Demonstration of a Conduction Cooled React and Wind MgB2 Coil Segment for MRI Applications.

This study is a contribution to the development of technology for an MgB2-based, cryogen-free, superconducting magnet for an MRI system. Specifically, we aim to demonstrate that a react and wind coil can be made using high performance in-situ route MgB2 conductor, and that the conductor could be operated in conduction mode with low levels of temperature gradient. In this work, an MgB2 conductor was used for the winding of a sub-size, MRI-like coil segment. The MgB2 coil was wound on a 457 mm ID 101 OFE copper former using a react-and-wind approach. The total length of conductor used was 330 m. The coil was epoxy impregnated and then instrumented for low temperature testing. After the initial cool down (conduction cooling) the coil Ic was measured as a function of temperature (15-30 K), and an Ic of 200 A at 15 K was measured.

MgB2 for MRI Magnets: Test Coils and Superconducting Joints Results.

Among key design and operation issues for MgB2 relevant to MRI magnets are: uniformity of current-carrying capacity over long lengths (>2 km) of wire; and reliability of a splicing technique. This paper presents experimental results of current-carrying capacities of a small test coil and joints, both made from MgB2 round wires, multifilament and monofilament (mono), manufactured by Hyper Tech Research, Inc. The test coils were wound with 95-m long unreacted, C (carbon)-doped MgB2 multifilament wire, sintered at 700°C for 90 min. The critical currents were measured in the 4.2 K-15 K and 0 T-5 T ranges. We have modified our original splicing technique, proven successful with unreacted, un-doped MgB2 multifilament wire sintered at 570°C, and applied it to splice both un-doped and C-doped mono wires sintered at 700°C. Most consistently good results were obtained using the un-doped mono wires. Also presented are results of a small joint-coil-PCS assembly of mono wire, operated in persistent mode at 50 A at >10 K.