In vitro bioaccessibility round robin testing for arsenic and lead in standard reference materials and soil samples.

In this study, we assessed the suitability of using a standard reference material (SRM) other than National Institute of Standards and Technology (NIST) 2710a or NIST 2711a in USEPA Method 1340 to determine arsenic (As) and lead (Pb) in vitro bioaccessibility (IVBA) and the capabilities of Canadian-based laboratories to perform the method. Five laboratories participated in an initial round robin study and analyzed NIST 2710a, NIST 2711a, BGS119, and Enviromat SS-2. Intra- and inter-laboratory variability were generally acceptable with percentage relative standard deviations (RSD) of less than 20%. The mean total As and Pb concentrations obtained for BGS119 (332 and 936 mg/kg, respectively) and the mean IVBA values (As = 14.3% and Pb = 78.1%) suggested it may be a suitable and acceptable SRM, whereas the concentration of As in Enviromat SS-2 as received (3.2 mg/kg) was deemed too low. Ten soil samples from sites with varying land use were analyzed in a follow-up round robin study using the modified IVBA method that included BGS119 as SRM. The concentrations of As and Pb in the IVBA extracts reported by the participating laboratories were comparable. The mean As IVBA values for the field-collected samples ranged from 0.1% to 56.4%; for Pb, they ranged from 7.0% to 121%. The lowest IVBA values were measured in mine site samples; the highest values were associated with smelter-affected soils. The low IVBA values correlated with high iron content. Intra- and interlaboratory reproducibility were acceptable (RSD < 30%). Based on the findings of the study, laboratories can use the modified method to provide reproducible and comparable As and Pb IVBA data. The use of BGS119 as an alternative SRM to assess contaminated sites in the province of British Columbia for regulatory purposes is recommended, as it is representative of As and Pb concentrations in contaminated soils in British Columbia. Integr Environ Assess Manag 2024;00:1-10. © 2024 The Authors. Integrated Environmental Assessment and Management published by Wiley Periodicals LLC on behalf of Society of Environmental Toxicology & Chemistry (SETAC).

Development of a methodology utilizing gas chromatography ion-trap tandem mass spectrometry for the determination of low levels of caffeine in surface marine and freshwater samples.

A methodology for monitoring low level of caffeine in aqueous samples via gas chromatography coupled with an ion-trap tandem mass spectrometry detection system (IT-MS/MS) was developed. Four IT-MS/MS operating parameters, including the collision-induced dissociation (CID) voltage, the excitation time (ET), the isolation time (IT) and the maximum ionization time (MIT) were optimized in order to maximize the sensitivity of the IT-MS/MS technique towards the analyte and its isotope-labeled standard. After optimization, a limit of detection of 500 fg microl(-1) with S/N = 3 was achieved. Taking into account blank values and the matrix background, a method detection limit of 1.0-2.0 ng l(-1) was derived and applied to all of the samples analyzed in the study. Various mass spectrometric conditions have been applied to caffeine and its trimethyl-(13)C-labeled standard to elucidate fragmentation pathways for new and commonly occurring product ions observed in the collision-induced dissociation (CID) spectra produced by the ion trap. Ion structures and fragmentation pathway mechanisms have been proposed and compared with previously published data. An isotope dilution method using (13)C-labeled caffeine as a surrogate internal standard was employed to determine and correct the recovery of native caffeine in water samples. The developed methodology has been applied for the determination of caffeine in surface marine and freshwater samples collected on the west coast of Vancouver Island in British Columbia, Canada. The results obtained for the marine water samples indicated a wide variation in the level of caffeine, ranging from 4.5 to 149 ng l(-1), depending on the location of the sampling site within the inlet. The concentrations of caffeine in samples from lakes associated with various residential densities ranged from ND to 6.5, 1.8 to 10.4 and 6.1 to 21.7 ng l(-1) for low, moderate and high residential densities, respectively.

Ion-trap tandem mass spectrometry-based analytical methodology for the determination of polychlorinated biphenyls in fish and shellfish. Performance comparison against electron-capture detection and high-resolution mass spectrometry detection.

Optimization of the Varian Saturn 2200 ion-trap tandem mass spectrometry (IT-MS/MS) system and comparison of its data quality with two other detection methods [electron-capture detection (ECD) and high-resolution mass spectrometry (HRMS)] was pursued by measuring polychlorinated biphenyls (PCBs) levels in fish and shellfish samples. IT-MS/MS methodology provided limits of detection (LOD) comparable to those obtained by ECD but superior specificity for the detection of a selected number of 39 PCB native congeners and 9 (13)C-labelled PCB standards. The method detection limits (MDLs) established for IT-MS/MS ranged between 1.0 and 5.0 pg/g on a wet weight basis while those obtained by ECD and HRMS were 1.0-4.0 pg/g and 0.1-2.0 pg/g, respectively. Overall, the results obtained in the study demonstrate that gas chromatography (GC) combined with IT-MS/MS provide higher data quality than those achievable by GC-ECD. For this particular set of target analytes the specificity achievable with IT-MS/MS was comparable to that obtained by HRMS and both techniques provided comparable data in terms of accuracy and precision.

