RESUMO
Collisionless shocks are ubiquitous in the Universe as a consequence of supersonic plasma flows sweeping through interstellar and intergalactic media. These shocks are the cause of many observed astrophysical phenomena, but details of shock structure and behavior remain controversial because of the lack of ways to study them experimentally. Laboratory experiments reported here, with astrophysically relevant plasma parameters, demonstrate for the first time the formation of a quasiperpendicular magnetized collisionless shock. In the upstream it is fringed by a filamented turbulent region, a rudiment for a secondary Weibel-driven shock. This turbulent structure is found responsible for electron acceleration to energies exceeding the average energy by two orders of magnitude.
RESUMO
This work considers a solenoid-based magnetic collimation system for improving the efficiency of ion trap loading with ions created by laser ablation. We discuss a physical model of ion beam collimation in such a system, provide qualitative analytical estimates of its collimation characteristics, develop a numerical model of ion collimation based on a test-particle approach, and describe a real experimental setup where the proposed approach is effectively employed to collimate 232Th3+ and 88Sr1+ ions. The experimental results are compared with the results of the performed numerical modeling. The observed inconsistencies between the two are discussed, and their possible explanations are suggested.
RESUMO
In this study, hard wear-resistant Ti-Si-C coatings were deposited on Cu-Cr materials to improve their performance as sliding electrical contact materials. A ceramic disk composed of Ti3SiC2 and TiC phases was used as a target for DC magnetron sputtering to deposit the coatings. The influence of the power supplied to the magnetron on the chemical composition, structure, and friction coefficient of the coatings was examined. The coatings demonstrated high hardness (23-25 GPa), low wear rate (1-3 × 10-5 mm3/N/m) and electrical resistance (300 µOhm·cm), and fair resistance to electroerosion. The coating deposited at 450 W for 30 min displayed optimal properties for protecting the Cu-Cr alloy from the arc effect.
RESUMO
The velocity map recorded in above-threshold ionization of xenon at 800 nm exhibits a distinct carpetlike pattern of maxima and minima for emission in the direction approximately perpendicular to the laser polarization. The pattern is well reproduced by a numerical solution of the time-dependent Schrödinger equation. In terms of the simple-man model and the strong-field approximation, it is explained by the constructive and destructive interference of the contribution of the long and the short orbit. Strictly perpendicular emission is caused by ionization at the two peaks of the laser field per cycle, which results in a 2hω separation of the above-threshold ionization rings.
RESUMO
Optical generation of kilo-tesla scale magnetic fields enables prospective technologies and fundamental studies with unprecedentedly high magnetic field energy density. A question is the optimal configuration of proposed setups, where plenty of physical phenomena accompany the generation and complicate both theoretical studies and experimental realizations. Short laser drivers seem more suitable in many applications, though the process is tangled by an intrinsic transient nature. In this work, an artificial neural network is engaged for unravelling main features of the magnetic field excited with a picosecond laser pulse. The trained neural network acquires an ability to read the magnetic field values from experimental data, extremely facilitating interpretation of the experimental results. The conclusion is that the short sub-picosecond laser pulse may generate a quasi-stationary magnetic field structure living on a hundred picosecond time scale, when the induced current forms a closed circuit.
RESUMO
A strong quasistationary magnetic field is generated in hollow targets with curved internal surface under the action of a relativistically intense picosecond laser pulse. Experimental data evidence the formation of quasistationary strongly magnetized plasma structures decaying on a hundred picoseconds timescale, with the magnetic field strength of the kilotesla scale. Numerical simulations unravel the importance of transient processes during the magnetic field generation and suggest the existence of fast and slow regimes of plasmoid evolution depending on the interaction parameters. The proposed setup is suited for perspective highly magnetized plasma application and fundamental studies.
RESUMO
We present, using three-dimensional particle-in-cell simulations, an observation that orbital angular momentum (OAM) is transferred to resonant electrons proportionally to longitudinal momentum when Laguerre-Gaussian plasma waves are subjected to Landau damping. A higher azimuthal mode number leads to a larger net orbital angular momentum transfer to particles traveling close to the phase velocity of the plasma wave, implying a population of electrons that are orbiting the same center of rotation as the plasma wave. This observation has implications on magnetic field excitation as a result of the formation and damping of OAM plasma waves. The energy distributions of electrons in damping Laguerre-Gaussian plasma waves are significantly changed as a function of azimuthal mode number. This leads to larger numbers of lower energy particles tending towards a significant narrowing of the energy distribution of accelerated particles.
