Removal of beta-lactam antibiotic in water environment by adsorption technique using cationic surfactant functionalized nanosilica rice husk.

This study aims to investigate the adsorption characteristics of cationic surfactant, cetyltrimethylamonium bromide (CTAB) onto negatively nanosilica rice husk surface and the application for antibiotic treatment in water environment. Adsorption of CTAB onto nanosilica increased with an increase of solution pH, due to an enhancement of the electrostatic attraction between cationic methylamomethylamonium groups and negatively charged nanosilica surface enhanced at higher pH. Adsorption of CTAB decreased with a decrease of ionic strength while a common intersection point (CIP) was observed for adsorption isotherm at different ionic strengths, suggesting that hydrophobic interactions between alkyl chains in CTAB molecules significantly induced adsorption and admicelles with bilayer formation were dominant than monolayer of hemimicelles. The CTAB functionalized nanosilica (CFNS) was applied for removal of beta-lactam amoxicillin (AMX). The best conditions for AMX treatment using CFNS were selected as pH 10, contact time 60 min and CFNS dosage 10 mg/mL. Removal efficiency of AMX using CFNS reached to 100% under optimum conditions while it was only 25.01% using nanosilica without CTAB. The maximum AMX adsorption capacity using CFNS of about 25 mg/g was much higher than other adsorbents. The effects of different organics such as humic acid, anionic surfactant, and other antibiotics on AMX removal using CFNS were also studied. A two-step model can fit CTAB uptake isotherms onto nanosilica and AMX onto CFNS well at different KCl concentrations. Based on the desorption of CTAB with AMX adsorption as well as adsorption isotherms, the change in surface charge and functional vibration groups after adsorption, we indicate that AMX adsorption onto CFNS was mainly controlled by electrostatic interaction. We reveal that CFNS is an excellent adsorbent for antibiotic treatment from aqueous solution.

Separation and determination of alkyl sulfate surfactants in wastewater by capillary electrophoresis coupled with contactless conductivity detection after preconcentration by simultaneous adsorption using alumina beads.

The aim of the present study is to determine four anionic alkyl sulfate (AS) surfactants with different alkyl chains, namely, C8, C10, C12, and C14, in wastewater by CE with capacitively coupled contactless conductivity detection (CE-C4 D). The conditions effective for the separation of the four AS surfactants were systematically optimized and found to be in a Tris-His (50 mM/20 mM) BGE solution at a pH of 8.95, using a separation voltage of +15 kV, hydrodynamic injection by siphoning using a 20 cm injection height and an injection time of 20 s. The LODs for C8, C10, C12, and C14 were 2.58, 2.30, 2.08, and 3.16 mg/L, respectively. The conditions used to achieve the simultaneous adsorption and preconcentration of the AS surfactants using Al2 O3 beads were pH of 3 and 0.1 mM NaCl. The adsorption efficiencies were found to be 45.6, 50.8, 81.7, and 99.9%, while the desorption efficiencies reached 66.1, 70.4, 83.9, and 100.0% for C8, C10, C12, and C14, respectively. The concentrations of the AS surfactants in wastewater samples were quantified by CE-C4 D after preconcentration by simultaneous adsorption using Al2 O3 beads. The results obtained from the proposed method were consistent with those obtained by HPLC-MS/MS, with a deviation of less than 15%. Our results indicate that the CE-C4 D performed after preconcentration by an adsorption technique using Al2 O3 beads is a new, inexpensive, and suitable method for quantifying AS surfactants in wastewater samples.

Low-cost and versatile analytical tool with purpose-made capillary electrophoresis coupled to contactless conductivity detection: Application to antibiotics quality control in Vietnam.

