RESUMO
Phosphogypsum (PG) occupies a large amount of land due to its large annual production and low utilization rate, and at the same time causes serious environmental problems due to toxic impurities. PG is used for mine backfill, and industrial solid waste is a curing agent for PG, which can save the filling cost and reduce environmental pollution. In this paper, PG was used as a raw material, combined with steel slag (SS) and ground granulated blast-furnace slag (GGBS) under the action of an alkali-activated agent (NaOH) to prepare all-solid waste phosphogypsum-based backfill material (PBM). The effect of the GGBS to SS ratio on the compressive strength and toxic leaching of PBM was investigated. The chemical composition of the raw materials was obtained by XRF analysis, and the mineral composition and morphology of PBM and its stabilization/curing mechanism against heavy metals were analyzed using XRD and SEM-EDS. The results showed that the best performance of PBM was achieved when the contents of PG, GGBS, and SS were 80%, 13%, and 7%, the liquid-to-solid ratio was 0.4, and the mass concentration of NaOH was 4%, with a strength of 2.8 MPa at 28 days. The leaching concentration of fluorine at 7 days met the standard of groundwater class IV (2 mg/L), and the leaching concentration of phosphorus was detected to be less than 0.001 mg/L, and the leaching concentration of heavy metals met the environmental standard at 14 d. The hydration concentration in PBM met the environmental standard. The hydration products in PBM are mainly ettringite and C-(A)-S-H gel, which can effectively stabilize the heavy metals in PG through chemical precipitation, physical adsorption, and encapsulation.
RESUMO
The environmental damage caused by surface subsidence and coal-based solid waste (CBSW) is a common problem in the process of coal mining. Backfill mining can control the mining-induced subsidence and solve the problem of bulk solid waste storage. In the present work, a magnesium-coal slag solid waste backfill material (MCB) with modified magnesium slag (MS) as binder and CBSW (fly ash (FA), flue gas desulfurization gypsum (FDG) and coal gasification slag (CGS)) as supplementary cementitious material/aggregate was proposed to meet the needs of coal mining in Northern Shaanxi, China, to realize the comprehensive treatment of goaf and CBSW. The results show that: (1) The rheological curve of the fresh MCB slurry is highly consistent with the Herschel-Bulkley (H-B) model, and its fluidity meets the basic requirements of mine backfill pumping. With the addition of FDG and MS, the yield stress, apparent viscosity and thixotropy of MCB slurry increase, while the pseudoplastic index and slump decrease. (2) The strength of MCB develops slowly in the early stage (0â¼14 days) and increases rapidly in the later stage (14â¼90 days). Except for the ratio of M20F1 and FDG = 0%, the strength of samples at other ratios (at 28 days) is between 6.06â¼11.68 MPa, which meets the strength requirement of 6 MPa for coal mine backfill. The addition of MS and appropriate amount of FDG is beneficial to the development of strength. In contrast, MS exhibits a significant improvement in early strength, and FDG has a significant improvement in late-age strength. (3) Corresponding to the compressive strength, the hydration products C-S(A)-H and AFt of MCB are less in the early stage and greatly increased in the later stage. The active substance in FA/CGS will undergo pozzolanic reaction with the MS hydration product CH. The addition of FDG and MS can promote the reaction and increase the amount of hydration product, but in contrast, the promotion effect of FDG is more significant. (4) The amount of heavy metal leaching of MCB meets the requirements of national standards. The hardened MCB has a solidification/stabilization effect on heavy metal elements, which can significantly reduce the amount of heavy metal leaching. The results imply that MCB is a safe, reliable, and eco-friendly solid waste backfill material, and its application is conducive to the coordinated development of coal resource mining and environmental protection.