Modulation for efficiency and spectra of non-doped white organic light emitting diodes by combining an exciplex with an ultrathin phosphorescent emitter.

Herein, structured non-doped white organic light-emitting diodes (WOLEDs) were designed by combining the emission of a blue exciplex and orange-red phosphorescent ultrathin layer. The device efficiency and spectra were modulated successfully by adjusting the thickness of the exciplex layer and ultrathin layer, respectively. Meanwhile, high efficiency with external quantum efficiency (EQE) ranging from 15% to 22%, power efficiency from 33 lm W-1 to 47 lm W-1 and warm white emission with correlated color temperature (CCT) from 1600 K to 2600 K were realized. The energy transfer process and emission mechanism is also discussed, and the results reveal that the efficient charge trapping and recombination contribute to the improvement of device efficiency and reduce the roll-off efficiency.

Friction and adhesion between C60 single crystal surfaces and AFM tips: effects of the orientational phase transition.

We have investigated the nanotribological properties of C60 single crystal (111) and (100) surfaces around its orientational order-disorder phase transition temperature, approximately 260 K, by atomic force microscopy and frictional force microscopy (AFM/FFM) in high vacuum. Results show that for both surfaces across the phase transition temperature, the friction force and the adhesive force between a C60 coated AFM tip and the C60 crystal surfaces exhibit discontinuous behavior. The friction force within the applied external load range in the low temperature phase is significantly larger than that in the high temperature phase, with no obvious change in the slope of the friction force curves (the friction coefficient) in the low and high temperature phases. The abrupt change in friction was found to be caused mainly by the abrupt change in adhesion, which, in turn, can be qualitatively understood through changes in the van der Waals interaction and the short-range Coulomb interaction associated with the structural changes across the phase transition. Compared to most other degrees of freedom, the rotation of C60 molecules was found to have little effect on friction and is an ineffective energy dissipation channel.

Enhanced Self-Organized Dewetting of Ultrathin Polymer Blend Film for Large-Area Fabrication of SERS Substrate.

We study the enhanced dewetting of ultrathin Polystyrene (PS)/Poly (methyl methacrylate) (PMMA) blend films in a mixed solution, and reveal the dewetting can act as a simple and effective method to fabricate large-area surface-enhanced Raman scattering (SERS) substrate. A bilayer structure consisting of under PMMA layer and upper PS layer forms due to vertical phase separation of immiscible PS/PMMA during the spin-coating process. The thicker layer of the bilayer structure dominates the dewetting structures of PS/PMMA blend films. The diameter and diameter distribution of droplets, and the average separation spacing between the droplets can be precisely controlled via the change of blend ratio and film thickness. The dewetting structure of 8 nm PS/PMMA (1:1 wt%) blend film is proved to successfully fabricate large-area (3.5 cm × 3.5 cm) universal SERS substrate via deposited a silver layer on the dewetting structure. The SERS substrate shows good SERS-signal reproducibility (RSD < 7.2%) and high enhancement factor (2.5 × 107). The enhanced dewetting of polymer blend films broadens the application of dewetting of polymer films, especially in the nanotechnology, and may open a new approach for the fabrication of large-area SERS substrate to promote the application of SERS substrate in the rapid sensitive detection of trace molecules.

A model calculation of the tip field distribution for a carbon nanotube array and the optimum intertube distance.

In a previous paper, the model of a floating top segment was proposed and used successfully to calculate the field enhancement factor as well as the field distribution on the top surface for a single carbon nanotube (CNT). In this paper, the model is extended to a CNT array. A set of modified linear charge equations has been derived for the CNT array using an approximation of multipole potential expansion. Fictitious charges inside a specific segment can be solved from these equations to calculate the field around the tips. Some numerical calculations of the field enhancement factor have been carried out, quantitatively accounting for the reduction of the factor with decreasing intertube distance. The relative field strength distribution on the top hemisphere of a CNT array is calculated too; it is observed to be close to that of a single CNT. Using the Fowler-Nordheim formula, the field emission intensity of a CNT array is maximized with varying intertube distance. The resulting optimum intertube distance to height ratio decreases gradually with increasing height to radius ratio, and is close to 2 only for height to radius ratio around 3 × 10(2).

Effect of C60 molecular rotation on nanotribology.

The effect of C60 molecular rotation on the nanotribological properties of C60 single crystal surfaces has been studied by atomic/frictional force microscopy. The orientational order-disorder phase transition, in which the high temperature C60 free rotation is reduced to a low temperature hindered rotation, is shown to give rise to an abrupt change in friction and adhesion. This change in frictional force is quantitatively consistent with the observed change in adhesion. The similar slopes of the friction versus load curves in both phases indicate that the friction coefficient in the two phases remains about the same. Hence the C60 rotation does not provide an additional energy dissipation channel in the friction process.