Influence of back mixing on the convective drying of residual sludges in a fixed bed.

The influence of a backmixing operation on the convective belt drying of two wastewater sludges was studied. The expansion of the sludge extrudates bed due to increasing additions of dry product was quantified by using X-ray tomography. This non-invasive technique was used to determine the bed porosity and the total exchange area available for heat and mass transfers, for increasing levels of backmixing. For a same drying flux, the expansion of the drying bed leads to higher drying rates, allowing a reduction of the total drying time. In this context, rheological properties of the sludges are key properties.

Structure-activity relationships in the beta-lactam family: an impossible dream.

The difficulty of establishing structure-activity relationships in the beta-lactam family of antibiotics stems from the fact that: (1) The targets in various bacteria exhibit widely different sensitivities. (2) Some bacteria produce beta-lactamases, enzymes capable of destroying the antibiotics. The rates of the reactions with the beta-lactamases and the target enzymes are not necessarily related. (3) In Gram-negative bacteria, the diffusion rate through the outer membrane varies independently from the two other factors.

Quantitative relationship between sensitivity to beta-lactam antibiotics and beta-lactamase production in gram-negative bacteria--II. Non-steady-state treatment and progress curves.

A non-steady-state model is discussed for the study of the interplay between beta-lactamase activity and outer membrane permeability with slowly hydrolysed beta-lactams. The analysis shows: (1) that the simple, steady-state model presented in the accompanying paper remains valid as long as kcat (i.e. k3 with chromosome-encoded class C beta-lactamases) is larger than 10(-3)/sec (generation time = 20 min or more); (2) that among the beta-lactam antibiotics studied here, the complete, non-steady-state model needs only be used in the case of aztreonam; (3) that the term "trapping" should be replaced by "formation of a covalent acyl-enzyme" and that such a phenomenon only contributes significantly to the resistance when penetration and hydrolysis are very slow and the periplasmic beta-lactamase concentration is very high. Aztreonam seems to be the only compound which fulfils the first two conditions.

Wastewater sludge convective drying: influence of sludge origin.

This paper deals with thermal drying of wastewater sludges, whose management will become crucial in the forthcoming years. Sludges collected after mechanical dewatering in 5 different WWTPs are submitted to the same convective drying treatment in order to try finding some relations between the drying behaviours, the type of effluent and wastewater treatments. Results show dearly sludge drying remains a particularly complex operation because sludges may exhibit very different behaviours, both from kinetic and texture points of view. Initial moisture content and global composition are not sufficient to explain the different observed behaviours. It is too early to claim one or another type of water treatment has an influence on the drying behaviour. However, the drying rates can be classified in the inverse order of the organic content. Moreover for sludges at the same siccities, the harder the material (rheological properties), the higher the drying rate. Final textural properties can be related to the rheological properties and the internal diffusion limitations lowering the drying intensity.

[Risk of contamination by hepatitis C of endoscopes utilized in gastroenterology hospital service]. / Risques de contamination par le virus de l'hépatite C des endoscopes utilisés dans un service hospitalier de gastroentérologie.

UNLABELLED: Transmission of hepatitis C virus by gastrointestinal endoscopy has been suggested especially therapeutic procedures. The aim of this study was to investigate the frequency of contamination of the endoscopes by hepatitis C virus and to assess the efficacy of a semi-automatic disinfection procedure. METHODS: In 19 patients with chronic replicative hepatitis C, upper gastrointestinal endoscopy with different invasive procedures was performed. Cleaning and disinfection were carried out according to the recommendation of the belgian "Conseil Supérieur de l'Hygiène": cleaning with detergent solution, rinsing, disinfection with a disinfectant solution for 10 minutes and again rinsing. Before the procedure (T0), a blood sample was collected to detect the presence of hepatitis C virus RNA. Immediately after the endoscopic procedure, the operating channel of the endoscope was flushed with water and was sterilely collected (T1); after cleaning (T2) and after disinfection (T3, T3EC), the same procedure was repeated. The collected samples were analysed by PCR in order to detect hepatitis C virus RNA. RESULTS: All the samples were positive at T0. Virus C RNA was found in 10 out the 19 patients at T1 (53%). The results were negative in all the samples both after cleaning (T2) and disinfection (T3-T3 EC). CONCLUSIONS: Our study confirmed the presence of hepatitis C virus in the operating channel after invasive upper gastrointestinal endoscopy. The contamination rate of the endoscope is high. Our cleaning and disinfection procedure seems to be effective in regard of hepatitis C virus RNA clearance.

