Preparation of core-shell Ag@CeO2 nanocomposite by LSPR photothermal induced interface reaction.

The core-shell structure of Ag@CeO2 was prepared by a novel and facile method, which was based on the photothermal effect of localized surface plasmon resonance (LSPR). Nanoparticles (NPs) of Ag were dispersed in a solution containing citric acid, ethylene glycol and cerium nitrate, then under irradiation, Ag NPs generated heat from LSPR and the heat-induced polymerization reaction in the interface between Ag and the sol resulted in cerium gel formation only on the surface of the Ag NPs. After calcination, Ag@CeO2 was successfully obtained, then Ag@CeO2/SiO2 was prepared by loading Ag@CeO2 on SiO2. The resultant catalyst exhibited favorable activity and stability for CO oxidation. The preparation method proposed here should be extendable to other composites with metallic cores and oxide shells in which the metallic nanoparticle possesses LSPR properties.

Role of disorder in the thermodynamics and atomic dynamics of glasses.

We measured the density of vibrational states (DOS) and the specific heat of various glassy and crystalline polymorphs of SiO2. The typical (ambient) glass shows a well-known excess of specific heat relative to the typical crystal (α-quartz). This, however, holds when comparing a lower-density glass to a higher-density crystal. For glassy and crystalline polymorphs with matched densities, the DOS of the glass appears as the smoothed counterpart of the DOS of the corresponding crystal; it reveals the same number of the excess states relative to the Debye model, the same number of all states in the low-energy region, and it provides the same specific heat. This shows that glasses have higher specific heat than crystals not due to disorder, but because the typical glass has lower density than the typical crystal.

Characterization of a novel anther-specific gene encoding a leucine-rich repeat protein in petunia.

In Petunia x hybrida 'Fantasy Red', a leucine-rich repeat (LRR) gene referred to as PhLRR, was identified in a flower bud cDNA library. The open reading frame sequence of PhLRR was 1251 bp, encoding a putative 46.2-kDa protein of 416 amino acids. The PhLRR protein showed high similarity to members of polygalacturonase inhibitor proteins (PGIPs), contained 11 conserved LRR domains, and was an extracellular localization protein. Phylogenetic analysis showed that PhLRR belonged to the same PGIPs subfamily as SHY, indicating that PhLRR may be involved in the development of pollen-like SHY. Expression analysis revealed that PhLRR was abundantly expressed during early stages of flower bud and anther development, while it was not detected in any other examined organs, such as sepals, petals, pistils, roots, stems, leaves, or open flowers. Furthermore, many cis-acting elements (such as AGAAA and GTGA) related to anther-specific gene expression were identified in the PhLRR gene promoter region, indicating that the promoter is also anther-specific. These results suggested that PhLRR is a novel anther-specific gene that may be essential for the early development of anthers.

Surface evolution of aluminosilicate glass fibers during dissolution: Influence of pH, solid-to-solution ratio and organic treatment.

Materials made of synthetic vitreous mineral fibers, such as stone wool, are widely used in construction, in functional composites and as thermal and acoustic insulation. Chemical stability is an important parameter in assessing long term durability of the products. Stability is determined by fiber resistivity to dissolution, where the controlling parameters are solid surface area to solution volume ratio (S/V), pH and composition of the fibers and organic compounds used as binders. We investigated stone wool dissolution under flow through conditions, far from equilibrium, at pH range of 2 to 13, as well as under batch conditions, close to equilibrium, for up to 28 days, where S/V ranged from 100 to 10000 m-1. The dissolution rate of stone wool shows minimum at pH 8.5 and increases significantly at pH < 4.5 and pH > 12. In close to equilibrium conditions, S/V defines the steady state concentration for the leached components. Decreased dissolution rate could result from evolution of a surface leached layer or the formation of secondary surface phases or both. We suggested three dissolution rate controlling mechanisms, which depend on pH. That is, dissolution is controlled by: a SiO2 rich surface layer at pH < 4.5; by adsorption of an Al and Al-Si mixed surface layer at 5 < pH < 11 and by divalent cation adsorption and formation of secondary phases (silicates, hydroxides) at pH âˆ¼ 13. The organic compounds, used to treat the stone wool fibers during manufacture, had no influence on their dissolution properties.

Vibrational properties of nanograins and interfaces in nanocrystalline materials.

The vibrational dynamics of nanocrystalline Fe(90)Zr(7)B(3) was studied at various phases of crystallization. The density of phonon states (DOS) of the nanograins was separated from that of the interfaces for a wide range of grain sizes and interface thicknesses. The DOS of the nanograins does not vary with their size and down to 2 nm grains still closely resembles that of the bulk. The anomalous enhancement of the phonon states at low and high energies originates from the DOS of the interfaces and scales linearly to their atomic fraction.

Density of vibrational states of a hyperquenched glass.

The vibrational density of states of a hyperquenched and an annealed glass has been measured using nuclear inelastic scattering. The hyperquenched sample shows a higher number of vibrational states in the low-energy region with respect to the annealed glass. It reveals, however, lower density and sound velocity and, therefore, smaller Debye energy. After rescaling the energy axes in Debye energy units and area renormalization, the density of states of both samples becomes identical. Thus, the effect of quenching is described by the transformation of the continuous medium.