Three-dimensional analysis of biplanar glenoid deformities: what are they and can they be virtually reconstructed with anatomic total shoulder arthroplasty implants?

BACKGROUND: Descriptions of glenoid deformities in glenohumeral osteoarthritis (GHOA) have focused on the axial plane. Less is known regarding arthritic glenoids with higher amounts of superior inclination and little evidence exists to guide management of inclination or combined version-inclination deformity when performing anatomic total shoulder arthroplasty (aTSA). We hypothesized that biplanar deformities (BD) would be present in a higher proportion of GHOA patients than previously appreciated, and these deformities would be difficult to adequately reconstruct with contemporary aTSA implants. METHODS: A retrospective query was performed of GHOA patients indicated for TSA 2012-2017 with a computed tomography (CT) scan within three months of surgery. Images were uploaded to three-dimensional (3D) software for automated measurements. Glenoids with superior inclination ≥10°, and retroversion ≥20° were considered to have BD. Walch classification was determined, and C-type glenoids were excluded. Rotator-cuff muscle cross-sectional area (CSA) was measured and fatty infiltration was graded. Glenoids with BD were virtually planned for aTSA with correction to neutral inclination and version, then with 5° superior inclination and 10° retroversion. RESULTS: Two-hundred and sixty-eight shoulders in 250 patients were included; average age was 65 years, 67% male. There were no differences in inclination between Walch types (P = .25). Twenty-nine shoulders with BD were identified (11%). These deformities were not associated with age (P = .47) or gender (P = .50) but were skewed towards Walch B-type, specifically B2 (P = .03). Acromial index and posterior humeral head subluxation were higher in BD patients (P = .04, P < .001, respectively). Biplanar deformities had similar cuff CSA compared to those without but were less frequently associated with fatty infiltration of the subscapularis (P = .05). When correcting to neutral version and inclination, 41% BD could not be reconstructed. Of those that could, 94% required augmented implants. When correcting to 5° superior inclination and 10° retroversion, 10% could not be reconstructed. Of those that could, 58% required augmented implants. With partial correction, augment use was predicted by retroversion >26° (P = .009). Inclination did not predict augment use (P = .90). Final implant position commonly involved unseating in the posterosuperior quadrant and cancellous exposure in the anteroinferior quadrant. CONCLUSIONS: This retrospective computed tomography (CT)-based study of 268 shoulders with GHOA found an 11% prevalence of BD. These deformities were commonly associated with Walch B2 wear patterns. Virtual aTSA planning showed a high failure rate (41%) when correcting to neutral version and inclination. Posteriorly augmented implants were frequently required, and often still involved unseating in the posterosuperior quadrant, increased cancellous exposure in the anteroinferior quadrant, and vault perforation.

Clinical and Radiographic Outcomes and Graft Incorporation Rate Assessed by CT Scan After Reverse Shoulder Arthroplasty With Glenoid Structural Bone Graft Reconstruction.

INTRODUCTION: Reverse total shoulder arthroplasty (RTSA) with structural bone graft has been described as a technique in addressing glenoid bony defects. Studies have demonstrated acceptable outcomes with structural autograft or allograft. However, most of these studies are relatively small and rarely evaluate bone graft incorporation with CT scan. The aim of this study was to assess clinical and radiographic outcomes and report graft incorporation assessed on CT scan after RTSA where structural bone autograft or allograft was used to reconstruct the glenoid. METHODS: From May 2011 through June 2016, 38 patients underwent RTSA with structural bone graft. Of these, 35 were available for a minimum 2-year follow-up and retrospectively enrolled. From July 2016 through February 2019, 32 patients undergoing RTSA with structural bone graft were prospectively enrolled. Preoperative and postoperative American Shoulder and Elbow Surgeons and visual analog scale (for pain) scores and radiographs were obtained. CT scan was obtained at least 1 year postoperatively. RESULTS: Thirty-five patients were enrolled retrospectively (52.2%) and 32 prospectively (47.8%). Autograft was used in 46 cases (68.7%) and allograft in 21 cases. The mean American Shoulder and Elbow Surgeons score improved from 33.1 (SD 18.5) to 78.2 (SD 22.4), with P < 0.0001. On postoperative radiographs, 63 cases (94.0%) showed stable RTSA constructs while four cases (6.0%) developed glenoid baseplate subsidence. Postoperative CT scan demonstrated complete graft incorporation in 45 cases (90.0%) while partial incorporation was noted in 4 cases (8.0%), and in 1 case (2.0%), there was no graft incorporation. No correlation was observed between baseplate subsidence and graft type (autograft versus allograft) or primary versus revision surgery. DISCUSSION: Reverse shoulder arthroplasty with structural bone autograft and allograft is reliable for glenoid augmentation in patients undergoing RTSA in both primary and revision settings. Bony incorporation of autograft and allograft as evaluated on CT scan is predictably high.

Incidence of and Risk Factors for Reoperation and Revision Following Total Elbow Arthroplasty with an Anatomic Convertible Prosthesis.

BACKGROUND: Total elbow arthroplasty (TEA) remains a valuable tool for treating inflammatory, degenerative, and traumatic elbow conditions. This study aimed to understand the incidence of and risk factors for reoperation following TEA at a high-volume center utilizing an implant with a convertible linkage and the potential for anatomic lateral column reconstruction. METHODS: All patients undergoing primary TEA with the Latitude prosthesis (Stryker) from July 2001 to May 2020 were identified. Patient characteristics, the surgical indication, and implant characteristics were obtained. Additionally, the indications and timing were identified for reoperations. Postoperative radiographs were analyzed to assess cement quality, implant position, lateral column reconstruction, and distal humeral bone loss. RESULTS: Two hundred and nineteen TEAs were performed in 206 patients; 162 (74.0%) were in female patients, the mean patient age was 61 years (range, 23 to 95 years), and the mean follow-up was 11.8 years (range, 2 to 21 years). The most common indication for surgery was sequelae of trauma (36%). Ninety elbows (41.1%) required 200 reoperations at a mean of 19.6 months. Forty TEAs (18.3%) required revision of nonmodular implants, with 14 (6.4%) undergoing definitive explantation. The 5 and 10-year survivorship was 86.1% and 79.7%, respectively. The most common of the reasons for revision was aseptic loosening (53.8%), and the most common cause for non-revision reoperation was infection (23%). Younger age and greater follow-up duration were associated with greater revision and reoperation risks. Aseptic ulnar loosening was associated with a short ulnar stem length and component linkage (30% of short linked ulnar stems loosened; p < 0.001). Aseptic humeral loosening was associated with less-than-adequate cement-mantle quality (p = 0.04). CONCLUSIONS: Extended follow-up of the Latitude prosthesis at a high-volume center demonstrates that TEA continues to be hampered by a high reoperation rate, primarily due to infection and aseptic loosening. Technical factors such as good cement-mantle quality, longer stem length, and unlinked implants may play a role in preventing aseptic loosening. Further work is required to optimize long-term outcomes following TEA through improved understanding of appropriate surgical indications, techniques, and implant utilization. LEVEL OF EVIDENCE: Therapeutic Level IV . See Instructions for Authors for a complete description of levels of evidence.