Non-destructive characterization of deer (Cervus Elaphus) antlers by X-ray microtomography coupled with image analysis.

X-ray microtomography coupled with image analysis was tested as a non-destructive alternative method for the textural characterization of the trabecular part of deer antlers (Cervus Elaphus). As gas adsorption and mercury intrusion cannot be applied on this soft and spongy material, its pore texture was, up to now, determined from histological sections that give only two-dimensional information. In this work, X-ray microtomography is used to scan entire or half pieces of antlers and three-dimensional image analysis is performed in order to assess the differences between samples collected at various antler locations. Results clearly show a porosity profile along the sample diameter. The pore size distribution is showed to be dependent on the sample original site.

Image analysis of X-ray microtomograms of soft materials during convective drying: 3D measurements.

Drying dewatered sludge leads to a complex three-dimensional porous structure. Moreover, this operation is dependent on the way the material is processed. In this study, textural changes of sludge extrudates submitted to convective drying are followed by a 3D image analysis of reconstructed X-ray microtomograms. To achieve this goal, two different wastewater sludges collected in wastewater treatment plant after the thickening step and dewatered in the laboratory are used. It is showed that the evolution of the 3D-crack ratio vs. the residual water content evolves following a hyperbolic law. The 3D opening crack size distribution reveals two different types of pore development, i.e. a continuous pore size evolution for one sludge and the sudden appearance of cracks for the other sludge.

Image analysis of X-ray microtomograms of soft materials during convective drying.

X-ray microtomography is used to explore the textural evolution that soft materials undergo during a drying treatment. An original image processing algorithm is applied to vertical projections and reconstructed cross-section images in order to quantify the texture at different stages of drying. Measurements are performed both on grey-level and on binary images. It is shown that X-ray microtomography is a very promising tool in the field of drying investigations. It can be used to determine internal moisture profiles, and to follow crack development and shrinkage in an accurate and non-destructive way. This information is crucial to validate drying models. Waste-water sludges are used as test materials to assess the validity of the proposed methodology. The management of these sludges, often including a drying stage, will become a challenge in the forthcoming years in accordance with environmental regulations. Samples collected in two waste-water treatment plants are investigated. Their analysis by X-ray microtomography brings to the fore two different drying behaviours, illustrating that sludge drying is a complex unit operation very sensitive to the way the material is produced.

Saturation of penicillin-binding protein 1 by beta-lactam antibiotics in growing cells of Bacillus licheniformis.

With the help of a new highly sensitive method allowing the quantification of free penicillin-binding proteins (PBPs) and of an integrated mathematical model, the progressive saturation of PBP1 by various beta-lactam antibiotics in growing cells of Bacillus licheniformis was studied. Although the results confirmed PBP1 as a major lethal target for these compounds, they also underlined several weaknesses in our present understanding of this phenomenon. In growing cells, but not in resting cells, the penicillin target(s) appeared to be somewhat protected from the action of the inactivators. In vitro experiments indicated that amino acids, peptides and depsipeptides mimicking the peptide moiety of the nascent peptidoglycan significantly interfered with the acylation of PBP1 by the antibiotics. In addition, the level of PBP1 saturation at antibiotic concentrations corresponding to the minimum inhibitory concentrations was not constant, suggesting that additional, presently undiscovered, factors might be necessary to account for the experimental observations.