RESUMO
Three-dimensional "particle in cell" simulations show that a quasistatic magnetic field can be generated in a plasma irradiated by a linearly polarized Laguerre-Gauss beam with a nonzero orbital angular momentum (OAM). Perturbative analysis of the electron dynamics in the low intensity limit and detailed numerical analysis predict a laser to electrons OAM transfer. Plasma electrons gain angular velocity thanks to the dephasing process induced by the combined action of the ponderomotive force and the laser induced-radial oscillation. Similar to the "direct laser acceleration," where Gaussian laser beams transmit part of its axial momentum to electrons, Laguerre-Gaussian beams transfer a part of their orbital angular momentum to electrons through the dephasing process.
RESUMO
Magnetic reconnection in a relativistic electron magnetization regime was observed in a laboratory plasma produced by a high-intensity, large energy, picoseconds laser pulse. Magnetic reconnection conditions realized with a laser-driven several kilotesla magnetic field is comparable to that in the accretion disk corona of black hole systems, i.e., Cygnus X-1. We observed particle energy distributions of reconnection outflow jets, which possess a power-law component in a high-energy range. The hardness of the observed spectra could explain the hard-state x-ray emission from accreting black hole systems.
RESUMO
The structure of Langmuir plasma waves carrying a finite orbital angular momentum is revised in the paraxial approximation. It is shown that the kinetic effects related to higher-order momenta of the electron distribution function lead to coupling of Laguerre-Gaussian modes and result in a modification of the wave dispersion and damping. The theoretical analysis is compared to the three-dimensional particle-in-cell numerical simulations for a mode with orbital momentum l=2. It is demonstrated that propagation of such a plasma wave is accompanied with generation of quasistatic axial and azimuthal magnetic fields which result from the orbital and longitudinal momenta transported with the wave, respectively.
RESUMO
Optical generation of compact magnetized plasma structures is studied in the moderate intensity domain. A sub-ns laser beam irradiated snail-shaped targets with the intensity of about 1016 W/cm2. With a neat optical diagnostics, a sub-megagauss magnetized plasmoid is traced inside the target. On the observed hydrodynamic time scale, the hot plasma formation achieves a theta-pinch-like density and magnetic field distribution, which implodes into the target interior. This simple and elegant plasma magnetization scheme in the moderate-intensity domain is of particular interest for fundamental astrophysical-related studies and for development of future technologies.
RESUMO
Bioactivity of multicomponent TiCaPCO(N) and Ag-doped TiCaPCO(N) films was evaluated in vitro using simulated body fluid (SBF) and compared with that of bioactive glass Biogran. The first group of films was fabricated by magnetron sputtering of composite TiС0.5 -Ti3 POx -CaO target produced via the self-propagating high-temperature synthesis (SHS) method (TiCaPCON films), after which their surface was implanted with Ag+ ions to obtain Ag-doped TiCaPCON films. The second group of films was fabricated by pulsed electrospark deposition (PED) using SHS-produced composite TiС0.5 -Ti3 POx -CaO and TiС0.5 -Ti3 POx -CaO-Ag electrodes. After immersion in SBF, the structure and chemistry of surface were well characterized using a combination of various microanalytical techniques, such as scanning electron microscopy, X-ray diffractometry (both in conventional and grazing incidence mode), Fourier transform infrared spectroscopy, Raman spectroscopy, and glow discharge optical emission spectroscopy. The results showed that the surfaces of the TiCaPCO(N) and Ag-doped TiCaPCO(N) films were bioactive in vitro and induced the formation of an apatite layer during exposure in SBF. In the case of the magnetron-sputtered films, the apatite layer was formed over 14 days, while 28 days were needed to form CaP phase on the surface of PED-modified samples. Various factors (film structure, surface roughness, surface functional groups, surface charge, and composition, supersaturation, and near-surface local supersaturation of SBF) affecting the kinetics of bone-like apatite formation on a bioactive surface are discussed. © 2015 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 105B: 193-203, 2017.
Assuntos
Apatitas/química , Líquidos Corporais/química , Cálcio/química , Membranas Artificiais , Prata/química , Titânio/química , Animais , Humanos , Propriedades de SuperfícieRESUMO
For the first time the surface of decellularized extracellular matrix (DECM) was modified via deposition of a multicomponent bioactive nanostructured film for improvement of the DECM's mechanical properties. TiCaPCON films were deposited onto the surface of intact and decellularized ulna, radius, and humerus bones by magnetron sputtering of TiC0.5 + 10%Ca3(PO4)2 and Ti targets in a gaseous mixture of Ar + N2. The film structure was studied using x-ray diffraction, scanning and transmission electron microscopy, and Raman spectroscopy. The films were characterized in terms of their wettability, as well as adhesion strength to the intact bone and DECM substrates. The mechanical properties of TiCaPCON-coated samples were investigated by compression testing. In addition, humerus bones were evaluated during three-point bending tests. The results indicate that the tightly adhered films, uniformly covering the DECM surfaces, possessed hydrophilic characteristics. A maximum improvement in mechanical properties (250%) was observed for coated humerus samples. In case of decellularized radius bones, the compressive strength also increased by 150% after coating. The positive role of TiCaPCON films was less noticeable for ulna bones because of large data scattering. These results clearly indicate that the films acted as a rigid frame that increased the material compressive strength. Compared with intact bones, fracture in the TiCaPCON-coated DECM samples was characterized by rarer and larger cracks generated under higher critical loads. As a result, the samples were crushed into several large pieces and numerous tiny fragments. Although the film deposition increased the bone stiffness, the bending tests revealed that the flexural strength of the coated samples became 20%-25% lower than the strength of the film-free samples.
