Plastic Shavings by Laser: Peeling Porous Graphene Springs for Multifunctional All-Carbon Applications.

Manufacturing strategies to create three-dimensional (3D) structures with multifunctional nanomaterials are of intense interest for fabricating building blocks in many electromechanical applications. A coil spring composed of graphene provides an important step toward the realization of all-carbon devices, as it is one of the essential elements for a wide range of systems. In this connection, here an unprecedented fabrication strategy to create a new type of 3D coil spring composed of laser-induced graphene springs (LIG-S) which is spontaneously produced via the pyrolytic jetting technique, is presented. Similar to wood or metal shavings observed in traditional machining processes, a pair of LIG-S with two opposite chiralities and controllable macroscopic dimensions is produced by a single scanning of a focused continuous-wave (CW) laser on a polyimide (PI) substrate. The resulting LIG-S, plastic shavings by laser, exhibits sufficient mechanical and electrical properties to enable many applications including strain-tolerant spring electrodes, antennas, supercapacitors, gas sensors, and luminescent filaments under extreme conditions. Without using any conventional fabrication techniques or other labor-intensive, time-consuming, and expensive processes, this novel approach enables a high-throughput mass production of macro-, micro-, and nanoscale featured LIG-S that can be manufactured within seconds to realize many open opportunities in all-carbon electromechanical systems.

From Chaos to Control: Programmable Crack Patterning with Molecular Order in Polymer Substrates.

Cracks are typically associated with the failure of materials. However, cracks can also be used to create periodic patterns on the surfaces of materials, as observed in the skin of crocodiles and elephants. In synthetic materials, surface patterns are critical to micro- and nanoscale fabrication processes. Here, a strategy is presented that enables freely programmable patterns of cracks on the surface of a polymer and then uses these cracks to pattern other materials. Cracks form during deposition of a thin film metal on a liquid crystal polymer network (LCN) and follow the spatially patterned molecular order of the polymer. These patterned sub-micrometer scale cracks have an order parameter of 0.98 ± 0.02 and form readily over centimeter-scale areas on the flexible substrates. The patterning of the LCN enables cracks that turn corners, spiral azimuthally, or radiate from a point. Conductive inks can be filled into these oriented cracks, resulting in flexible, anisotropic, and transparent conductors. This materials-based processing approach to patterning cracks enables unprecedented control of the orientation, length, width, and depth of the cracks without costly lithography methods. This approach promises new architectures of electronics, sensors, fluidics, optics, and other devices with micro- and nanoscale features.