Optimising Laparoscopic Artificial Insemination in Lohi Sheep: Effects of Timing, Sperm Concentration and Body Condition on Fertility Outcome in Subtropical Climates.

The objective of this study was to determine the optimal timing, sperm concentration, and body condition score (BCS) for laparoscopic artificial insemination (LAI) in the subtropical Lohi sheep breed. In Experiment 1, Lohi ewes (n = 80) were synchronised through progestin-sponges (day 0-day 11), administering PGF2α (d-cloprostenol 75 µg/mL; i.m. @ 75 µg /ewe) on day 09 and eCG (i.m. @ 300 IU/ewe) on day 11. Ewes were divided equally into four groups (n = 20 each) and then LAI was performed at 48 (T48), 60 (T60), 72 (T72) and 96 (T96) hours post-sponge removal using 200 million sperm/insemination. In Experiment 2, ewes (n = 81) were synchronised as in Experiment I. Following synchronisation ewes were divided into four groups, each subjected to LAI employing varying sperm concentrations: 10 (S10; n = 21), 20 (S20; n = 20), 50 (S50; n = 20), or 100 (S100; n = 20) million per insemination. Inseminations were performed within a time window of 48-60 h post-sponge removal, based on the findings from Experiment 1. In both experiments ewes were categorised according to BCS, that is, medium 3 and high > 3. Results of Experiment 1 revealed a quadratic response that ewes inseminated at 60-h post-sponge removal exhibited significantly higher pregnancy and twinning rates (p = 0.02). The results of Experiment 2 revealed that sperm concentration had a quadratic effect, 50 million sperm per insemination resulted in maximal pregnancy rates (p = 0.01). Additionally, ewes with medium BCS (≤ 3) had higher pregnancy rates than high BCS (> 3) ewes. In conclusion, ewes with medium BCS (≤ 3) are ideal candidate for LAI and can be inseminated at 60 h with minimal sperm 50 × 106/dose post-sponge removal to achieve a maximum pregnancy rate.

Factors influencing pregnancy rate and loss after laparoscopic artificial insemination with frozen-thawed semen in Lohi sheep under sub-tropical conditions.

This study evaluates factors influencing pregnancy rates per artificial insemination (P/AI) and pregnancy loss in Lohi ewes undergoing laparoscopic AI with frozen-thawed semen under sub-tropical conditions. Data from three experiments comprising ewes (n = 358) of mixed parity (nulliparous; NP and parous; P), various body condition score (BCS) and assigned to long-term (LTP, 11 days) and short-term (STP, 5 days) oestrus synchronization regimen across high breeding season (HBS) and low breeding season (LBS) were analysed. Laparoscopic insemination was conducted 54 h post-sponge removal. Pregnancy diagnosis and loss were evaluated on days 35 and 90 post-insemination via ultrasonography. Results showed parity significantly influenced P/AI, with nulliparous ewes achieving higher pregnancy ratios than parous ewes (p = .001). BCS significantly influenced P/AI (p < .05), with a quadratic relationship observed between BCS and season (BCS*BCS*Season; p = .07). Progestin treatment did not significantly influence the ratio of pregnant ewes (p = .07). Pregnancy losses were significantly higher during LBS than HBS (p < .05), irrespective of progestin treatment. In conclusion, parity and BCS significantly influenced P/AI, with BCS demonstrating a quadratic association with season. Ewes bred during LBS experienced higher pregnancy losses than HBS, irrespective of progestin treatment.

Editing microbes to mitigate enteric methane emissions in livestock.

Livestock production significantly contributes to greenhouse gas (GHG) emissions particularly methane (CH4) emissions thereby influencing climate change. To address this issue further, it is crucial to establish strategies that simultaneously increase ruminant productivity while minimizing GHG emissions, particularly from cattle, sheep, and goats. Recent advancements have revealed the potential for modulating the rumen microbial ecosystem through genetic selection to reduce methane (CH4) production, and by microbial genome editing including CRISPR/Cas9, TALENs (Transcription Activator-Like Effector Nucleases), ZFNs (Zinc Finger Nucleases), RNA interference (RNAi), Pime editing, Base editing and double-stranded break-free (DSB-free). These technologies enable precise genetic modifications, offering opportunities to enhance traits that reduce environmental impact and optimize metabolic pathways. Additionally, various nutrition-related measures have shown promise in mitigating methane emissions to varying extents. This review aims to present a future-oriented viewpoint on reducing methane emissions from ruminants by leveraging CRISPR/Cas9 technology to engineer the microbial consortia within the rumen. The ultimate objective is to develop sustainable livestock production methods that effectively decrease methane emissions, while maintaining animal health and productivity.

Recent advances in chromosome capture techniques unraveling 3D genome architecture in germ cells, health, and disease.

In eukaryotes, the genome does not emerge in a specific shape but rather as a hierarchial bundle within the nucleus. This multifaceted genome organization consists of multiresolution cellular structures, such as chromosome territories, compartments, and topologically associating domains, which are frequently defined by architecture, design proteins including CTCF and cohesin, and chromatin loops. This review briefly discusses the advances in understanding the basic rules of control, chromatin folding, and functional areas in early embryogenesis. With the use of chromosome capture techniques, the latest advancements in technologies for visualizing chromatin interactions come close to revealing 3D genome formation frameworks with incredible detail throughout all genomic levels, including at single-cell resolution. The possibility of detecting variations in chromatin architecture might open up new opportunities for disease diagnosis and prevention, infertility treatments, therapeutic approaches, desired exploration, and many other application scenarios.

Synergistic effect of extracellular adenosine triphosphate and quercetin on post-thaw quality and fertilization potential of Lohi ram sperm.

