Mechanism Involved in Polyvinyl Chloride Nanoplastics Induced Anaerobic Granular Sludge Disintegration: Microbial Interaction Energy, EPS Molecular Structure, and Metabolism Functions.

Nanoplastics (NPs) are emerging pollutants and have been reported to cause the disintegration of anaerobic granular sludge (AnGS). However, the mechanism involved in AnGS disintegration was not clear. In this study, polyvinyl chloride nanoplastics (PVC-NPs) were chosen as target NPs and their long-term impact on AnGS structure was investigated. Results showed that increasing PVC-NPs concentration resulted in the inhibition of acetoclastic methanogens, syntrophic propionate, and butyrate degradation, as well as AnGS disintegration. At the presence of 50 µg·L-1 PVC-NPs, the hydrophobic interaction was weakened with a higher energy barrier due to the relatively higher hydrophilic functional groups in extracellular polymeric substances (EPS). PVC-NPs-induced ROS inhibited quorum sensing, significantly downregulated hydrophobic amino acid synthesis, whereas it highly upregulated the genes related to the synthesis of four hydrophilic amino acids (Cys, Glu, Gly, and Lys), resulting in a higher hydrophily degree of protein secondary structure in EPS. The differential expression of genes involved in EPS biosynthesis and the resulting protein secondary structure contributed to the greater hydrophilic interaction, reducing microbial aggregation ability. The findings provided new insight into the long-term impact of PVC-NPs on AnGS when treating wastewater containing NPs and filled the knowledge gap on the mechanism involved in AnGS disintegration by PVC-NPs.

High-Performance Flexible Graphene Oxide-Based Moisture-Enabled Nanogenerator via Multilayer Heterojunction Engineering and Power Management System.

Recently, there has been a surge of interest in nanogenerators within the scientific community because their immense potential for extracting energy from the surrounding environment. A promising approach involves utilizing ambient moisture as an energy source for portable devices. In this study, moisture-enabled nanogenerators (MENGs) are devised by integrating heterojunctions of graphene oxide (GO) and reduced graphene oxide (rGO). Benefiting from the unique structure, a larger ion concentration gradient is achieved as well as a lower resistance, which leads to enhanced electricity generation. The resulting MENG generates a desirable open-circuit voltage of 0.76 V and a short-circuit current density of 73 µA cm-2 with a maximum power density of 15.8 µW cm-2 . Notably, the designed device exhibits a high voltage retention of more than 90% after 3000 bending cycles, suggesting a high potential for flexible applications. Moreover, a large-scale integrated MENG array is developed by incorporating flexible printed circuit technology and connecting it to a power management system. This integrated system can provide ample energy to operate an electronic ink display and drive a heart rate sensor for health monitoring. The outcomes of this research present a novel framework for advancing next-generation self-powered flexible devices, thereby demonstrating significant promise for future wearable electronics.

A novel pre-magnetized ZVI/PS pretreatment for improving sludge dewaterability: The role of EPS fractions.

The dewaterability of waste-activated sludge (WAS) has been extensively examined using zero-valent iron (ZVI)-based advanced oxidation processes (AOPs). However, the high dosage and low utilization efficiencies of ZVI cast doubt on the dependability and viability of ZVI-based AOPs. In this study, we successfully demonstrated pre-magnetization as an efficient, chemical-free, and ecological method for improving the efficiency of sludge dewatering by ZVI/persulfate (PS) process, in which the reduction ratios of capillary suction time (CST) and specific resistance to filtration (SRF) increased by 8.67% and 11.06% under optimal conditions, respectively. The highly active Fe2+ released during ZVI corrosion may be more essential than ZVI itself during PS activation, which could be strengthened by pre-magnetization. Both homogeneous and heterogeneous Fe2+ could react with PS to produce aqueous hydroxyl radicals (∙OH) and sulfate radicals (SO4-∙) as well as surface-bound ∙OH and SO4-∙, further decomposing bound-extracellular polymeric substances fractions, broking hydrophilic functional groups and compounds, altering protein secondary structure to expose more hydrophobic sites, and releasing abundant EPS-bound water. Due to the protection of tightly-bound extracellular polymeric substances (TB-EPS) and the competitive oxidation of organics released during the early disintegration stage, radical oxidation primarily occurs at extracellular levels, releasing a bit of intracellular water. Besides, polysaccharides in TB-EPS may function a more significant role in flocculation than proteins, and a porous structure favorable to drainage will be formed after the pre-magnetized ZVI/PS treatment. The cost-benefit analysis further reveals that the Pre-ZVI/PS process presents high reusability and utilization, making it potential for particle application in sludge dewatering.

