Energy-Degeneracy-Driven Covalency in Actinide Bonding.

Evaluating the nature of chemical bonding for actinide elements represents one of the most important and long-standing problems in actinide science. We directly address this challenge and contribute a Cl K-edge X-ray absorption spectroscopy and relativistic density functional theory study that quantitatively evaluates An-Cl covalency in AnCl62- (AnIV = Th, U, Np, Pu). The results showed significant mixing between Cl 3p- and AnIV 5f- and 6d-orbitals (t1u*/t2u* and t2 g*/eg *), with the 6d-orbitals showing more pronounced covalent bonding than the 5f-orbitals. Moving from Th to U, Np, and Pu markedly changed the amount of M-Cl orbital mixing, such that AnIV 6d - and Cl 3p-mixing decreased and metal 5f - and Cl 3p-orbital mixing increased across this series.

Measurement of the 240Pu/239Pu mass ratio using a transition-edge-sensor microcalorimeter for total decay energy spectroscopy.

We have developed a new category of sensor for measurement of the (240)Pu/(239)Pu mass ratio from aqueous solution samples with advantages over existing methods. Aqueous solution plutonium samples were evaporated and encapsulated inside of a gold foil absorber, and a superconducting transition-edge-sensor microcalorimeter detector was used to measure the total reaction energy (Q-value) of nuclear decays via heat generated when the energy is thermalized. Since all of the decay energy is contained in the absorber, we measure a single spectral peak for each isotope, resulting in a simple spectral analysis problem with minimal peak overlap. We found that mechanical kneading of the absorber dramatically improves spectral quality by reducing the size of radioactive inclusions within the absorber to scales below 50 nm such that decay products primarily interact with atoms of the host material. Due to the low noise performance of the microcalorimeter detector, energy resolution values of 1 keV fwhm (full width at half-maximum) at 5.5 MeV have been achieved, an order of magnitude improvement over α-spectroscopy with conventional silicon detectors. We measured the (240)Pu/(239)Pu mass ratio of two samples and confirmed the results by comparison to mass spectrometry values. These results have implications for future measurements of trace samples of nuclear material.

Determining relative f and d orbital contributions to M-Cl covalency in MCl6(2-) (M = Ti, Zr, Hf, U) and UOCl5(-) using Cl K-edge X-ray absorption spectroscopy and time-dependent density functional theory.

Chlorine K-edge X-ray absorption spectroscopy (XAS) and ground-state and time-dependent hybrid density functional theory (DFT) were used to probe the electronic structures of O(h)-MCl(6)(2-) (M = Ti, Zr, Hf, U) and C(4v)-UOCl(5)(-), and to determine the relative contributions of valence 3d, 4d, 5d, 6d, and 5f orbitals in M-Cl bonding. Spectral interpretations were guided by time-dependent DFT calculated transition energies and oscillator strengths, which agree well with the experimental XAS spectra. The data provide new spectroscopic evidence for the involvement of both 5f and 6d orbitals in actinide-ligand bonding in UCl(6)(2-). For the MCl(6)(2-), where transitions into d orbitals of t(2g) symmetry are spectroscopically resolved for all four complexes, the experimentally determined Cl 3p character per M-Cl bond increases from 8.3(4)% (TiCl(6)(2-)) to 10.3(5)% (ZrCl(6)(2-)), 12(1)% (HfCl(6)(2-)), and 18(1)% (UCl(6)(2-)). Chlorine K-edge XAS spectra of UOCl(5)(-) provide additional insights into the transition assignments by lowering the symmetry to C(4v), where five pre-edge transitions into both 5f and 6d orbitals are observed. For UCl(6)(2-), the XAS data suggest that orbital mixing associated with the U 5f orbitals is considerably lower than that of the U 6d orbitals. For both UCl(6)(2-) and UOCl(5)(-), the ground-state DFT calculations predict a larger 5f contribution to bonding than is determined experimentally. These findings are discussed in the context of conventional theories of covalent bonding for d- and f-block metal complexes.

Experimental and theoretical comparison of the O K-edge nonresonant inelastic X-ray scattering and X-ray absorption spectra of NaReO4.

Accurate X-ray absorption spectra (XAS) of first row atoms, e.g., O, are notoriously difficult to obtain due to the extreme sensitivity of the measurement to surface contamination, self-absorption, and saturation affects. Herein, we describe a comprehensive approach for determining reliable O K-edge XAS data for ReO(4)(1-) and provide methodology for obtaining trustworthy and quantitative data on nonconducting molecular systems, even in the presence of surface contamination. This involves comparing spectra measured by nonresonant inelastic X-ray scattering (NRIXS), a bulk-sensitive technique that is not prone to X-ray self-absorption and provides exact peak intensities, with XAS spectra obtained by three different detection modes, namely total electron yield (TEY), fluorescence yield (FY), and scanning transmission X-ray microscopy (STXM). For ReO(4)(1-), TEY measurements were heavily influenced by surface contamination, while the FY and STXM data agree well with the bulk NRIXS analysis. These spectra all showed two intense pre-edge features indicative of the covalent interaction between the Re 5d and O 2p orbitals. Density functional theory calculations were used to assign these two peaks as O 1s excitations to the e and t(2) molecular orbitals that result from Re 5d and O 2p covalent mixing in T(d) symmetry. Electronic structure calculations were used to determine the amount of O 2p character (%) in these molecular orbitals. Time dependent-density functional theory (TD-DFT) was also used to calculate the energies and intensities of the pre-edge transitions. Overall, under these experimental conditions, this analysis suggests that NRIXS, STXM, and FY operate cooperatively, providing a sound basis for validation of bulk-like excitation spectra and, in combination with electronic structure calculations, suggest that NaReO(4) may serve as a well-defined O K-edge energy and intensity standard for future O K-edge XAS studies.

