RESUMO
OBJECTIVES: To investigate bioavailability enhancement of zinc on model oral surfaces and in oral biofilms in vitro through strategic formulation with two sources of zinc and L-arginine. METHODS: To modulate the bioavailability of active zinc ions in a zinc citrate dentifrice, an additive research strategy was pursued. A series of zinc citrate dentifrice formulations were prepared with increasing replacement of zinc citrate with zinc oxide (a water insoluble source of zinc ions) to generate a Dual Zinc active system. A screening of isolated zinc and amino acid effects in simple solutions using zeta potential and uptake to model oral surfaces was performed in an effort to determine the effect of particle charge on zinc bioavailability. Zinc delivery and antibacterial efficacy of the Dual Zinc plus Arginine dentifrice formula were tested using in vitro oral epithelial tissue and saliva-derived biofilm models. Furthermore, zinc penetration and retention were determined by subjecting in vitro biofilms to dynamic flow after treatment with the Dual Zinc plus Arginine dentifrice with treated biofilms evaluated for zinc using imaging mass spectrometry (I-MS). Bacterial adhesion to gingival epithelial cells treated with the Dual Zinc plus Arginine dentifrice was imaged upon challenging with Streptococcus gordonii. RESULTS: Addition of zinc oxide into a zinc citrate dentifrice formula enhanced the efficacy of the system against anaerobic biofilms in a concentration- dependent manner. L-arginine further provided a significant positive charge (+36 mV) to the zinc oxide suspension (+16 mV) as measured by zeta potential. Simple solutions of the Dual Zinc active showed increased zinc uptake on model oral surfaces as a direct function of L-arginine concentration. Antibacterial efficacy of a Dual Zinc plus Arginine dentifrice was evaluated through multiple mechanisms. Enhanced antibacterial performance was observed through significant reductions in metabolic activity as measured through bacterial glycolytic function (p = 0.0001) and total oxygen consumption (p = 0.0001). Greater penetration and retention of zinc was observed in bacterial biofilms treated with the Dual Zinc plus Arginine dentifrice in comparison to treatment with a Dual Zinc dentifrice after twelve hours of dynamic flow (10 mL/hour) in an in vitro drip flow biofilm culture. Confocal microscopy showed adherent bacteria on cheek cells treated with the Dual Zinc plus Arginine dentifrice formula. CONCLUSIONS: The combination of zinc citrate, zinc oxide, and the amino acid L-arginine in a dentifrice formula enhances the bioavailability of zinc to model oral tissue surfaces, resulting in unique physicochemical effects. The significant antimicrobial control associated with the Dual Zinc plus Arginine dentifrice provides a unique vehicle toward achieving whole mouth health.
Assuntos
Placa Dentária , Dentifrícios , Zinco , Arginina , Disponibilidade Biológica , Placa Dentária/prevenção & controle , Dentifrícios/farmacocinética , Humanos , Zinco/farmacocinéticaRESUMO
OBJECTIVES: The aim for this pilot study was to investigate the effect of a sodium fluoride varnish on step height measured by a profilometer from human enamel worn by healthy volunteers with a novel in situ/ex vivo erosion design. METHOD: Healthy volunteers aged 18-70 years wore a palatal splint containing 8 human enamel samples and underwent two 3-day treatment periods for 6 h a day with a varnish containing sodium fluoride at 22,600 ppm and the control with the same ingredients but without fluoride. Each splint contained 4 polished and 4 unpolished samples. The interventions were applied to the surface of the enamel samples in randomised order, removed after 6 h, then immersed ex-vivo in 1 %, pH 2.7 citric acid for 2 min, repeated 4 times a day, over 2 days. Measurements of enamel were assessed blindly by microhardness on day 2 and by non-contact laser profilometry on day 3 for the two treatments. RESULTS: 24 volunteers, 2 males and 22 females aged 27-54 years, were screened and recruited. The delta microhardness, from polished samples removed at the end of day 2, for the control and fluoride treatment was 95.7 (22.9) kgf/mm2 and 123.7 (28.9) kgf/mm2, respectively (p < .005). The mean (SD) step height for the control polished enamel surfaces was 3.67 (2.07) µm and for the fluoride varnish was 1.79 (1.01) µm (p < .0005). The control unpolished enamel surfaces had a mean 2.09 (1.53) µm and the fluoride varnish was 2.11 (1.53) µm but no statistical difference was detected. CONCLUSIONS: The results from this pilot study, utilizing an in-situ model where enamel was exposed to acid over the course of 2 days, demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm prevented erosive wear compared to a control on the polished enamel surfaces. CLINICAL SIGNIFICANCE: Intra-oral study demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm reduced erosive tooth wear.