In Situ Interfacial Polymerized Arginine-Doped Polydopamine Thin-Film Nanocomposite Membranes for High-Separation and Antifouling Reverse Osmosis.

In this work, we synthesized polydopamine nanoparticles (PDNPs-M, M = I, II, III, and IV) with uniform particle sizes but varying l-arginine (Arg) contents (0%, 0.53%, 3.73%, and 6.62%) through a one-pot synthesis approach. Thin-film nanocomposite (TFN) membranes were fabricated via in situ interfacial polymerization (IP). The effects of the PDNPs-M chemical structure on the IP process and the consequent impacts on the structure and properties of the polyamide (PA) selective layer were investigated. The hydrophilicity and dispersibility of PDNPs-M exhibited an upward trend with the Arg content. Furthermore, Arg doping contributes to a denser and smoother PA layer. Among the TFC and TFN membranes, TFN-PDNPs-IV exhibited a water permeability of 3.89 L·m-2·h-1·bar-1 (55.1% higher than that of TFC-0) with a NaCl rejection rate of 98.8%, signifying superior water/salt selectivity. Additionally, TFN-PDNPs-IV exhibited regular pressure stability, commendable acid/alkali stability, and enhanced antifouling properties. These findings highlight the significant impact of nanoparticle hydrophilic functional groups on the structural and functional attributes of TFN membranes, offering a promising approach for developing advanced reverse osmosis membranes.

Fe(II)-activated sodium percarbonate for improving sludge dewaterability: Experimental and theoretical investigation combined with the evaluation of subsequent utilization.

Fe(II)-activated sodium percarbonate (SPC) was an emerging technology for enhancing the dewaterability of waste activated sludge, and its operational parameters were systematically explored. The results showed that after the treatment by 1.20 mmol/g VSS SPC and 1.44 mmol/g VSS Fe(II) at initial pH 3.0, the water content and specific resistance to filtration remained at 76.05 ± 0.36% and 2.57 ± 0.08 × 1012 m·kg-1, respectively. The acid condition was instrumental in sludge dewatering, whereas overdosing Fe(II) or SPC imposed adverse effect. The conversion of EPS fractions was examined to elucidate the underlying mechanism, which indicated that a coexisting oxidation/flocculation process accounted for the improvement of sludge dewaterability. The stronger oxidative ·OH degraded the hydrophilic compounds (proteins and carbohydrates) of tightly-bound extracellular polymeric substance and the dissolved multivalence iron promoted solid-liquid separation. Additionally, the theoretical analysis (DFT calculation) demonstrated that the oxygen- and nitrogen-containing groups of EPS resulted in high-water holding capacity of sludge. The difficulty of destroying hydrophilic functional groups followed C=O > C-N > C-O during oxidation process. Moreover, Fe(II)/SPC treatment performed well in coliforms inactivation and phytotoxicity reduction compared with different ·OH-based advanced oxidation processes for sludge conditioning.

Preparation and characterisation of anion exchangers with dihydroxy-containing alkyl substitutes in the quaternary ammonium functional groups.

Novel poly(styrene-divinylbenzene) (PS-DVB) based anion exchangers having one and two (2,3-dihydroxypropyl) substitutes in the quaternary ammonium functional groups are prepared and characterised by ion chromatography (IC). The introduction of bulky and hydrophilic substitutes to the anion-exchange groups allows the elimination of non-ionic interactions between the polarisable anions and the aromatic rings from the matrix and the improvement of separation selectivity as compared with the traditional trimethylammonium (TMA) functionalised ion exchangers. The synthesis of the ion exchangers includes acylation of PS-DVB particles with acetic anhydride followed by reductive amination either with methylamine hydrochloride or dimethylamine and further alkylation with oxiranes under varied conditions. The ion exchange selectivity and separation efficiency of nine adsorbents having different structure of bonded groups, ion exchange capacity (9-98µequiv.g(-1)) or particle size is studied for model mixture of inorganic anions (F(-), Cl(-), NO2(-), Br(-), NO3(-), HPO4(2-) and SO4(2-)) using carbonate and hydroxide eluents. The adsorbents with more hydrophilic substitutes provided superior columns efficiencies and better peak symmetry as compared with analogues having hydrophobic functional groups. The calculated values of column efficiencies for polarisable NO3(-) and HPO4(2-) are 18,500 and 29,000N/m, respectively, for anion-exchanger, having N-methyl-N',N″-di-(2,3-dihydroxypropyl)ammonium groups which is significantly higher than 1800 and 12,000N/m obtained for these anions with anion exchanger bearing TMA functional groups.