Review on Phase Synchronization Methods for Spaceborne Multistatic Synthetic Aperture Radar.

Multistatic synthetic aperture radar (SAR) is a special mode of SAR system. The radar transmitter and receiver are located on different satellites, which brings many advantages, such as flexible baseline configuration, diverse receiving modes, and more detailed ground object classification information. The multistatic SAR has been widely used in interferometry, moving target detection, three-dimensional imaging, and other fields. The frequency offset between different oscillators will cause a modulation phase error in the signal. Therefore, phase synchronization is one of the most critical problems to be addressed in distributed SAR systems. This article reviews phase synchronization techniques, which are mainly divided into two methods: synchronization by direct microwave link and synchronization by a data-based estimation algorithm. Furthermore, the future development of synchronization technology is anticipated.

Spatial Baseline Optimization for Spaceborne Multistatic SAR Tomography Systems.

Spaceborne multistatic synthetic aperture radar (SAR) tomography (SMS-TomoSAR) systems take full advantage of the flexible configuration of multistatic SAR in the space, time, phase, and frequency dimensions, and simultaneously achieve high-precision height resolution and low-deformation measurement of three-dimensional ground scenes. SMS-TomoSAR currently poses a series of key issues to solve, such as baseline optimization, spatial transmission error estimation and compensation, and the choice of imaging algorithm, which directly affects the performance of height-dimensional imaging and surface deformation measurement. This paper explores the impact of baseline distribution on height-dimensional imaging performance for the baseline optimization issue, and proposes a feasible baseline optimization method. Firstly, the multi-base multi-pass baselines of an SMS-TomoSAR system are considered equivalent to a group of multi-pass baselines from monostatic SAR. Secondly, we establish the equivalent baselines as a symmetric-geometric model to characterize the non-uniform characteristic of baseline distribution. Through experimental simulation and model analysis, an approximately uniform baseline distribution is shown to have better SMS-TomoSAR imaging performance in the height direction. Further, a baseline design method under uniform-perturbation sampling with Gaussian distribution error is proposed. Finally, the imaging performance of different levels of perturbation is compared, and the maximum baseline perturbation allowed by the system is given.