Anti-TNF Thioester Glucocorticoid Antibody-Drug Conjugate Fully Inhibits Inflammation with Minimal Effect on Systemic Corticosterone Levels in a Mouse Arthritis Model.

We describe the discovery of a thioester-containing glucocorticoid receptor modulator (GRM) payload and the corresponding antibody-drug conjugate (ADC). Payload 6 was designed for rapid hepatic inactivation to minimize systemic exposure of nonconjugated GRM. Mouse PK indicated that 6 is cleared 10-fold more rapidly than a first-generation GRM payload, resulting in 10-fold lower exposure and 3-fold decrease in Cmax. The anti-mTNF conjugate ADC5 fully inhibited inflammation in mouse contact hypersensitivity with minimal effects on corticosterone, a biomarker for systemic GRM effects, at doses up to and including 100 mg/kg. Concomitant inhibition of P1NP suggests potential delivery to cells involved in the remodeling of bone, which may be a consequence of TNF-targeting or bystander payload effects. Furthermore, ADC5 fully suppressed inflammation in collagen-induced arthritis mouse model after one 10 mg/kg dose for 21 days. The properties of the anti-hTNF conjugate were suitable for liquid formulation and may enable subcutaneous dosing.

Linker substitution influences succinimide ring hydrolysis equilibrium impacting the stability of attachment to antibody-drug conjugates.

Maleimide chemistry is widely used in antibody-drug conjugate (ADC) generation to connect drugs to antibodies through a succinimide linker. The resulting ADC is prone to payload loss via a reverse Michael reaction, leading to premature drug release in vivo. Complete succinimide hydrolysis is an effective strategy to overcome the instability of ADC. However, we discovered through previous work that hydrolysed succinimide rings can close again in a liquid formulation during storage and under thermal stress conditions. In this work, a set of maleimide linkers with hydrolysis-prone groups were designed. The corresponding ADCs were prepared and subjected to thermal stress conditions. The extent of succinimide hydrolysis and drug release was measured, and ADC properties such as SEC, DAR, pI and clog P of linkers were calculated. Our results demonstrated that even though all these groups increased the hydrolysis rate, they have different impacts on maintaining the hydrolysed succinimide ring in an open conformation and ADC stability in a liquid formulation.

Impact of dipeptide on ADC physicochemical properties and efficacy identifies Ala-Ala as the optimal dipeptide.

Side chains of natural occurring amino acids vary greatly in terms of charge state, polarity, size and hydrophobicity. Using a linear synthetic route, two amino acids were sequentially coupled to a potent glucocorticoid receptor modulator (GRM) to afford a library of dipeptide-GRM linker payloads with a range of in silico properties. The linker payloads were conjugated to a mouse anti-TNF antibody through interchain disulfide Cys. Impact of various dipeptide linkers on ADC physical properties, including solubility, hydrophobicity, and aggregation were evaluated and the in silico properties pI, Log P and tPSA of the linker drugs used to correlate with these properties. ADCs were screened in a GRE luciferase reporter assay to compare their in vitro efficacy. Data identified Ala-Ala as a superior dipeptide linker that allowed a maximum drug load of 10 while affording ADCs with low aggregation.

Discovery of ABBV-154, an anti-TNF Glucocorticoid Receptor Modulator Immunology Antibody-Drug Conjugate (iADC).

Stable attachment of drug-linkers to the antibody is a critical requirement, and for maleimide conjugation to cysteine, it is achieved by ring hydrolysis of the succinimide ring. During ADC profiling in our in-house property screening funnel, we discovered that the succinimide ring open form is in equilibrium with the ring closed succinimide. Bromoacetamide (BrAc) was identified as the optimal replacement, as it affords stable attachment of the drug-linker to the antibody while completely removing the undesired ring open-closed equilibrium. Additionally, BrAc also offers multiple benefits over maleimide, especially with respect to homogeneity of the ADC structure. In combination with a short, hydrophilic linker and phosphate prodrug on the payload, this afforded a stable ADC (ABBV-154) with the desired properties to enable long-term stability to facilitate subcutaneous self-administration.

