Construction and Evaluation of Hyaluronic Acid-Coated Flurbiprofen-Layered Double Hydroxide Ocular Drug Delivery System.

In this study, flurbiprofen (FB) was selected as the model drug, and hyaluronic acid-coated flurbiprofen-layered double hydroxide ophthalmic drug delivery system (HA-FB-LDH) was designed and prepared. In this system, the model drug flurbiprofen was intercalated in layered double hydroxide and coated with hyaluronic acid (HA), so as to prolong the corneal residence time and increase the corneal permeability of the drug. Layered double hydroxide (LDH) was prepared by alcohol-water coprecipitation method. Through single factor investigation, the optimum preparation conditions were obtained as follows: The Mg/Al ratio was 2:1, the reaction pH was 11.0, the hydrothermal reaction time was 24 h, and the hydrothermal reaction temperature was 100°C. Under these conditions, the particle size of LDH was 116.4 ± 0.8 nm, the potential was 42.2 ± 1.2 mV, and a relatively regular crystal structure could be had. Then FB was intercalated into the LDH layer to prepare flurbiprofen-layered double hydroxide (FB-LDH). In the end, HA-FB-LDH was prepared by the stirring-ultrasonic method, in which through prescription screening, the molecular weight of HA was 200-400 kDa and the concentration of HA solution was 1.25 mg·mL -1, the final particle size of HA-FB-LDH was 185.8 ± 3.3 nm, and potential of - 31.4 ± 0.7 mV. The successful loading of FB and the coating of HA were verified by XRD, FTIR, TGA, TEM, and other characterization methods. The results of in vitro stability experiment indicated that the coating of HA could significantly enhance the stability of LDH in the presence of electrolytes. The in vitro release results suggested that the cumulative release amounts of FB-LDH and HA-FB-LDH within 12 h were 92.99 ± 0.37% and 74.82 ± 0.29% respectively, showing a certain sustained release effect. At the same time, the release mechanism of FB-LDH was preliminarily explored by in vitro release experiment, which proved that the release mechanism of FB-LDH was mainly ion exchange. The results of in vivo ocular irritation experiments demonstrated that the ophthalmic preparation studied in this paper was safe and non-irritating. The results of tear pharmacokinetics in rabbits showed that the area under the curve(AUC), the average residence time (MRT), and the highest concentration (Cmax) in tears in the HA-FB-LDH group were 4.43, 4.48, and 2.27 times higher than those in eye drops group separately. Furthermore, the AUC of the HA-FB-LDH group was 1.48 times higher than that of the FB-LDH group. The above results suggested that HA-FB-LDH could improve the precorneal residence time. The results of aqueous humor pharmacokinetics in rabbits indicated that the AUC, MRT, and maximum concentration (Cmax) in aqueous humor in the HA-FB-LDH group were 6.88, 2.15, and 4.08 times of those in the eye drop group respectively. Additionally, the AUC and MRT of the HA-FB-LDH group were 1.55 and 1.63 times those of the FB-LDH group separately. These mentioned findings verified that HA-FB-LDH could enhance the corneal permeability of the drug. The fluorescent substance-fluoresce isothiocyanate (FITC) was substituted for FB intercalation in LDH for in vitro tissue imaging study of rabbits, whose results stated clearly that FITC-LDH and HA-FITC-LDH could both prolong the precorneal residence time of drugs, and HA-FITC-LDH could increase the corneal permeability of the drug to a certain extent. To sum up, HA-FB-LDH, which can overcome the shortcomings of low bioavailability of traditional eye drops to a certain degree, is a safe and effective ophthalmic drug delivery system.

Chitosan temperature-sensitive gel loaded with drug microspheres has excellent effectiveness, biocompatibility and safety as an ophthalmic drug delivery system.

In the present study, a temperature-sensitive gel composed of chitosan, carboxymethyl chitosan and glycerophosphate was prepared and loaded with chitosan microspheres encapsulating levofloxacin. The bioavailability of levofloxacin and the safety of this novel opthalmic drug delivery formulation were evaluated. Levofloxacin chitosan microspheres were prepared using the ionic gelation method, and the particle size and entrapment rate were determined. The morphology of the microspheres was observed by scanning electron microscopy. The pH and zeta potential were measured. The in vitro release of levofloxacin by the chitosan temperature-sensitive gel loaded with drug microspheres was determined using spectrophotometry. The eye retention time of the chitosan temperature-sensitive gel was calculated using a fluorescein sodium test. To assess the bioavailability and safety of the chitosan temperature-sensitive gel, a cell compatibility test, a cytotoxicity test and skin irritation test were performed. The entrapment rate of levofloxacin in the chitosan microspheres was determined to be 26.5%. The levofloxacin chitosan microspheres that were formed by chitosan and sodium tripolyphosphate were identified to be suitable for use in an ophthalmic particle dispersion system based on their physical and chemical properties. The pH of the levofloxacin chitosan microsphere suspension was 5.87±0.04, the average particle diameter was 2,452±342 nm, the polydispersity index was 0.168±0.028 and the ζ potential was 28.62±1.7 mV. The chitosan temperature-sensitive gel carrying microspheres loaded with drug prevented drug burst release at the initial stage and facilitated the slow release of the drug later on. Furthermore, this delivery system markedly prolonged the contact duration of levofloxacin with the eye. The chitosan temperature-sensitive hydrogel was safe and provided a good bioavailability of the drug. The results revealed that the chitosan temperature-sensitive gel had a cytotoxicity of grade 0, and no erythematous response was observed during the entire course of the skin irritation test. The present study provided a basis for the future development of the chitosan-based temperature-sensitive hydrogel in ophthalmic drug delivery.