Effect of Extrinsic Disorder on the Magnetoresistance Response of Gated Single-Layer Graphene Devices.

Analogous to the case of classical metal oxide semiconductor field-effect transistors, transport properties of graphene-based devices are determined by scattering from adventitious charged impurities that are invariably present. The presence of charged impurities renders experimental graphene samples "extrinsic" in that their electrical performances also depend on the environment in which graphene operates. While the role of such an extrinsic disorder component has been studied for conventional charge transport in graphene, its impact on the magnetotransport remains unexplored. Here, we show that single-layer graphene transistors with a low density of extrinsic disorder feature a larger magnetoresistance (MR) than those with a high density. Importantly, in gated single-layer devices with a low density of charged impurities, we find that MR peaks at gate voltage values far from the charge neutrality point not only at a low temperature but also at room temperature; in particular, MR approaches 800% at room temperature and 1400% at 50 K in such devices. In addition, dynamic measurements of MR on devices with a low degree of extrinsic disorder lead to stable and reliable single-layer graphene magnetosensors endowed with an ultralow power consumption of 2.5 nW. Our work indicates that the initial value of the minimum conductivity σ0 at room temperature along with carrier mobility must be looked at to select the most promising devices for magnetosensing.

Homogeneous 2D MoTe2 p-n Junctions and CMOS Inverters formed by Atomic-Layer-Deposition-Induced Doping.

Recently, α-MoTe2 , a 2D transition-metal dichalcogenide (TMD), has shown outstanding properties, aiming at future electronic devices. Such TMD structures without surface dangling bonds make the 2D α-MoTe2 a more favorable candidate than conventional 3D Si on the scale of a few nanometers. The bandgap of thin α-MoTe2 appears close to that of Si and is quite smaller than those of other typical TMD semiconductors. Even though there have been a few attempts to control the charge-carrier polarity of MoTe2 , functional devices such as p-n junction or complementary metal-oxide-semiconductor (CMOS) inverters have not been reported. Here, we demonstrate a 2D CMOS inverter and p-n junction diode in a single α-MoTe2 nanosheet by a straightforward selective doping technique. In a single α-MoTe2 flake, an initially p-doped channel is selectively converted to an n-doped region with high electron mobility of 18 cm2 V-1 s-1 by atomic-layer-deposition-induced H-doping. The ultrathin CMOS inverter exhibits a high DC voltage gain of 29, an AC gain of 18 at 1 kHz, and a low static power consumption of a few nanowatts. The results show a great potential of α-MoTe2 for future electronic devices based on 2D semiconducting materials.

Electric and Photovoltaic Behavior of a Few-Layer α-MoTe2 /MoS2 Dichalcogenide Heterojunction.

Mo-based van der Waals heterojunction p-n diodes with p-type α-MoTe2 and n-type MoS2 are fabricated on glass, and demonstrate excellent static and dynamic device performances at a low voltage of 5 V, with an ON/OFF current ratio higher than 10(3) , ideality factors of 1.06, dynamic rectification at a high frequency of 1 kHz, high photoresponsivity of 322 mA W(-1) , and an external quantum efficiency of 85% under blue-light illumination.

Static and Dynamic Performance of Complementary Inverters Based on Nanosheet α-MoTe2 p-Channel and MoS2 n-Channel Transistors.

Molybdenum ditelluride (α-MoTe2) is an emerging transition-metal dichalcogenide (TMD) semiconductor that has been attracting attention due to its favorable optical and electronic properties. Field-effect transistors (FETs) based on few-layer α-MoTe2 nanosheets have previously shown ambipolar behavior with strong p-type and weak n-type conduction. We have employed a direct imprinting technique following mechanical nanosheet exfoliation to fabricate high-performance complementary inverters using α-MoTe2 as the semiconductor for the p-channel FETs and MoS2 as the semiconductor for the n-channel FETs. To avoid ambipolar behavior and produce α-MoTe2 FETs with clean p-channel characteristics, we have employed the high-workfunction metal platinum for the source and drain contacts. As a result, our α-MoTe2 nanosheet p-channel FETs show hole mobilities up to 20 cm(2)/(V s), on/off ratios up to 10(5), and a subthreshold slope of 255 mV/decade. For our complementary inverters composed of few-layer α-MoTe2 p-channel FETs and MoS2 n-channel FETs we have obtained voltage gains as high as 33, noise margins as high as 0.38 VDD, a switching delay of 25 µs, and a static power consumption of a few nanowatts.

