RESUMO
The instability and expense of anodes for water electrolyzers with acidic electrolytes can be overcome through the implementation of a cobalt-iron-lead oxide electrocatalyst, [Co-Fe-Pb]Ox , that is self-healing in the presence of dissolved metal precursors. However, the latter requirement is pernicious for the membrane and especially the cathode half-reaction since Pb2+ and Fe3+ precursors poison the state-of-the-art platinum H2 evolving catalyst. To address this, we demonstrate the invariably stable operation of [Co-Fe-Pb]Ox in acidic solutions through a cobalt-selective self-healing mechanism without the addition of Pb2+ and Fe3+ and investigate the kinetics of the process. Soft X-ray absorption spectroscopy reveals that low concentrations of Co2+ in the solution stabilize the catalytically active Co(Fe) sites. The highly promising performance of this system is showcased by steady water electrooxidation at 80±1 °C and 10â mA cm-2 , using a flat electrode, at an overpotential of 0.56±0.01â V on a one-week timescale.
RESUMO
Manganese oxide (MnOx ) electrocatalysts are examined herein by inâ situ soft X-ray absorption spectroscopy (XAS) and resonant inelastic X-ray scattering (RIXS) during the oxidation of water buffered by borate (pHâ 9.2) at potentials from 0.75 to 2.25â V vs. the reversible hydrogen electrode. Correlation of L-edge XAS data with previous mechanistic studies indicates MnIV is the highest oxidation state involved in the catalytic mechanism. MnOx is transformed into birnessite at 1.45â V and does not undergo further structural phase changes. At potentials beyond this transformation, RIXS spectra show progressive enhancement of charge transfer transitions from oxygen to manganese. Theoretical analysis of these data indicates increased hybridization of the Mn-O orbitals and withdrawal of electron density from the O ligand shell. Inâ situ XAS experiments at the O K-edge provide complementary evidence for such a transition. This step is crucial for the formation of O2 from water.
RESUMO
Soft X-ray emission (XE), absorption (XA), and resonant inelastic scattering (RIXS) experiments have been conducted at the nitrogen K-edge of urea and its derivatives in aqueous solution and were compared with density functional theory and time-dependent density functional theory calculations. This comprehensive study provides detailed information on the occupied and unoccupied molecular orbitals of urea, thiourea, acetamide, dimethylurea, and biuret at valence levels. By identifying the electronic transitions that contribute to the experimental spectral features, the energy gap between the highest occupied and the lowest unoccupied molecular orbital of each molecule is determined. Moreover, a theoretical approach is introduced to simulate resonant inelastic X-ray scattering spectra by adding an extra electron to the lowest unoccupied molecular orbital, thereby mimicking the real initial state of the core-electron absorption before the subsequent relaxation process.
RESUMO
MnOx films electrodeposited under basic, neutral, and acidic conditions from an ionic liquid were investigated by means of X-ray absorption spectroscopy at the manganese L2,3 -edges and the oxygen K-edge. Such films can serve as catalysts for the water oxidation reaction. Previous studies showed that the catalytic activity could be controlled by varying the deposition parameters, which influence the formation of MnOx phases and the film composition. Herein the film compositions are investigated in detail, indicating different ratios of MnOx structural phases in the films. All films in the series predominately consist of varying proportions of three MnOx phases-Mn2 O3 , Mn3 O4 , and birnessite, while an increase of the average Mn oxidation state in the film is identified when going from basic to acidic conditions during electrodeposition. The contribution of these three phases shows a systematic dependency on the pH during electrodeposition. While no specific single MnOx phase was found to dominate the composition of samples that were previously found to show high catalytic activity, the X-ray spectroscopic results revealed the compositions of those samples prepared under close to neutral conditions to be most sensitive to changes in pH.
RESUMO
Detection of ionic current with two electrodes installed in a liquid cell has been established previously as an effective method, termed as total ion yield (TIY), to acquire X-ray absorption (XA) spectra of liquid solutions behind a membrane. In this study, the exact locations where TIY signals are generated are further investigated and unequivocally identified. The detected ionic current stems dominantly from the bulk solution species while only marginally from the species located at the membrane-solution interface. Such a two-electrode TIY detection in a liquid cell combines the advantages of bulk sensitivity of fluorescence yield and high signal strength (for light elements) of electron yield, exhibiting its novel and promising role in the XA spectroscopy measurements of liquid cells.
RESUMO
Photons and electrons are two common relaxation products upon X-ray absorption, enabling fluorescence yield and electron yield detections for X-ray absorption spectroscopy (XAS). The ions that are created during the electron yield process are relaxation products too, which are exploited in this study to produce ion yield for XA detection. The ionic currents measured in a liquid cell filled with water or iron(III) nitrate aqueous solutions exhibit characteristic O K-edge and Fe L-edge absorption profiles as a function of excitation energy. Application of two electrodes installed in the cell is crucial for obtaining the XA spectra of the liquids behind membranes. Using a single electrode can only probe the species adsorbed on the membrane surface. The ionic-current detection, termed as total ion yield (TIY) in this study, also produces an undistorted Fe L-edge XA spectrum, indicating its promising role as a novel detection method for XAS studies in liquid cells.