RESUMO
Bioactive coatings are frequently used to improve the osseointegration of the metallic implants used in dentistry or orthopaedics. Among different types of bioactive coatings, hydroxyapatite (Ca10(PO4)6(OH)2) is one of the most extensively used due to its chemical similarities to the components of bones and teeth. In this article, production and characterization of hydroxyapatite films deposited on Ti6Al4V alloy prepared by magnetron sputtering were reported. Besides, SiC was deposited on substrate surface to study the interlayer effect. Obtained coatings were annealed at 600 °C for 30 and 120 min in a mixed atmosphere of N2 + H2O vapours with the heating rate of 12 °C min(-1). The effects of SiC interlayer and heat treatment parameters on the structural, mechanical and corrosion properties were investigated. After heat treatment process, the crystalline hydroxyapatite was obtained. Additionally, cell viability tests were performed. The results show that the presence of the SiC interlayer contributes a decrease in surface roughness and improves the mechanical properties and corrosion performance of the hydroxyapatite coatings. Biological properties were not affected by the presence of the SiC interlayer.
Assuntos
Materiais Biocompatíveis/química , Compostos Inorgânicos de Carbono/química , Durapatita/química , Compostos de Silício/química , Titânio/química , Ligas , Materiais Biocompatíveis/toxicidade , Compostos Inorgânicos de Carbono/toxicidade , Linhagem Celular Tumoral , Sobrevivência Celular/efeitos dos fármacos , Durapatita/toxicidade , Humanos , Compostos de Silício/toxicidade , Propriedades de Superfície , Titânio/toxicidadeRESUMO
This study investigated the designs of osseointegrated prostheses in cases of free-end partial edentulism using comparative stress interpreted with the three-dimensional finite element method. Three free-end fixed osseointegrated prostheses models with various connection designs (i.e., rigidly connected to an abutment tooth and an implant, rigidly connected to an implant and two abutment teeth, and rigidly connected to an implant and three abutment teeth) were studied. The stress values of the three models loaded with vertical, buccolingual, and linguobuccal directions at 30 degrees angled to vertical axis forces were analyzed. When the fixed partial denture was connected to the three natural abutment teeth and an implant, the lowest levels of stress in the bone were noted.