Assuntos
Erosão Dentária , Desgaste dos Dentes , Masculino , Feminino , Humanos , Fluoretos/uso terapêutico , Fluoreto de Sódio/farmacologia , Fluoreto de Sódio/uso terapêutico , Fluoretos Tópicos/farmacologia , Fluoretos Tópicos/uso terapêutico , Projetos Piloto , Erosão Dentária/prevenção & controle , Erosão Dentária/tratamento farmacológicoRESUMO
The synthesis of 4'-hydroxy-4-biphenylpropionic, 3',4'-dihydroxy-4-biphenylpropionic, 3',5'-dihydroxy-4-biphenylpropionic, and 3',4',5'-trihydroxy-4-biphenylpropionic methyl esters via three efficient and modular strategies including one based on Ni-catalyzed borylation and sequential cross-coupling is reported. These building blocks were employed in a convergent iterative approach to the synthesis of one library of 3,4,5-trisubstituted and two libraries of constitutional isomeric 3,4- and 3,5-disubstituted biphenylpropyl ether dendrons. Structural and retrostructural analysis of supramolecular dendrimers revealed that biphenylpropyl ether dendrons self-assemble and self-organize into the same periodic lattices and quasi-periodic arrays observed in previously reported libraries, but with larger dimensions, different mechanisms of self-assembly, and improved solubility, thermal, acidic, and oxidative stability. The different mechanisms of self-assembly led to the discovery of two new supramolecular structures. The first represents a new banana-like lamellar crystal with a four layer repeat. The second is a giant vesicular sphere self-assembled from 770 dendrons that exhibits an ultrahigh molar mass of 1.73 x 10(6) g/mol. Thus, the enhanced size of the self-assembled structures constructed from biphenylpropyl ether dendrons permitted for the first time discrimination of various molecular mechanisms of spherical self-assembly and elaborated a continuum between small filled spheres and very large hollow spheres that is dictated by the primary structure of the dendron. The comparative analysis of libraries of biphenylpropyl ether dendrons with the previously reported libraries of benzyl-, phenylpropyl-, and biphenyl-4-methyl ether dendrons demonstrated biomimetic self-assembly wherein the primary structure of the dendron and to a lesser extent the structure of its repeat unit determines the supramolecular tertiary structure. A "nanoperiodic table" of self-assembling dendrons and supramolecular dendrimers that allows the prediction of the general features of tertiary structures from primary structures was elaborated.
Assuntos
Dendrímeros/química , Estrutura Molecular , Peso MolecularRESUMO
The design and synthesis of the first examples of AB4 and AB5 dendritic building blocks with complex architecture are reported. Structural and retrostructural analysis of supramolecular dendrimers self-assembled from hybrid dendrons based on different combinations of AB4 and AB5 building blocks with AB2 and AB3 benzyl ether dendrons demonstrated that none of these new hybrid dendrons exhibit the previously encountered conformations of libraries of benzyl ether dendrons. These hybrid dendrons enabled the discovery of some highly unusual tapered and conical dendrons generated by the intramolecular back-folding of their repeat units and of their apex. The new back-folded tapered dendrons have double thickness and self-assemble into pine-tree-like columns exhibiting a long-range 7/2 helical order. The back-folded conical dendrons self-assemble into spherical dendrimers. Non-back-folded truncated conical dendrons were also discovered. They self-assemble into spherical dendrimers with a less densely packed center. The discovery of dendrons displaying a novel crown-like conformation is also reported. Crown-like dendrons self-assemble into long-range 5/1 helical pyramidal columns. The long-range 7/2 and 5/1 helical structures were established by applying, for the first time, the helical diffraction theory to the analysis of X-ray patterns obtained from oriented fibers of supramolecular dendrimers.