlighting missing formation pathways and/or precursor emissions. By comparing modelled to measured Gas/Particle Partitioning (GPP) of markers, the simulated partitioning of Semi-Volatile Organic Compounds (SVOCs) was evaluated. Except for nitroguaiacols and nitrophenols when ideality was assumed, the GPP for all the markers was underestimated and mainly driven by the hydrophilic partitioning. SVOCs GPP, and more generally of all SVOC contributing to the formation of SOA, could therefore be significantly underestimated by air quality models, especially when only the partitioning on the organic phase is considered. Our results show that marker modelling can give insights on some processes (such as precursor emissions or missing mechanisms) involved in SOA formation and could prove especially useful to evaluate the GPP in 3D air quality models.

PM2.5 composition and sources in the San Joaquin Valley of California: A long-term study using ToF-ACSM with the capture vaporizer.

The San Joaquin Valley (SJV) of California has suffered persistent particulate matter (PM) pollution despite many years of control efforts. To further understand the chemical drivers of this problem and to support the development of State Implementation Plan for PM, a time-of-flight aerosol chemical speciation monitor (ToF-ACSM) outfitted with a PM2.5 lens and a capture vaporizer has been deployed at the Fresno-Garland air monitoring site of the California Air Resource Board (CARB) since Oct. 2018. The instrument measured non-refractory species in PM2.5 continuously at 10-min resolution. In this study, the data acquired from Oct. 2018 to May 2019 were analyzed to investigate the chemical characteristics, sources and atmospheric processes of PM2.5 in the SJV. Comparisons of the ToF-ACSM measurement with various co-located aerosol instruments show good agreements. The inter-comparisons indicated that PM2.5 in Fresno was dominated by submicron particles during the winter whereas refractory species accounted for a major fraction of PM2.5 mass during the autumn associated with elevated PM10 loadings. A rolling window positive matrix factorization analysis was applied to the organic aerosol (OA) mass spectra using the Multilinear Engine (ME-2) algorithm. Three distinct OA sources were identified, including vehicle emissions, local and regional biomass burning, and formation of oxygenated species. There were significant seasonal variations in PM2.5 composition and sources. During the winter, residential wood burning and oxidation of nitrogen oxides were major contributors to the occurrence of haze episodes with PM2.5 dominated by biomass burning OA and nitrate. In autumn, agricultural activities and wildfires were found to be the main cause of PM pollution. PM2.5 concentrations decreased significantly after spring and were dominated by oxygenated OA during March to May. Our results highlight the importance of using seasonally dependent control strategies to mitigate PM pollution in the SJV.

Speciation of organic fraction does matter for source apportionment. Part 1: A one-year campaign in Grenoble (France).

PM10 source apportionment was performed by positive matrix factorization (PMF) using specific primary and secondary organic molecular markers on samples collected over a one year period (2013) at an urban station in Grenoble (France). The results provided a 9-factor optimum solution, including sources rarely apportioned in the literature, such as two types of primary biogenic organic aerosols (fungal spores and plant debris), as well as specific biogenic and anthropogenic secondary organic aerosols (SOA). These sources were identified thanks to the use of key organic markers, namely, polyols, odd number higher alkanes, and several SOA markers related to the oxidation of isoprene, α-pinene, toluene and polycyclic aromatic hydrocarbons (PAHs). Primary and secondary biogenic contributions together accounted for at least 68% of the total organic carbon (OC) in the summer, while anthropogenic primary and secondary sources represented at least 71% of OC during wintertime. A very significant contribution of anthropogenic SOA was estimated in the winter during an intense PM pollution event (PM10>50µgm-3 for several days; 18% of PM10 and 42% of OC). Specific meteorological conditions with a stagnation of pollutants over 10days and possibly Fenton-like chemistry and self-amplification cycle of SOA formation could explain such high anthropogenic SOA concentrations during this period. Finally, PMF outputs were also used to investigate the origins of humic-like substances (HuLiS), which represented 16% of OC on an annual average basis. The results indicated that HuLiS were mainly associated with biomass burning (22%), secondary inorganic (22%), mineral dust (15%) and biogenic SOA (14%) factors. This study is probably the first to state that HuLiS are significantly associated with mineral dust.