Sorption behavior of chitosan nanoparticles for single and binary removal of cationic and anionic dyes from aqueous solution.

In this study, chitosan nanoparticles (ChNs) were used as an adsorbent for single and simultaneous uptake of cationic (methylene blue (MB)) and anionic (methyl orange (MO)) dyes. ChNs were prepared based on the ionic gelation method using sodium tripolyphosphate (TPP) and characterized by zetasizer, FTIR, BET, SEM, XRD, and pHPZC. The studied parameters that affect removal efficiency included pH, time, and dyes' concentration. The results showed that in single-adsorption mode, the removal of MB is better in alkaline pH, contrary to MO uptake which presents higher removal efficiency in acidic media. The simultaneous removal of MB and MO from the mixture solution by ChNs could be achieved under neutral conditions. The adsorption kinetic results showed that adsorption of MB and MO for both single-adsorption and binary adsorption systems comply with the pseudo-second-order model. Langmuir, Freundlich, and Redlich-Peterson isotherms were used for the mathematical description of single-adsorption equilibrium, while non-modified Langmuir and extended Freundlich isotherms were used to fit the co-adsorption equilibrium results. The maximum adsorption capacities of MB and MO in a single dye adsorption system were 315.01 and 257.05 mg/g for MB and MO, respectively. On the other hand, and for binary adsorption system, the adsorption capacities were 49.05 and 137.03 mg/g, respectively. The adsorption capacity of MB decreases in solution containing MO and vice versa, suggesting an antagonistic behavior of MB and MO on ChNs. Overall, ChNs could be a candidate for single and binary removal of MB and MO in dye-containing wastewater.

Influence of some factors affecting antibacterial activity of PVA/Chitosan based hydrogels synthesized by gamma irradiation.

Poly (vinyl alcohol) hydrogels containing different concentrations of chitosan with molecular weight of 471 and 101 kDa were crosslinked by gamma irradiation at a dose of 25 kGy. The swelling behavior, gel content and morphological structure of the blend were investigated. The antibacterial effect, as a function of chitosan content and molecular weight in the hydrogel, was investigated against Escherichia coli and Bacillus subtilis. With increasing chitosan content the equilibrium degree of swelling of the blend increased and the gel fraction decreased. Results of antibacterial activity of chitosan revealed that chitosan was more effective in inhibiting growth of gram positive bacteria than that of gram negative ones. It was observed that, the chitosan content as well as its molecular weight has a direct influence on bacteria growth inhibition. The higher the chitosan content in the blend and the higher its initial molecular weight, the larger was the inhibition zone diameter. The bacteria growth inhibition was attributed to the diffusion of entrapped chitosan from the hydrogel blend to the culture medium.

The synergistic effect of gamma irradiation and alkaline soaking at low temperature on the pre-deacetylation of α-chitin: Optimization by design of experiment.

The effect of gamma irradiation and alkaline soaking time at low temperature (4 °C) as a pretreatment of α-chitin before its N-deacetylation and the effect temperature, NaOH concentration and the reaction time traditionally used during the deacetylation process were studied by applying a factorial experimental design. The top and bottom levels applied for each factor were 1-25 kGy for γ irradiation dose, 2-18 hours for alkaline soaking time at low temperature (4 °C), 50-85 °C for temperature, 35-60% for NaOH concentration and 30-90 min for reaction time. The measured response of deacetylation degree (DD) was determined by FTIR. The pre-treated samples of α-chitin were characterized by X-ray diffraction, DSC and SEM to investigate physical and chemical modification. The obtained results showed that γ irradiation and alkaline soaking time at low temperature are significant factors. The most influential factor was the temperature during the deacetylation process. The equation of the predictive mathematical model for the DD was obtained as follows: DD(%)=-80.4825+0.4984A[NaOH]+1.1355AT°+0.1505Atime-0.1808ADose+0.9845Asoaktime X-ray diffraction, DSC and SEM revealed that the pre-treatment of α-chitin affected greatly its crystallinity and led to chemical and physical modification of its structure. The pretreatment consisting of γ irradiation and soaking time at 4 °C in alkaline medium played a synergistic effect during the deacetylation process.