Optimization of Drug-Linker to Enable Long-term Storage of Antibody-Drug Conjugate for Subcutaneous Dosing.

To facilitate subcutaneous dosing, biotherapeutics need to exhibit properties that enable high-concentration formulation and long-term stability in the formulation buffer. For antibody-drug conjugates (ADCs), the introduction of drug-linkers can lead to increased hydrophobicity and higher levels of aggregation, which are both detrimental to the properties required for subcutaneous dosing. Herein we show how the physicochemical properties of ADCs could be controlled through the drug-linker chemistry in combination with prodrug chemistry of the payload, and how optimization of these combinations could afford ADCs with significantly improved solution stability. Key to achieving this optimization is the use of an accelerated stress test performed in a minimal formulation buffer.

Discovery of ABBV-3373, an Anti-TNF Glucocorticoid Receptor Modulator Immunology Antibody Drug Conjugate.

Using a convergent synthetic route to enable multiple points of diversity, a series of glucocorticoid receptor modulators (GRM) were profiled for potency, selectivity, and drug-like properties in vitro. Despite covering a large range of diversity, profiling the nonconjugated small molecule was suboptimal and they were conjugated to a mouse antitumor necrosis factor (TNF) antibody using the MP-Ala-Ala linker. Screening of the resulting antibody drug conjugates (ADCs) provided a better assessment of efficacy and physical properties, reinforcing the need to conduct structure-activity relationship studies on the complete ADC. DAR4 ADCs were screened in an acute mouse contact hypersensitivity model measuring biomarkers to ensure a sufficient therapeutic window. In a chronic mouse arthritis model, mouse anti-TNF GRM ADCs were efficacious after a single dose of 10 mg/kg i.p. for over 30 days. Data on the unconjugated payloads and mouse surrogate anti-TNF ADCs identified payload 17 which was conjugated to a human anti-TNF antibody and advanced to the clinic as ABBV-3373.

Design and Development of Glucocorticoid Receptor Modulators as Immunology Antibody-Drug Conjugate Payloads.

Glucocorticoid receptor modulators (GRM) are the first-line treatment for many immune diseases, but unwanted side effects restrict chronic dosing. However, targeted delivery of a GRM payload via an immunology antibody-drug conjugate (iADC) may deliver significant efficacy at doses that do not lead to unwanted side effects. We initiated our α-TNF-GRM ADC project focusing on identifying the optimal payload and a linker that afforded stable attachment to both the payload and antibody, resulting in the identification of the synthetically accessible maleimide-Gly-Ala-Ala linker. DAR 4 purified ADCs were shown to be more efficacious in a mouse contact hypersensitivity model than the parent α-TNF antibody. Analysis of P1NP and corticosterone biomarkers showed there was a sufficient therapeutic window between efficacy and unwanted effects. In a chronic mouse arthritis model, α-TNF-GRM ADCs were more efficacious than both the parent α-TNF mAb and an isotype control bearing the same GRM payload.

Novel approach to optimization of a high-throughput semipreparative LC/MS system.

Automated semipreparative LC/MS systems are now well established commercially and commonly used for purification of early stage drug discovery compounds. A number of vendors have instruments on the market that are capable of reliably purifying compounds with good water/acetonitrile solubility. However, these systems often fail when the sample has poor solubility, extreme polarity, and/or poor ionization. Even in cases when substantial optimization has been done prior to purification, a certain percent of failures to recover the desired product is unavoidable. In the past, when the majority of samples run on LC/MS semipreparative systems were large combinatorial libraries, some losses in this high throughput mode were acceptable. However, now that more chemistry laboratories are making smaller more focused libraries with higher purity requirements, reliability and recovery are more crucial. This paper describes modifications made to customize an MS-triggered semipreparative LC/MS system in order to ensure improved reliability and recovery of products from traditional medicinal chemistry as well as combinatorial libraries.