RESUMO
The design is described of a thin-layer contactless conductivity detector suitable for liquid chromatography and flow-injection analysis. Its principal analytical parameters have been determined using a potassium chloride solution: the linear dynamic range extends from 7.5 x 10(-6) to 1.5 x 10(-2) S m(-1), corresponding to the KCl concentration range from 0.5 to 1000 microM, the limit of detection equals 3.5 x 10(-6) S m(-1) (0.2 microM KCl), the detection repeatability, expressed in terms of the relative standard deviation, amounts to 1.13% and the detection volume is 0.6 microL. The detector was applied to detection of ionic compounds, benzoic, lactic and octanesulfonic acids, and sodium capronate, after their separation by liquid chromatography in a Biospher PSI 100C 18 columns using a 60% aqueous acetonitrile mobile phase. The frequency characteristics of the detector are reasonably theoretically described on the basis of a simple model which is commonly used in the field of contactless impedance detectors.
RESUMO
Three groups of structurally diverse chiral compounds were used to study the interaction mechanism responsible for stereoselective recognition with teicoplanin as chiral selector in capillary liquid chromatography. Teicoplanin-based chiral stationary phase (CSP) was used. The effect of the variation of mobile phase composition on retention and enantioselective separation was studied. The mobile phase composition suitable for enantioresolution of the various chiral compounds differed according to the interaction forces needed for chiral recognition. Mobile phases with high buffer portion (70-90 vol.%) were preferred for separation of enantiomers of profen non-steroidal anti-inflammatory drugs and chlorophenoxypropionic acid herbicides that require hydrophobic interactions, inclusion and pi-pi interactions for stereoselective recognition with teicoplanin. Higher concentration triethylamine in the buffer (0.5-1.0%) increased resolution of these acids. On the other hand, H-bonding and electrostatic interactions are important in stereoselective interaction mechanism of beta-adrenergic antagonists with teicoplanin. These interaction types predominate in the reversed phase separation mode with high organic modifier content (95% methanol) and in polar organic mobile phases. For this reason beta-adrenergic antagonists were best enantioresolved in the polar organic mode. The mobile phase composed of methanol/acetic acid/triethylamine, 100/0.01/0.01 (v/v/v), provided enantioresolution values of all the studied beta-adrenergic antagonists in the range 1.1-1.9. Addition of teicoplanin to the mobile phase, which was suitable for enantioseparation of certain compounds on the CSP, was also investigated. This system was used to dispose of nonstereoselective interactions of analytes with silica gel support that often participate in the interaction with CSPs. Very low concentration of teicoplanin in the mobile phase (0.1 mM) resulted in enantioselective separation of 2,2- and 2,4-chlorophenoxypropionic acids.
Assuntos
Antagonistas Adrenérgicos beta/isolamento & purificação , Anti-Inflamatórios não Esteroides/isolamento & purificação , Cromatografia Líquida/métodos , Herbicidas/isolamento & purificação , Teicoplanina/química , Antagonistas Adrenérgicos beta/química , Anti-Inflamatórios não Esteroides/química , Herbicidas/química , Ligação de Hidrogênio , Espectrofotometria Ultravioleta , Eletricidade Estática , EstereoisomerismoRESUMO
A mathematical and computational model is introduced for optimization of background electrolyte systems for capillary zone electrophoresis of anions. The model takes into account mono- or di- or trivalent ions and allows also for modeling of highly acidic or alkaline electrolytes, where a presence of hydrogen and hydroxide ions is significant. At maximum, the electrolyte can contain two co-anions and two counter-cations. The mathematical relations of the model are formulated to enable an easy algorithmization and programming in a computer language. The model assesses the composition of the background electrolyte in the analyte zone, which enables prediction of the parameters of the system that are experimentally available, like the transfer ratio, which is a measure of the sensitivity in the indirect photometric detection or the molar conductivity detection response, which expresses the sensitivity of the conductivity detection. Furthermore, the model also enables the evaluation of a tendency of the analyte to undergo electromigration dispersion and allows the optimization of the composition of the background electrolyte to reach a good sensitivity of detection while still having the dispersion properties in the acceptable range. Although the model presented is aimed towards the separation of anions, it can be straightforwardly rearranged to serve for simulation of electromigration of cationic analytes. The suitability of the model is checked by inspecting the behavior of a phosphate buffer for analysis of anions. It is shown that parameters of the phosphate buffer when used at neutral and alkaline pH values possess singularities that indicate a possible occurrence of system peaks. Moreover, if the mobility of any analyte of the sample is close to the mobilities of the system peaks, the indirect detector signals following the background electrolyte properties will be heavily amplified and distorted. When a specific detector sensitive on presence of the analyte were used, the signal would be almost lost due to the excessive dispersion of the peak.