Determination of acidic drugs and caffeine in municipal wastewaters and receiving waters by gas chromatography-ion trap tandem mass spectrometry.

Some aspects of both sample preparation and instrumental techniques for analysis of such acidic drugs as acetylsalicylic acid, ibuprofen, gemfibrozil, fenoprofen, naproxen, ketoprofen, and diclofenac, as well as caffeine in surface water and municipal wastewater have been studied and further developed. Water samples were filtered and target analytes were extracted by solid-phase extraction (SPE). Supelco LC-18 and Oasis HLB SPE cartridges were used to pre-concentrate samples for acidic drugs and caffeine, respectively. A methylation process was applied to acidic drugs prior to analysis while caffeine was analyzed directly. A method of gas chromatography-ion trap tandem mass spectrometry (IT-MS/MS) for analysis of the target acidic pharmaceuticals and caffeine is presented here in detail. Such parameters as collision-induced dissociation (CID) voltage, isolation time, excitation time, excitation storage level, and electron energy were adjusted in order to optimize the instrument analytical performance. After optimization, an instrument detection limit of 0.5-20 pg/microL with signal-to-noise (S/N) not less than 5 was achieved for all target analytes. It was shown that this method has good linearity within the range of 10-2000 pg/microL. The application of the optimized IT-MS/MS parameters conjointly with the sample preparation procedure resulted in method detection limits (MDLs) of 0.1-1.0 and 20 ng/L for the determination of acidic drugs and caffeine, respectively in such samples as surface water, effluent from municipal wastewater plants, as well as receiving waters.

Isotopic characterization as a screening tool in authentication of organic produce commercially available in western North America.

The use of nitrogen stable isotopes to discriminate between conventionally and organically grown crops has been further developed in this study. Soil and irrigation water from different regions, as well as nitrogen fertilizers used, have been examined in detail to determine their effects on nitrogen isotope composition of spinach, lettuce, broccoli and tomatoes. Over 1000 samples of various types of organically and conventionally grown produce of known origin, along with the samples of nitrogen fertilizers used for their growth, have been analysed in order to assemble the datasets of crop/fertilizer correlations. The results demonstrate that the developed approach can be used as a valuable component in the verification of agricultural practices for more than 25 different types of commercially grown green produce, either organic or conventional. Over a period of two years, various organic and non-organic greens, from different stores in Seattle (WA, USA) and Victoria (BC, Canada), were collected and analysed using this methodology with the objective of determining any pattern of misrepresentation.

Carbon and nitrogen isotopic signatures and nitrogen profile to identify adulteration in organic fertilizers.

Recently it has been shown that stable isotopes of nitrogen can be used to discriminate between organic and synthetic fertilizers, but the robustness of the approach is questionable. This work developed a comprehensive method that is far more robust in identifying an adulteration of organic nitrogen fertilizers. Organic fertilizers of various types (manures, composts, blood meal, bone meal, fish meal, products of poultry and plant productions, molasses and seaweed based, and others) available on the North American market were analyzed to reveal the most sensitive criteria as well as their quantitative ranges, which can be used in their authentication. Organic nitrogen fertilizers of known origins with a wide δ(15)N range between -0.55 and 28.85‰ (n = 1258) were characterized for C and N content, δ(13)C, δ(15)N, viscosity, pH, and nitrogen profile (urea, ammonia, organic N, water insoluble N, and NO3). A statistically significant data set of characterized unique organic nitrogen fertilizers (n = 335) of various known origins has been assembled. Deliberately adulterated samples of different types of organic fertilizers mixed with synthetic fertilizers at a wide range of proportions have been used to develop the quantitative critical characteristics of organic fertilizers as the key indicators of their adulteration. Statistical analysis based on the discriminant functions of the quantitative critical characteristics of organic nitrogen fertilizers from 14 different source materials revealed a very high average rate of correct classification. The developed methodology has been successfully used as a source identification tool for numerous commercial nitrogen fertilizers available on the North American market.

Ecosystemic effects of salmon farming increase mercury contamination in wild fish.

Net-pen salmon aquaculture has well-known effects on coastal ecosystems: farm waste increases sediment organic content and the incidence of sediment anoxia, supports increased production of deposit-feeding invertebrates, and attracts higher densities of demersal fish and other mobile carnivores. These impacts are widely considered to be localized and transitory, and are commonly managed by imposing a period of fallowing between cycles of production. The implications of these ecosystemic effects for contaminant cycling, however, have not previously been considered. We found elevated levels of mercury in demersal rockfishes near salmon farms in coastal British Columbia, Canada, attributable to a combination of higher rockfish trophic position and higher mercury levels in prey near farms. Mercury concentrations in long-lived species such as rockfishes change over a longer time scale than cycles of production and fallowing, and thus at least some important effects of fish farms may not be considered transitory.