CuO/Cu composite nanospheres on a TiO2 nanotube array for amperometric sensing of glucose.

A non-enzymatic glucose sensor based on the use of CuO-Cu nanospheres placed on a TiO2 nanotube (TNT) array with excellent performance is described. The electrode was fabricated by coating the CuO-Cu nanospheres onto the TNT array through electrochemical deposition. The CuO-Cu nanospheres with a diameter of ~200 nm are well dispersed on the TNT surface, which warrants smooth interaction and a 3D nanostructure with high uniformity. The modified electrode was then used for amperometric determination of glucose in 0.1 M NaOH solution. Figures of merit include (a) a typical working voltage of 0.65 V (vs. Ag/AgCl). (b) a linear range as wide as from 0.2-90 mM, (c) good sensitivity (234 µA mM-1 cm-2), and a 19 nM lower detection limit. The sensor is selective over ascorbic acid (AA), dopamine (DA), uric acid (UA), lactose, sucrose, and fructose. Graphical abstract.

Design and development of ferrocene-containing chitosan-cografted-branched polyethylenimine redox conjugates for monitoring free flap failure after reconstructive surgery.

We reported a proof-of-concept study of developing an electrochemical biosensor for prolonged continuous monitoring free flap failure caused by vascular occlusion after reconstructive surgery. Ferrocene (Fc)-containing Chitosan-cografted-Branched Polyethylenimine redox conjugates (CHIT-Fc-co-BPEI-Fc) were used as pH-tuneable matrix to attach the target enzymes (glucose oxidase ≡ GOD and lactate oxidase ≡ LOD, respectively) to build up the corresponding GOD-sensor and LOD-sensor. The sensitivity of GOD-/LOD-sensor was found to be 2.89(±0.06)µA/mM and 2.95(±0.19)µA/mM with a limit of detection (LOD) of 0.047 mM and 0.172 mM, respectively. The sensor performance was further pre-clinically validated via rabbit study, which confirmed that the designed biosensors could electrochemically detect the changes of metabolite levels caused by flap failure within minutes. This sensor protocol is able to be fabricated as embedded biosensor for prolong continuous detection for clinical application/research.

Magnetic nanoparticle enhanced surface plasmon resonance sensing and its application for the ultrasensitive detection of magnetic nanoparticle-enriched small molecules.

Magnetic nanoparticles (MNPs) have been frequently used in bioseparation, but their applicability in bioassays is limited due to their extremely small size so that sensitive detection is difficult to achieve using a general technique. Here, we present an amplification technique using MNPs for an enhanced surface plasmon resonance (SPR) bioassay. The amplification effect of carboxyl group modified Fe(3)O(4) MNPs of two sizes on SPR spectroscopy is first demonstrated by assembling MNPs on amino group modified SPR gold substrate. To further evaluate the feasibility of the use of Fe(3)O(4) MNPs in enhancing a SPR bioassay, a novel SPR sensor based on an indirect competitive inhibition assay (ICIA) is developed for detecting adenosine by employing Fe(3)O(4) MNP-antiadenosine aptamer conjugates as the amplification reagent. The results confirm that Fe(3)O(4) MNPs can be used as a powerful amplification agent to provide a sensitive approach to detect adenosine by SPR within the range of 10-10,000 nM, which is much superior to the detection result obtained by a general SPR sensor. Importantly, the present detection methodology could be easily extended to detect other biomolecules of interest by changing the corresponding aptamer in Fe(3)O(4) MNP-aptamer conjugates. This novel technique not only explores the possibility of the use of SPR spectroscopy in a highly sensitive detection of an MNP-based separation product but also offers a new direction in the use of Fe(3)O(4) MNPs as an amplification agent to design high performance SPR biosensors.

An Overview of Carbon Nanotubes and Graphene for Biosensing Applications.

With the development of carbon nanomaterials in recent years, there has been an explosion of interests in using carbon nanotubes (CNTs) and graphene for developing new biosensors. It is believed that employing CNTs and graphene as sensor components can make sensors more reliable, accurate, and fast due to their remarkable properties. Depending on the types of target molecular, different strategies can be applied to design sensor device. This review article summarized the important progress in developing CNT- and graphene-based electrochemical biosensors, field-effect transistor biosensors, and optical biosensors. Although CNTs and graphene have led to some groundbreaking discoveries, challenges are still remained and the state-of-the-art sensors are far from a practical application. As a conclusion, future effort has to be made through an interdisciplinary platform, including materials science, biology, and electric engineering.