Low Power Consumption Complementary Inverters with n-MoS2 and p-WSe2 Dichalcogenide Nanosheets on Glass for Logic and Light-Emitting Diode Circuits.

Two-dimensional (2D) semiconductor materials with discrete bandgap become important because of their interesting physical properties and potentials toward future nanoscale electronics. Many 2D-based field effect transistors (FETs) have thus been reported. Several attempts to fabricate 2D complementary (CMOS) logic inverters have been made too. However, those CMOS devices seldom showed the most important advantage of typical CMOS: low power consumption. Here, we adopted p-WSe2 and n-MoS2 nanosheets separately for the channels of bottom-gate-patterned FETs, to fabricate 2D dichalcogenide-based hetero-CMOS inverters on the same glass substrate. Our hetero-CMOS inverters with electrically isolated FETs demonstrate novel and superior device performances of a maximum voltage gain as ∼27, sub-nanowatt power consumption, almost ideal noise margin approaching 0.5VDD (supply voltage, VDD=5 V) with a transition voltage of 2.3 V, and ∼800 µs for switching delay. Moreover, our glass-substrate CMOS device nicely performed digital logic (NOT, OR, and AND) and push-pull circuits for organic light-emitting diode switching, directly displaying the prospective of practical applications.

High-gain subnanowatt power consumption hybrid complementary logic inverter with WSe2 nanosheet and ZnO nanowire transistors on glass.

A 1D-2D hybrid complementary logic inverter comprising of ZnO nanowire and WSe2 nanosheet field-effect transistors (FETs) is fabricated on glass, which shows excellent static and dynamic electrical performances with a voltage gain of ≈60, sub-nanowatt power consumption, and at least 1 kHz inverting speed.

Trap density probing on top-gate MoS2 nanosheet field-effect transistors by photo-excited charge collection spectroscopy.

Two-dimensional (2D) molybdenum disulfide (MoS2) field-effect transistors (FETs) have been extensively studied, but most of the FETs with gate insulators have displayed negative threshold voltage values, which indicates the presence of interfacial traps both shallow and deep in energy level. Despite such interface trap issues, reports on trap densities in MoS2 are quite limited. Here, we probed top-gate MoS2 FETs with two- (2L), three- (3L), and four-layer (4L) MoS2/dielectric interfaces to quantify deep-level interface trap densities by photo-excited charge collection spectroscopy (PECCS), and reported the result that deep-level trap densities over 10(12) cm(-2) may exist in the interface and bulk MoS2 near the interface. Transfer curve hysteresis and PECCS measurements show that shallow traps and deep traps are not that different in density order from each other. We conclude that our PECCS analysis distinguishably provides valuable information on deep level interface/bulk trap densities in 2D-based FETs.

Molybdenum disulfide nanoflake-zinc oxide nanowire hybrid photoinverter.

We demonstrate a hybrid inverter-type nanodevice composed of a MoS2 nanoflake field-effect transistor (FET) and ZnO nanowire Schottky diode on one substrate, aiming at a one-dimensional (1D)-two-dimensional (2D) hybrid integrated electronic circuit with multifunctional capacities of low power consumption, high gain, and photodetection. In the present work, we used a nanotransfer printing method using polydimethylsiloxane for the fabrication of patterned bottom-gate MoS2 nanoflake FETs, so that they could be placed near the ZnO nanowire Schottky diodes that were initially fabricated. The ZnO nanowire Schottky diode and MoS2 FET worked respectively as load and driver for a logic inverter, which exhibits a high voltage gain of ∼50 at a supply voltage of 5 V and also shows a low power consumption of less than 50 nW. Moreover, our inverter effectively operates as a photoinverter, detecting visible photons, since MoS2 FETs appear very photosensitive, while the serially connected ZnO nanowire Schottky diode was blind to visible light. Our 1D-2D hybrid nanoinverter would be quite promising for both logic and photosensing applications due to its performance and simple device configuration as well.