Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 1 de 1
Filtrar
Mais filtros











Filtros aplicados
Intervalo de ano de publicação
1.
Campinas; s.n; 2009. 99 p. ilus.
Tese em Português | BBO - Odontologia | ID: biblio-865173

RESUMO

A interface entre tecido ósseo e implante tem sido muito estudada. A transmissão de tensões nesse local tem grande relevância no processo de osseointegração e depende, entre outros fatores, do tipo de carga, tecido ósseo de suporte, geometria do implante e propriedades mecânicas do implante e prótese. O propósito desta pesquisa foi analisar, pelo método dos elementos finitos, com análise bidimensional, a distribuição de tensões ocorridas na coroa protética, no pilar intermediário, no implante osseointegrável e nas estruturas de suporte, e determinar qual nível de inserção do implante apresenta melhor resposta biomecânica. Foi utilizado implante AR Morse, da empresa Conexão® - Sistemas de Prótese, formato rosqueável com 4,00mm de diâmetro por 10,0 mm de comprimento. O implante recebeu um pilar speed e sobre ele foi cimentada uma coroa metalocerâmica representando um dente 46. Foi aplicada uma carga de 100 N, distribuída pela superfície oclusal, em sentido axial e oblíquo. Constatou-se que houve maior tensão nas solicitações oclusais que envolviam carga oblíqua para os conjuntos avaliados. A distribuição das tensões no tecido ósseo não diferiu significativamente para os três níveis de inserção do implante quando se incidiu apenas carga axial, entretanto quando sujeito a ação de forças oblíquas, o nível do implante sub-crestal gerou tensões mais elevadas que o nível do implante supra-crestal, que gerou tensões mais elevadas que a posição do implante ao nível da crista óssea.


The interface between bone tissue and implant has been much studied. The conduction of stresses this site have great relevance in the osseointegration and depends, among other factors, the type of load, the supporting bone, the implant geometry and mechanical properties of the implant and prosthesis. The purpose of this research was to analyze out through the finites elements method, with two-dimensional analysis, the distribution of stress that took place on prosthetic crown, the intermediate abutment, the osseointegrated implant and at the supporting structures, and to determine which attachment level from implant shows better biomechanical response. The AR Morse implant (Conexão trademark - Prosthesis Systems; screw shape, 4.0mm in diameter and 10.0mm in lenght) was used in this study. The speed abutment was inserted into implant and over it a metal-ceramic crown was cemented, representing a tooth 46. Axial and oblique loads of 100N were applied, which were distributed through occlusal surface. It was found out that there was higher stress on occlusal requests involving oblique load for the assessed sets. The stress distribution on bone tissue not differed significantly for the three implant attachment levels when only one load was applied, however, when subjected to oblique loads, the level of implant below the beak bone generated more increased stresses than the level of implant above the bone crest, what generated more increased stresses than the position of implant at the bone crest.


Assuntos
Elementos Químicos , Resistência à Tração , Implantes Dentários
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA