A novel device for the determination of liposome/water partition coefficients.

A novel, cheap and easy-to-construct device and a simple method for partition coefficient determination in liposome/water system based on modified equilibrium dialysis have been developed. The device consists of two vials separated by a semi-permeable membrane, through which the free form of a low molecular weight substance is transported by shaking assisted diffusion. Five test substances, eugenol, carvacrol, thymol, 4-hydroxybenzyl alcohol (4-HBA) and butylparaben were analyzed after equilibration in aqueous phase by three methods, HPLC-UV, GC-MS and DPV with comparable results. This shows the possibility of using the proposed method in any laboratory with any equipment capable of analyzing the substance under study. The liposome/water partition coefficients (log Pl/w) determined for eugenol (2.39), thymol (2.83), carvacrol (2.78) and butylparaben (3.30) are consistent with previously published data. A strong effect of NaCl on the liposome/water partition coefficient was observed. The value of log Pl/w = 1.06 determined for 4-HBA in the presence of 0.15 mol L-1 NaCl in the partitioning liposomal system was considerably lower than in the absence of the salt (log Pl/w = 2.06). The developed method was used to determine the partition coefficient of morphine in liposome/water system without NaCl (log Pl/w = 2.65) under given conditions.

Carbon fiber brush electrode as a novel substrate for atmospheric solids analysis probe (ASAP) mass spectrometry: Electrochemical oxidation of brominated phenols.

A carbon fiber brush electrode (CFBE) was newly designed and used as a substrate for both controlled potential electrolysis and atmospheric solids analysis probe (ASAP) mass spectrometry. Electropolymerized and strongly adsorbed products of electrolysis were directly desorbed and ionized from the electrode surface. Electrochemical properties of the electrode investigated by cyclic voltammetry revealed large electroactive surface area (23 ± 3 cm2) at 1.3 cm long array of carbon fibers with diameter 6-9 µm. Some products of electrochemical oxidation of pentabromophenol and 2,4,6-tribromophenol formed a compact layer on the carbon fibers and were analyzed using ASAP. Eleven new oligomeric products were identified including quinones and biphenoquinones. These compounds were not observed previously in electrolyzed solutions by liquid or gas chromatography/mass spectrometry. The thickness around 58 nm and 45 nm of the oxidation products layers deposited on carbon fibers during electrolysis of pentabromophenol and 2,4,6-tribromophenol, respectively, was estimated from atomic force microscopy analysis and confirmed by scanning electron microscopy with energy-dispersive X-ray spectroscopy measurements.