In this study, the development of our purpose-made capacitively coupled contactless conductivity detection (C4 D) for CE is reported. These systems have been employed as a simple, versatile, and cost-effective analytical tool. CE-C4 D devices, whose principle is based on the control of the ion movements under an electrical field, can be constructed even with a modest financial budget and limited infrastructure. A featured application was developed for quality control of antimicrobial drugs using CE-C4 D, with most recent work on determination of aminoglycoside and glycopeptide antibiotics being communicated. For aminoglycosides, the development of CE-C4 D methods was adapted to two categories. The first one includes drugs (liquid or powder form) for intravenous injection, containing either amikacin, streptomycin, kanamycin A, or kanamycin B. The second one covers drugs for eye drops (liquid or ointment form), containing either neomycin, tobramycin, or polymyxin. The CE-C4 D method development was also made for determination of some popular glycopeptide antibiotics in Vietnam, including vancomycin and teicoplanin. The best detection limit achieved using the developed CE-C4 D methods was 0.5 mg/L. Good agreement between results from CE-C4 D and the confirmation method (HPLC- Photometric Diode Array ) was achieved, with their result deviations less than 8% and 13% for aminoglycoside and glycopeptide antibiotics, respectively.

Screening determination of four amphetamine-type drugs in street-grade illegal tablets and urine samples by portable capillary electrophoresis with contactless conductivity detection.

A simple and inexpensive method for the identification of four substituted amphetamines, namely, 3,4-methylenedioxy methamphetamine (MDMA), methamphetamine (MA), 3,4-methylenedioxy amphetamine (MDA) and 3,4-methylenedioxy-N-ethylamphetamine (MDEA) was developed using an in-house constructed semi-automated portable capillary electrophoresis instrument (CE) with capacitively coupled contactless conductivity detection (C(4)D). Arginine 10mM adjusted to pH4.5 with acetic acid was found to be the optimal background electrolyte for the CE-C(4)D determination of these compounds. The best detection limits achieved with and without a sample preconcentration process were 10ppb and 500ppb, respectively. Substituted amphetamines were found in different seized illicit club drug tablets and urine samples collected from different suspected users. Good agreement between results from CE-C(4)D and those with the confirmation method (GC-MS) was achieved, with correlation coefficients for the two pairs of data of more than 0.99.

Green Analytical Method for Simultaneous Determination of Glucosamine and Calcium in Dietary Supplements by Capillary Electrophoresis with Capacitively Coupled Contactless Conductivity Detection.

The need for analytical methods that are fast, affordable, and ecologically friendly is expanding. Because of its low solvent consumption, minimal waste production, and speedy analysis, capillary electrophoresis is considered a "green" choice among analytical separation methods. With these "green" features, we have utilized the capillary electrophoresis method with capacitively coupled contactless conductivity detection (CE-C4D) to simultaneously determine glucosamine and Ca2+ in dietary supplements. The CE analysis was performed in fused silica capillaries (50 µm inner diameter, 40 cm total length, 30 cm effective length), and the analytical time was around 5 min. After optimization, the CE conditions for selective determination of glucosamine and Ca2+ were obtained, including a 10 mM tris (hydroxymethyl) aminomethane/acetic acid (Tris/Ace) buffer of pH 5.0 as the background electrolyte; separation voltage of 20 kV; and hydrodynamic injection (siphoning) at 25 cm height for 30 s. The method illustrated good linearity over the concentration range of 5.00 to 200 mg/L of for glucosamine (R 2 = 0.9994) and 1.00 to 100 mg/L for Ca2+ (R 2 = 0.9994). Under the optimum conditions, the detection limit of glucosamine was 1.00 mg/L, while that of Ca2+ was 0.05 mg/L. The validated method successfully analyzed glucosamine and Ca2+ in seven dietary supplement samples. The measured concentrations were generally in line with the values of label claims and with cross-checking data from reference methods (HPLC and ICP-OES).

Antibiotics in surface water of East and Southeast Asian countries: A focused review on contamination status, pollution sources, potential risks, and future perspectives.

This review provides focused insights into the contamination status, sources, and ecological risks associated with multiple classes of antibiotics in surface water from the East and Southeast Asia based on publications over the period 2007 to 2020. Antibiotics are ubiquitous in surface water of these countries with concentrations ranging from <1 ng/L to hundreds µg/L and median values from 10 to 100 ng/L. Wider ranges and higher maximum concentrations of certain antibiotics were found in surface water of the East Asian countries like China and South Korea than in the Southeast Asian nations. Environmental behavior and fate of antibiotics in surface water is discussed. The reviewed occurrence of antibiotics in their sources suggests that effluent from wastewater treatment plants, wastewater from aquaculture and livestock production activities, and untreated urban sewage are principal sources of antibiotics in surface water. Ecological risks associated with antibiotic residues were estimated for aquatic organisms and the prevalence of antibiotic resistance genes and antibiotic-resistant bacteria were reviewed. Such findings underline the need for synergistic efforts from scientists, engineers, policy makers, government managers, entrepreneurs, and communities to manage and reduce the burden of antibiotics and antibiotic resistance in water bodies of East and Southeast Asian countries.