Single domain antibody coated gold nanoparticles as enhancer for Clostridium difficile toxin detection by electrochemical impedance immunosensors.

This work presents a sandwich-type electrochemical impedance immunosensor for detecting Clostridium difficile toxin A (TcdA) and toxin B (TcdB). Single domain antibody conjugated gold nanoparticles were applied to amplify the detection signal. Gold nanoparticles (Au NPs) were characterized by transmission electron microscopy and UV­vis spectra. The electron transfer resistance (Ret) of the working electrode surface was used as a parameter in the measurement of the biosensor. With the increase of the concentration of toxins from 1 pg/mL to 100 pg/mL, a linear relationship was observed between the relative electron transfer resistance and toxin concentration. In addition, the detection signal was enhanced due to the amplification effect. The limit of detection for TcdA and TcdB was found to be 0.61 pg/mL and 0.60 pg/mL respectively at a signal-to-noise ratio of 3 (S/N = 3). This method is simple, fast and ultrasensitive, thus possesses a great potential for clinical applications in the future.

Experimental investigation of magnetically actuated separation using tangential microfluidic channels and magnetic nanoparticles.

A novel continuous switching/separation scheme of magnetic nanoparticles (MNPs) in a sub-microlitre fluid volume surrounded by neodymium permanent magnet is studied in this work using tangential microfluidic channels. Polydimethylsiloxane tangential microchannels are fabricated using a novel micromoulding technique that can be done without a clean room and at much lower cost and time. Negligible switching of MNPs is seen in the absence of magnetic field, whereas 90% of switching is observed in the presence of magnetic field. The flow rate of MNPs solution had dramatic impact on separation performance. An optimum value of the flow rate is found that resulted in providing effective MNP separation at much faster rate. Separation performance is also investigated for a mixture containing non-magnetic polystyrene particles and MNPs. It is found that MNPs preferentially moved from lower microchannel to upper microchannel resulting in efficient separation. The proof-of-concept experiments performed in this work demonstrates that microfluidic bioseparation can be efficiently achieved using functionalised MNPs, together with tangential microchannels, appropriate magnetic field strength and optimum flow rates. This work verifies that a simple low-cost magnetic switching scheme can be potentially of great utility for the separation and detection of biomolecules in microfluidic lab-on-a-chip systems.

Magnetite nanoparticles doped photoresist derived carbon as a suitable substratum for nerve cell culture.

A method which alters the substrate's physical and electrochemical properties by doping photoresist derived carbon with magnetite nanoparticles has been developed to enhance the existing substrate's ability to foster cell growth. Cyclic voltammetry, scanning electron microscopy and atomic force microscopy are used to evaluate the characters of the prepared film. And then, the magnetite nanoparticles doped carbon film is used as substrate for the growth of nerve cell. Here, rat pheochromocytoma cells are used for culture to test substrate-cell interactions. The results showed an increase in cell concentration and average neurite length with the increase of nanoparticle concentration on the surface. Importantly, the nerve cells can be grown on the magnetite nanoparticles doped carbon even in the absence of nerve growth factor. This finding will potentially provide a new material for nerve regeneration.

Fe3O4 nanoparticles-enhanced SPR sensing for ultrasensitive sandwich bio-assay.

Magnetic nanoparticles (MNPs) have been receiving increasing attention because of its great potentials in bioseparation. However, the separation products are difficult to be detected by general method due to their extremely small size. Here, we demonstrate that MNPs can greatly enhance the signal of surface plasmon resonance spectroscopy (SPR). Features of MNPs-aptamer conjugates as a powerful amplification reagent for ultrasensitive immunoassay are reported in this work for the first time. In order to evaluate the sensing ability of MNPs-aptamer conjugates as an amplification reagent, a sandwich SPR sensor is constructed by using thrombin as model analyte. Thrombin, captured by immobilized anti-thrombin aptamer on SPR gold film, is sensitively detected by SPR spectroscopy with a lowest detection limit of 0.017 nM after MNPs-aptamer conjugates is used as amplification reagent. At the same time, the excellent selectivity of the present biosensor is also confirmed by using three kinds of proteins (BSA, human IgM and human IgE) as controls. These results confirm that MNPs is a powerful sandwich element and an excellent amplification reagent for SPR based sandwich immunoassay and SPR has a great potential for the detection of MNPs-based bioseparation products.