Assuntos
Eletrólitos , Eletroforese Capilar/métodos , Modelos QuímicosRESUMO
A simple and general method suitable for the determination of cyclodextrin content in various matrices is described. The proposed method involves selective cleavage of C-C bonds with vicinal hydroxyl groups by means of periodate (Malaprade's reaction). The amount of produced iodate is monitored by capillary electrophoresis. Optimized electrophoretic conditions (20 mM disodium tetraborate with 1 mM tetradecyltrimethylammonium bromide, direct UV detection lambda = 200 nm) ensure complete separation of periodate and iodate ions and sufficient sensitivity towards iodate. Under optimized reaction conditions (2-fold excess of periodate, temperature 70 degrees C) reproducible quantitative results were obtained for alpha-, beta- and gamma-cyclodextrins as model samples. The proposed method was tested on a real sample of acrylamide--2'-O-allyl-beta-CD copolymer. The values of beta-cyclodextrin content were compared with those obtained by reference NMR measurement and were found to be identical.
Assuntos
Ciclodextrinas/análise , Eletroforese Capilar/métodos , Ácido Periódico/química , Espectroscopia de Ressonância Magnética , Oxirredução , Reprodutibilidade dos Testes , Espectrofotometria UltravioletaRESUMO
Ropinirole, 4-[2-(dipropylamino)ethyl]-1,3-dihydro-2H-indol-2-one, is a potent anti-Parkinson's disease drug developed by SmithKline Beecham Pharmaceuticals. Capillary liquid chromatography (CLC) was used for the separation and quantification of ropinirole and its five related impurities, potentially formed during its synthesis. A simultaneous optimization of three mobile phase parameters, i.e., pH, buffer concentration and acetonitrile content was performed employing an experimental design approach which proved a powerful tool in method development. The retention factors of the investigated substances in different mobile phases were determined. Baseline resolution of the six substances on a C18 reversed stationary phase was attained using a mobile phase with an optimized composition [acetonitrile-8.7 mM 2-(N-morpholino)ethanesulfonic acid adjusted to pH 6.0 (55:45, v/v)]. It was shown that CLC, operated in the isocratic mode under the mobile phase flow-rate of 4 microl/min, can determine the level of these impurities, down to a level of 0.06% of the main component within 25 min.
Assuntos
Antiparkinsonianos/isolamento & purificação , Cromatografia Líquida/métodos , Indóis/isolamento & purificação , Antiparkinsonianos/química , Contaminação de Medicamentos , Concentração de Íons de Hidrogênio , Indóis/químicaRESUMO
A sensitive capillary electrophoretic method was developed for the determination of thiodiglycolic acid (TDA) in urine which avoids the pretreatment of the urine sample. Several carrier electrolytes were examined. The most suitable carrier electrolyte system consisted of potassium hydrogen phthalate (5 mM), 2-(N-morpholino)ethanesulfonic acid (50 mM) and tetradecyltrimethylammonium bromide (0.5 mM), pH 5.2. Ten times diluted fresh midstream void urine was used for the determination. In this way, the concentrations of TDA between 5 and 50 mg/l in undiluted urine samples can be determined.
Assuntos
Eletroforese Capilar/métodos , Tioglicolatos/urina , Soluções Tampão , Calibragem , Humanos , Espectrofotometria UltravioletaRESUMO
Ropinirole, 4-[2-(dipropylamino)ethyl]-1,3-dihydro-2H-indol-2-one, is a potent anti-Parkinson's disease drug developed by SmithKline Beecham Pharmaceuticals. Capillary zone electrophoresis (CZE) was used for the determination of the dissociation constants of ropinirole and five structurally related impurities, potentially formed during its synthesis and for separation and quantification of these substances. The dissociation constants obtained from the CZE measurements were confirmed by UV spectrophotometry for some of the test compounds, obtaining a good agreement between the values. Careful optimization of the running buffer composition permitted base-line resolution of the six compounds in a borate buffer containing acetonitrile and magnesium sulfate (a 100 mM borate buffer containing 30 mM MgSO4 and 20 vol.% of acetonitrile). It was shown that CZE can determine the level of these impurities, down to a level of 0.05% of the main component within 15 min.