Trends in covalency for d- and f-element metallocene dichlorides identified using chlorine K-edge X-ray absorption spectroscopy and time-dependent density functional theory.

We describe the use of Cl K-edge X-ray absorption spectroscopy (XAS) and both ground-state and time-dependent hybrid density functional theory (DFT) to probe the electronic structure and determine the degree of orbital mixing in M-Cl bonds for (C(5)Me(5))(2)MCl(2) (M = Ti, 1; Zr, 2; Hf, 3; Th, 4; U, 5), where we can directly compare a class of structurally similar compounds for d- and f-elements. Pre-edge features in the Cl K-edge XAS data for the group IV transition-metals 1-3 provide direct evidence of covalent M-Cl orbital mixing. The amount of Cl 3p character was experimentally determined to be 25%, 23%, and 22% per M-Cl bond for 1-3, respectively. For actinides, we find a pre-edge shoulder for 4 (Th) and distinct and weak pre-edge features for U, 5. The amount of Cl 3p character was determined to be 9% for 5, and we were unable to make an experimental determination for 4. Using hybrid DFT calculations with relativistic effective core potentials, the electronic structures of 1-5 were calculated and used as a guide to interpret the experimental Cl K-edge XAS data. For transition-metal compounds 1-3, the pre-edge features arise due to transitions from Cl 1s electrons into the 3d-, 4d-, and 5d-orbitals, with assignments provided in the text. For Th, 4, we find that 5f- and 6d-orbitals are nearly degenerate and give rise to a single pre-edge shoulder in the XAS. For U, 5, we find the 5f- and 6d-orbitals fall into two distinct energy groupings, and Cl K-edge XAS data are interpreted in terms of Cl 1s transitions into both 5f- and 6d-orbitals. Time-dependent DFT was used to calculate the energies and intensities of Cl 1s transitions into empty metal-based orbitals containing Cl 3p character and provide simulated Cl K-edge XAS spectra for 1-4. For 5, which has two unpaired 5f electrons, simulated spectra were obtained from transition dipole calculations using ground-state Kohn-Sham orbitals. To the best of our knowledge, this represents the first application of Cl K-edge XAS to actinide systems. Overall, this study allows trends in orbital mixing within a well-characterized structural motif to be identified and compared between transition-metals and actinide elements. These results show that the orbital mixing for the d-block compounds slightly decreases in covalency with increasing principal quantum number, in the order Ti > Zr approximately = Hf, and that uranium displays approximately half the covalent orbital mixing of transition elements.

Variations of bromide in potable ground water in the United States.

Concentrations of bromide in potable ground water that has <10 mg/L chloride range from 0.0032 to 0.058 mg/L with a median value of 0.016 mg/L. The chloride/bromide mass ratio for the same water ranges from 43 to 285 with a median value of 101. The ratios, which resulted from screening approximately 165 analyses of water from 32 locations in 24 states in the United States, show a distinct geographic variation with highest values near the coast and trending toward a value of approximately 50 in the continental interior.

Covalency trends in group IV metallocene dichlorides. chlorine K-edge X-ray absorption spectroscopy and time dependent-density functional theory.

For 3-5d transition-metal ions, the (C5R5)2MCl2 (R = H, Me for M = Ti, Zr, Hf) bent metallocenes represent a series of compounds that have been central in the development of organometallic chemistry and homogeneous catalysis. Here, we evaluate how changes in the principal quantum number for the group IV (C5H5)2MCl2 (M = Ti, Zr, Hf; 1- 3, respectively) complexes affects the covalency of M-Cl bonds through application of Cl K-edge X-ray Absorption Spectroscopy (XAS). Spectra were recorded on solid samples dispersed as a thin film and encapsulated in polystyrene matrices to reliably minimize problems associated with X-ray self-absorption. The data show that XAS pre-edge intensities can be quantitatively reproduced when analytes are encapsulated in polystyrene. Cl K-edge XAS data show that covalency in M-Cl bonding changes in the order Ti > Zr > Hf and demonstrates that covalency slightly decreases with increasing principal quantum number in 1-3. The percent Cl 3p character was experimentally determined to be 26, 23, and 18% per M-Cl bond in the thin-film samples for 1-3 respectively and was indistinguishable from the polystyrene samples, which analyzed as 25, 25, and 19% for 1-3, respectively. To aid in interpretation of Cl K-edge XAS, 1-3 were also analyzed by ground-state and time-dependent density functional theory (TD-DFT) calculations. The calculated spectra and percent chlorine character are in close agreement with the experimental observations, and show 20, 18, and 17% Cl 3p character per M-Cl bond for 1-3, respectively. Polystyrene matrix encapsulation affords a convenient method to safely contain radioactive samples to extend our studies to include actinide elements, where both 5f and 6d orbitals are expected to play a role in M-Cl bonding and where transition assignments must rely on accurate theoretical calculations.