[Discussion of the Application and Influence Factors of Low-Background Gamma Spectrometry in Distinguishing Sedimentary Rock Types].

The contents of radionuclides uranium, thorium and potassium in the sedimentary rocks mainly depend on the contents of clay in the rocks. And the content of clay is the main basis for distinguishing types of sedimentary rock. Therefore, the value of specific activity or content of uranium, thorium and potassium can be as the quantitative index to distinguish sedimentary rock type. The specific activity or content of radionuclides uranium, thorium and potassium with the method of low-background gamma spectrometry can distinguish the type of rock quickly and accurately. Because of the influence of geometry, mass and moisture content in the sample, the accuracy of distinguishing types of rocks is influenced. This paper makes a theoretical discussion and experimental verification on the influence of mass and moisture content on the results of low-background gamma spectrometry. Results show that there is a linear relationship between (cps) of characteristic peak of all radionuclides and the mass of sample while different energy ranges and lithologies have different linear coefficient and trend fitting degree; The moisture content which is no more than 10%(while collecting samples, the moisture content is no more than 10%) has a little influence on the measurement results( the change values are within the twice standard deviation), so the moisture content which has no significant influence on the accuracy of distinguishing types of sedimentary rock using the method of low-background gamma spectrometry could not be considered. The distinguishing experiment of drilling cuttings samples collected from one oil and gas exploration area in Shanxi Dingbian is done. By the mass correction of the measured data, normalized (cps) ((cps) of per unit mass) of uranium, thorium and potassium channel can only roughly divide the types of sedimentary rocks. Therefore, synthetic distinguishing mode is established with (cps) of combination peak of characteristic peak of uranium, thorium and potassium. The type of rocks is further subdivided, and the distinguishing accuracy is more than 75%.

Effect of Pulsed Current on the Tensile Deformation Behavior and Microstructure Evolution of AZ80 Magnesium Alloy.

In this work, the tensile deformation behavior of an as-extruded AZ80 magnesium alloy under pulsed current (PC) was investigated based on microstructure observations. We found that compared with the tensile tests at room temperature (RT) and given temperature (GT), the flow stress is reduced due to both thermal and athermal effects of pulsed current. A quasi-in-situ electron backscatter diffraction (EBSD) analysis reveals that at the same strain, the geometrically necessary dislocation (GND) density of the RT sample is the highest, followed by the GT sample and the PC sample. This proves that the athermal effect can promote the annihilation of dislocations and slow down dislocation pileup, which reduces the flow stress. In addition, the twinning behavior under different deformation conditions was studied; the twins are {10-12} tension twins, which are activated with the assistance of local stress. We found that the twin fraction in the PC sample is lower than that in the RT and GT samples, due to the least accumulation of GNDs at grain boundaries, which decreases the nucleation of {10-12} tension twins.