Determination of carbapenem antibiotics using a purpose-made capillary electrophoresis instrument with contactless conductivity detection.

In this study, the employment of a purpose-made capillary electrophoresis (CE) instrument with capacitively coupled contactless conductivity detection (C4D) as a simple and cost-effective approach for simultaneous determination of different carbapenem antibiotics is reported. The developed CE-C4D approach was for the first time applied for quality control of various pharmaceutical formulations in Vietnam, as well as for therapeutic monitoring of these antibiotics in plasma samples from patients under intensive care. Four of the most popular carbapenems in Vietnam, doripenem, meropenem, imipenem and ertapenem, were determined using an electrolyte composed of 10 mM Tris adjusted to pH 8.0 with acetic acid. The best detection limits achieved using the developed CE-C4D method were 0.36 mg/L and 0.45 mg/L for pharmaceutical and plasma samples, respectively. Good agreement between results from CE-C4D and the confirmation method (HPLC-PDA) was achieved, with a coefficient of determination (r2) for the two pairs of data of 0.9967.

Cost-effective capillary electrophoresis with contactless conductivity detection for quality control of beta-lactam antibiotics.

A simple and inexpensive approach for determination of various antimicrobial drugs using a purpose-made compact capillary electrophoresis (CE) instrument with capacitively coupled contactless conductivity detection (C4D) is reported. The objective of the work is to propose an affordable and easily-implemented tool for quality control and detection of counterfeiting of antibiotic formulations in resource constrained developing countries. The design of the purpose-made CE-C4D system was improved according to the feedback from over 10 years of use of our previous instrument. CE-C4D methods were for the first time developed to analyze ß-lactam-based antibiotics commonly used in Vietnam, including single- ß-lactam antibiotics (i.e. Cephalexin, Cefotaxime Sodium, Cefixime and Sulbactam) as well as ß-lactams co-formulated with Sulbactam (i.e. Amoxicillin, Ampicillin, Cefoperazone and Sulbactam). Single ß-lactam antibiotics were analyzed using a background electrolyte (BGE) composed of Tris/Ace (10 mM, pH 7.8) whereas ß-lactam - Sulbactam combinations were simultaneously separated using a BGE containing Tris/Ace (10 mM, pH 7.5). The best achieved detection limits were 2.0 mg/L and 1.0 mg/L for these two groups, respectively. Good agreement between results obtained from CE-C4D and standard confirmation methods (LCMS) was achieved, with a coefficient of determination, r2, of 0.9991. The applicability of the developed CE-C4D method was demonstrated for quality control of 24 ß-lactam-based antimicrobial drugs available in Vietnam.

Simple semi-automated portable capillary electrophoresis instrument with contactless conductivity detection for the determination of ß-agonists in pharmaceutical and pig-feed samples.

An inexpensive, robust and easy to use portable capillary electrophoresis instrument with miniaturized high-voltage capacitively coupled contactless conductivity detection was developed. The system utilizes pneumatic operation to manipulate the solutions for all flushing steps. The different operations, i.e. capillary flushing, interface rinsing, and electrophoretic separation, are easily activated by turning an electronic switch. To allow the analysis of samples with limited available volume, and to render the construction less complicated compared to a computer-controlled counterpart, sample injection is carried out hydrodynamically directly from the sample vial into the capillary by manual syphoning. The system is a well performing solution where the financial means for the highly expensive commercial instruments are not available and where the in-house construction of a sophisticated automated instrument is not possible due to limited mechanical and electronic workshop facilities and software programming expertise. For demonstration, the system was employed successfully for the determination of some ß-agonists, namely salbutamol, metoprolol and ractopamine down to 0.7ppm in pharmaceutical and pig-feed sample matrices in Vietnam.