RESUMO
Non-isothermal crystallization kinetics of montmorillonite (MMT)/polyamide 610 (PA610) composites were readily prepared by in situ melt polymerization followed by a full investigation in terms of their microstructure, performance, and crystallization kinetics. The kinetic models of Jeziorny, Ozawa, and Mo were used in turn to fit the experimental data, in all of which Mo's analytical method was found to be the best model for the kinetic data. Differential scanning calorimetry (DSC) and transmission electron microscopy (TEM) studies were used to investigate the isothermal crystallization behavior and MMT dispersion levels in the MMT/PA610 composites. The experiment results revealed that low MMT content can promote the PA610 crystallization, whilst high MMT content result in MMT agglomeration, and reduce the PA610 crystallization rate.
RESUMO
OBJECTIVES: The purpose of this study was to formulate novel triple-layered tablet (TLT) matrices employing modified polyamide 6,10 (mPA6,10) and salted-out poly(lactic-co-glycolic acid) (s-PLGA) in an attempt to achieve stratified zero-order drug release. METHODS: mPA6,10 and s-PLGA were employed as the outer drug-carrier matrices, whereas poly(ethylene oxide) (PEO) was used as the middle-layer drug matrix. Diphenhydramine HCl, ranitidine HCl and promethazine were selected as model drugs to pre-optimize the TLT, whereas atenolol, acetylsalicylic acid and simvastatin were employed as a comparable fixed dose combination to test the TLT prototype in vitro and in vivo (Large White Pig model). A total of 17 formulations that varied in terms of polymer stoichiometry, salt addition and polymer-polymer ratios were generated using a Box-Behnken experimental design. RESULTS: The in vitro drug release analysis revealed that release from the mPA6,10 layer was relatively linear with a burst release, which upon addition of sodium sulfate was reduced. Furthermore, formulations with higher quantities of mPA6,10 provided more controlled zero-order drug release and increased the matrix hardness. The addition of PEO to the s-PLGA layer significantly reduced the initial burst release that occurred when s-PLGA was used alone. CONCLUSIONS: The formulation with a lower s-PLGA:PEO ratio displayed superior zero-order release. Relatively, linear drug release was achieved from the middle-layer. The in vivo results proved the applicability of optimized TLT formulation in a therapeutic cardiovascular drug treatment regimen.