Tailored intraoperative localization of non-palpable pulmonary lesions for thoracoscopic wedge resection using hybrid room technology.

INTRODUCTION: VATS wedge resection can require conversion to thoracotomy when pulmonary lesions cannot be identified. Hybrid operating rooms (HORs) provide real-time image acquisition capabilities allowing the intraoperative placement of markers to facilitate the removal of non-palpable nodules during VATS. OBJECTIVES: To present our workflow based on the alternative use of two different markers according to the location of the lung lesion and report our initial results. METHODS: All consecutive patients with non-palpable lesions requiring VATS wedge resection underwent localization of the targets in HOR. Lesions were considered non-palpable if they were small (<1 cm), deep (>1 cm from surface), subsolid, or located within a dystrophic area. Anesthetized patients were placed in lateral decubitus. Cone-beam CT (CBCT) was performed, and the needle trajectory was planned using Syngo iGuide Needle Guidance. Metal hook-wire or coil was placed, according to our workflow, close to the lesion and their position was verified by CBCT or fluoroscopy. RESULTS: Eleven VATS wedge resections were performed in 10 patients with 12 non-palpable lesions. The localization was performed with seven hook-wires and four coils in 30 minutes (range 17-56 minutes). The median estimated total effective dose was 11.6 mSv (range 1.9-24.7 mSv). Eleven lesions were removed by VATS, and one deep nodule required a thoracotomy. No complications were observed. CONCLUSIONS: Our experience confirms that HOR is suitable for simultaneous localization and VATS resection of 'difficult' pulmonary lesions. A versatile approach, using different devices, seems advisable for the removal of targets in every clinical scenario, reducing the VATS conversion rate.