Development of alginate gel beads with a potential use in the treatment against acute lead poisoning.

The objective was to develop alginate beads that could adsorb lead ions in gastric pH, in view to preconize their use in gastric lavage following lead poisoning. The swelling measurements of both, dry and hydrated beads, were carried out in simulated gastric fluid (SGF). The sorption kinetics was examined at lead concentrations ranging from 50 to 200mg/l. Calcium released during the sorption process was investigated. The swelling rate of the dry beads increased considerably with time increase and reached the equilibrium at 736% after 240min; concerning the hydrated beads, the equilibrium swelling reached 139% after 180min. The adsorption of Pb (II) in SGF by dry beads increased with the increase of time and initial lead concentration. The adsorption kinetics of Pb ions by hydrated alginate beads indicated a rapid binding of Pb ions to the sorbent during the first 15min for all the concentrations, followed by a slow increase until the equilibrium was reached after 90min. The adsorption capacity of Pb ions increased with the increase of the storage time in water at 4°C and with the weight. The amount of Ca2+ released by the beads increased with the increase of Pb ions a rate.

Oral delivery of insulin from alginate/chitosan crosslinked by glutaraldehyde.

Insulin is mainly administered via subcutaneous route by injection which is the cause of painful and possible infections. Oral insulin administration would present a more convenient form of application because it is less invasive. Oral delivery of insulin to the gastrointestinal tract is one of the most challenging issues, because it numerous barriers to overcome in order to create an effective system for insulin delivery. In the present study, insulin-loaded alginate/chitosan blend gel beads were prepared with different mass ratios. Chitosan was depolymerized by gamma irradiation at a dose of 80 kGy reducing its molecular weight for ideal blend with sodium alginate. The homogeneous solution of alginate and chitosan was dripped into CaCl2 solution (2%), the resultant calcium crosslinked beads were dipped in glutaraldehyde (2%) solution sequentially to prepare dual crosslinked beads with improved mechanical properties so as to withstand the simulated gastric fluid (SGF) and simulated intestinal fluid (SIF). Morphological structure, FTIR analysis, thermogravimetry analysis, specific surface area, gel fraction, swelling kinetics in SGF and SIF, loading efficiency, insulin release behavior, mucoadhesivity of the alginate/chitosan beads were investigated. The cumulative insulin release of pure alginate beads (10:0) reached as maximum level 100% in 3h after they were dipped in SIF. Concerning the beads Alg/Chi (8:2), Alg/Chi (7:3) and Alg/Chi (6:4) the cumulative release of insulin reached 90.5%, 89.2% and 70.2%, respectively in 6h. The rate of 100% was reached after 24h for Alg/Chi (8:2), Alg/Chi (7:3) and after 73 h for Alg/Chi (6:4). The presence of chitosan in the blend beads decreased the cumulative insulin release in gastric media and enhanced behavior of alginate/chitosan beads in intestinal medium due to the crosslinking. The alginate/chitosan beads crosslinked by glutaraldehyde may be considered as potential insulin carriers for oral drug delivery system.

Evaluation of healing activity of PVA/chitosan hydrogels on deep second degree burn: pharmacological and toxicological tests.

Hydrogel based on poly(vinyl alcohol) containing 0.25% of chitosan was synthesized by gamma irradiation and evaluated as wound dressing material in a burn rat model. Histological analyses, Primary Irritation Index (P.I.I.) and Ocular Irritation Index (O.I.I.) were investigated. The comparative study showed that the wounds treated with PVA/chitosan hydrogel healed on the 9th day, while those treated with paraffin gauze dressing and cotton gauze healed on the 16th day. Histological analysis showed that new granulation tissue and epithelialization progressed better in wound treated with hydrogel PVA/chitosan. The determined values of P.I.I. and O.I.I. of the PVA/chitosan hydrogel were, respectively 0.5 and zero. These values indicate that the PVA/chitosan hydrogel can be considered as non-irritating to the skin.