Assuntos
Substitutos Ósseos/química , Osso e Ossos/química , Fosfatos de Cálcio/química , Materiais Revestidos Biocompatíveis/química , Matriz Extracelular/química , Titânio/química , Adesividade , Animais , Argônio/química , Sistema Livre de Células/química , Força Compressiva , Cães , Módulo de Elasticidade , Teste de Materiais , Nanoestruturas/química , Nanoestruturas/ultraestrutura , Nitrogênio/química , Estresse Mecânico , Propriedades de Superfície , Resistência à TraçãoRESUMO
A simple setup for the generation of ultra-intense quasistatic magnetic fields, based on the generation of electron currents with a predefined geometry in a curved snail (or 'escargot') target, is proposed and analyzed. Particle-in-cell simulations and qualitative estimates show that gigagauss scale magnetic fields may be obtained with existent laser facilities. The described mechanism of the strong magnetic field generation may be useful in a wide range of applications, from laboratory astrophysics to magnetized inertial confinement fusion schemes.
RESUMO
The fabrication of antibacterial yet biocompatible and bioactive surfaces is a challenge that biological and biomedical community has faced for many years, while no "dream material" has been developed so far. The primary goal of this study was to establish an optimal range of Ag concentration and its state of agglomeration in bioactive nanocomposite TiCaPCON films which would provide a strong bactericidal effect without compromising the material biocompatibility and bioactivity. To obtain samples with different Ag content and redistribution, two different methods were employed: (i) TiCaPCON films deposition by magnetron sputtering of composite TiС0.5-Ca3(Ð Ð4)2 target followed by Ag(+) ion implantation and (ii) Ag-doped TiCaPCON films obtained by co-sputtering of composite TiС0.5-Ca3(Ð Ð4)2 and Ag targets. In order to reveal the antibacterial role of Ag nanoparticles and Ag(+) ions, both separate and in synergy, part of the samples from the first and second groups was subjected to additional ion etching to remove an Ag rich surface layer heavily populated with Ag nanoparticles. All resultant films were characterized with respect to surface morphology, chemical composition, surface roughness, wettability, and Ag(+) ion release. The antibacterial and antifungal effects of the Ag-doped TiCaPCON films were evaluated against clinically isolated Escherichia coli O78 (E. coli) and Neurospora crassa wt-987 spores. The influence of the surface chemistry on spreading, proliferation, and early stages of MC3T3-E1 osteoblastic cell differentiation was also studied. Our data demonstrated that under optimal conditions in terms of Ag content and agglomeration, the Ag-doped TiCaPCON films are highly efficient against E. coli bacteria and, at the same time, provide good adhesion, spreading, proliferation and differentiation of osteoblastic cells which reflect high level of biocompatibility and bioactivity of the films. The influence of Ag(+) ions and nanoparticles on the MC3T3-E1 osteoblastic cells and E. coli bacteria is also discussed.
Assuntos
Antibacterianos/química , Antibacterianos/farmacologia , Células 3T3 , Fosfatase Alcalina/química , Fosfatase Alcalina/metabolismo , Animais , Antifúngicos/química , Antifúngicos/farmacologia , Materiais Biocompatíveis , Fosfatos de Cálcio/química , Diferenciação Celular/efeitos dos fármacos , Escherichia coli/efeitos dos fármacos , Camundongos , Nanocompostos , Neurospora crassa/efeitos dos fármacos , Osteoblastos , Prata/química , Prata/farmacologia , Esporos Fúngicos/efeitos dos fármacos , Propriedades de Superfície , Titânio/químicaRESUMO
An analytical theory of the resonancelike phenomena in high-order above-threshold ionization is presented that explains details of the experimental spectra and theoretical simulations. It traces the observed features to the constructive interference of "quantum orbits" with long travel times at laser intensities where the N-photon ionization channels close. Characteristic differences show up between even and odd N. The effects are generic to all laser-induced recollision phenomena. For nonsequential double ionization, their signature in the momentum distribution of the final electrons is identified.