This study determined the individual and combined effects of extracellular adenosine triphosphate (ATP) and quercetin (QUE) on the quality of post-thawed sperm and the fertilization potential of Lohi rams. In experiment 1, semen samples from four Lohi rams were pooled and extended with different concentrations of ATP or QUE (control; no ATP or QUE, 1 or 2 mM ATP and 10 or 20 µM QUE). In experiment 2, pooled semen samples were extended with various combinations of ATP and QUE (control; no ATP and QUE, 1 mM ATP + 10 µM QUE, 1 mM ATP + 20 µM QUE, 2 mM ATP + 10 µM QUE and 2 mM ATP + 20 µM QUE). All samples in both experiments were cryopreserved and analyzed for post-thawed sperm quality. In experiment 3, the best combination of ATP and QUE from experiment 2 was to extend semen, which was then used for laparoscopic insemination in estrus-synchronized ewes (n = 83). The results of experiment 1 showed that 1 mM ATP and 20 µM QUE treatments resulted in higher total motility, progressive motility, viability, plasma membrane intactness (PMI), and motion kinetics (VCL, VSL, VAP, LIN, and STR) compared to other treatments (p < 0.05). In experiment 2, the 1 mM ATP +10 µM QUE-treated group exhibited significantly higher total and progressive motility, PMI, and motion kinetics (VSL, VCL, VAP, STR, and BCF) compared to the control group (p < 0.05). In experiment 3, the fertilizing potential of sperms treated with 1 mM ATP +10 µM QUE was greater than that of untreated controls (58.1% vs. 27.5%, respectively, p-value = 0.012). In conclusion, the quality of post-thawed ram semen is enhanced when the extender is supplemented with extracellular 1 mM ATP and 20 µM QUE, whether used separately or in combination with 1 mM ATP and 10 µM QUE. Furthermore, the inclusion of 1 mM ATP and 10 µM QUE together in the extender significantly improves in vivo fertility in Lohi ram.

Surface Characteristics of Silicon Nanowires/Nanowalls Subjected to Octadecyltrichlorosilane Deposition and n-octadecane Coating.

In this study, nanowires/nanowalls were generated on a silicon wafer through a chemical etching method. Octadecyltrichlorosilane (OTS) was deposited onto the nanowire/nanowall surfaces to alter their hydrophobicity. The hydrophobic characteristics of the surfaces were further modified via a 1.5-µm-thick layer of n-octadecane coating on the OTS-deposited surface. The hydrophobic characteristics of the resulting surfaces were assessed using the sessile water droplet method. Scratch and ultraviolet (UV)-visible reflectivity tests were conducted to measure the friction coefficient and reflectivity of the surfaces. The nanowires formed were normal to the surface and uniformly extended 10.5 µm to the wafer surface. The OTS coating enhanced the hydrophobic state of the surface, and the water contact angle increased from 27° to 165°. The n-octadecane coating formed on the OTS-deposited nanowires/nanowalls altered the hydrophobic state of the surface. This study provides the first demonstration that the surface wetting characteristics change from hydrophobic to hydrophilic after melting of the n-octadecane coating. In addition, this change is reversible; i.e., the hydrophilic surface becomes hydrophobic after the n-octadecane coating solidifies at the surface, and the process again occurs in the opposite direction after the n-octadecane coating melts.

Nuclear morphology, diameter and meiotic competence of buffalo oocytes relative to follicle size.

The nuclear morphology, diameter and in vitro meiotic competence of buffalo oocytes was compared relative to follicle size. Cumulus-oocyte complexes (COCs) were collected from 1-<2, 2-<3, 3-<4, 4-<6 and 6-<8 mm follicles from abattoir ovaries. Cumulus cells were removed using 3 mg mL(-1) hyaluronidase in saline and repeated pipetting. Denuded oocytes were measured, fixed in 3% glutaraldehyde, stained with 4,6-diamidoino-2-phenylindole and evaluated for nuclear morphology, namely the stage of germinal vesicle (GV) development before in vitro maturation (IVM). The COCs from >2-mm follicles were matured in vitro in their respective size groups for 24 h in Medium 199 supplemented with 10 microg mL(-1) follicle-stimulating hormone, 10 microg mL(-1) luteinizing hormone, 1.5 microg mL(-1) oestradiol, 75 microg mL(-1) streptomycin, 100 IU mL(-1) penicillin, 10 mM HEPES and 10% fetal bovine serum. Matured oocytes were fixed, stained and evaluated for GV status and meiotic development. The number of oocytes collected from follicles 1-<8 mm in diameter averaged 1.82 per ovary. Oocytes from follicles 1-<2 mm (107.7 +/- 1.6 microm), 2-<3 mm (108 +/- 1.1 microm) and 3-<4 mm (114.6 +/- 1.3 microm) in diameter were smaller in diameter (P < 0.05) than oocytes from follicles 4-<6 mm (124.4 +/- 1.3 microm) and 6-<8 mm (131.9 +/- 1.4 microm) in diameter. A majority of oocytes (P< 0.05) from <4-mm follicles was at the initial stages of GV development (GV-I, II and III), whereas oocytes from 4-<6- and 6-<8-mm follicles were at the final stages of GV-IV (35.0 and 21.6% respectively) and GV-V (49.1 and 67.5% respectively). Poor IVM rates of 32.0% and 32.7% to metaphase (M)-II were observed for oocytes isolated from 2-<3- and 3-<4-mm follicles, respectively, whereas significantly (P< 0.05) more oocytes from 4-<6- and 6-<8-mm follicles reached M-II (67.1% and 79.1% respectively). In conclusion, buffalo oocytes displayed a size-dependent ability to undergo meiotic maturation and we suggest that oocytes from >4-mm follicles should be considered in buffalo in vitro fertilization systems for better results.