RESUMO
The structural state and crystal structure of Lu(1-x)ScxFeO3 (0 ≤ x ≤ 1) compounds prepared by a chemical route based on a modified sol-gel method were investigated using X-ray diffraction, Raman spectroscopy, as well as scanning electron microscopy. It was observed that chemical doping with Sc ions led to a structural phase transition from the orthorhombic structure to the hexagonal structure via a wide two-phase concentration region of 0.1 < x < 0.45. An increase in scandium content above 80 mole% led to the stabilization of the non-perovskite bixbyite phase specific for the compound ScFeO3. The concentration stability of the different structural phases, as well as grain morphology, were studied depending on the chemical composition and synthesis conditions. Based on the data obtained for the analyzed samples, a composition-dependent phase diagram was constructed.
RESUMO
Results of switching behavior of the improper ferroelectric LuFeO3 are presented. Using a model set of films prepared under controlled chemical and growth-rate conditions, it is shown that defects can reduce the quasi-static switching voltage by up to 40% in qualitative agreement with first-principles calculations. Switching studies show that the coercive field has a stronger frequency dispersion for the improper ferroelectrics compared to a proper ferroelectric such as PbTiO3 . It is concluded that the primary structural order parameter controls the switching dynamics of such improper ferroelectrics.
RESUMO
Room-temperature multiferroism in LuFeO3 (LFO) films is demonstrated by exploiting the orthorhombic-hexagonal (o-h) morphotrophic phase coexistence. The LFO film further reveals a magnetoelectric coupling effect that is not shown in single-phase (h- or o-) LFO. The observed multiferroism is attributed to the combination of sufficient polarization from h-LFO and net magnetization from o-LFO.
RESUMO
LuFeO3 particles with an average particle size of â¼200 nm were synthesized via a polyacrylamide gel route. The sonocatalytic activity of LuFeO3 particles was evaluated by the degradation of Rhodamine B (RhB) under ultrasonic irradiation, revealing that they exhibit a good sonocatalytic activity. The effects of various experimental factors including ultrasonic frequency (f), reaction solution temperature (T), catalyst dosage (Ccatalyst), initial RhB concentration (CRhB), and pH value on the sonocatalysis efficiency were investigated. It is found that the former four factors have an important influence on the sonocatalytic degradation of RhB, where the best degradation conditions are obtained to be f=60 kHz, T=40 °C, Ccatalyst=4 g L(-1), and CRhB=5 mg L(-1). The pH value has a relatively small effect on the sonocatalytic degradation of RhB compared with other experimental factors. Hydroxyl (·OH) radicals were detected by fluorimetry using terephthalic acid as a probe molecule, revealing that they are produced over the ultrasonic-irradiated LuFeO3 particles. The addition of ethanol leads to a quenching of ·OH radicals and a simultaneous decrease in the RhB degradation. This indicates that ·OH radicals are the primary active species responsible for the dye degradation.