ABSTRACT
Abstract Objectives This study aimed to assess the effect of proanthocyanidin, palm oil and vitamin E against erosive and erosive+abrasive challenges in vitro after enamel pellicle formation in situ. Methodology Bovine enamel blocks (n=84) were obtained and divided into the following treatment groups: negative control (NC) - deionized water; positive control (PC) - SnCl2/NaF/AmF-containing solution; palm oil (PO); 2% proanthocyanidin (P2); vitamin E (VitE); 2% proanthocyanidin+palm oil (P2PO); and 2% proanthocyanidin+vitamin E (P2VitE). For 5 days, one half of the sample from each group was subjected to erosion and the other half was subjected to erosion+abrasion. The acquired enamel pellicle (AEP) was pre-formed in situ for 30 minutes. The specimens were then treated in vitro with solutions (500 µl, 30s for each group). Subsequently, the blocks were left in the oral cavity for another hour to obtain the modified AEP. The blocks were immersed in 0.5% citric acid (pH=2.5) for 90s, 4×/day. AEP formation and treatment were carried out before the first and third erosive challenges, and after these challenges, abrasive cycles (15s) were performed on half of the samples. Enamel wear was quantified by profilometry and data were analyzed by two-way ANOVA and Tukey's test (p<0.05). Results All groups showed higher wear when exposed to erosion+abrasion than when exposed to erosion alone (p=0.0001). PO, P2VitE, P2, and P2PO showed enamel wear similar to the PC group, but only PC, PO and P2VitE differed from the NC group. The other groups behaved similarly to NC. Conclusion It was concluded that the combination of proanthocyanidin and vitamin E was effective in reducing wear in the face of in vitro erosive and erosive+abrasive challenges.
ABSTRACT
Objective: This study evaluated Proanthocyanidin protective effect on dentin subjected to erosion and its inhibition on degradation of the demineralized organic matrix (DOM). Material and Methods: The tested groups were: G1 - 10% Proanthocyanidin gel (test group), G2 - 1.23% NaF (positive control 1), G3 - 0.012% Chlorhexidine (positive control 2) and G4 Placebo (negative control with no active compound) and two methodologies were performed: contact profilometry and ICTP ELISA method. To quantify dentin wear, profilometry was performed. Data were submitted to Analysis of Variance followed by Fisher's LSD Test. To assess the collagen degradation, ICTP ELISA method was performed. Data were submitted to the Kruskal-Wallis followed by the Dunn Ìs test. Simple linear regression and Pearson Correlation test were also performed (p<0.05). Results: The profilometry showed significantly lower wear of G1 when compared to other groups and G2, G3 and G4, which did not present significant difference among them. In the ICTP ELISA analysis, G1 and G4 did not show significant differences and the same happened between G2 and G3. However, G1 and G4 had lower values of collagen degradation compared to groups G2 and G3. Data showed that degraded DOM is a significant predictor to explain the values obtained through the ICTP ELISA. Conclusions: The results allow to verify that 10% proanthocyanidin provided less tooth wear and decreased degradation of the DOM, suggesting a good ability to prevent dentin erosion. The regression analysis also suggests that contact profilometry is a good strategy to quantify dentin wear (AU)
Objetivo: Este estudo avaliou o efeito protetor da proantocianidina na dentina submetida à erosão e sua inibição na degradação da matriz orgânica desmineralizada (MOD). Material e Métodos: Os grupos testados foram: G1 - gel de Proantocianidina 10% (grupo teste), G2 - NaF 1,23% (controle positivo 1), G3 - Clorexidina 0,012% (controle positivo 2) e G4 - Placebo (controle negativo sem princípio ativo) e duas metodologias foram realizadas: perfilometria de contato e método ICTP ELISA. Para quantificar o desgaste da dentina, a perfilometria foi realizada. Os dados foram submetidos à Análise de Variância seguida do Teste LSD de Fisher. Para avaliar a degradação do colágeno, foi realizado o método ICTP ELISA. Resultados: Os dados foram submetidos ao teste de Kruskal-Wallis seguido do teste de Dunn. Regressão linear simples e teste de correlação de Pearson também foram realizados (p<0,05). A perfilometria mostrou desgaste significativamente menor do G1 quando comparado aos outros grupos e G2, G3 e G4, que não apresentaram diferença significativa entre si. Na análise ICTP ELISA, G1 e G4 não apresentaram diferenças significativas e o mesmo ocorreu entre G2 e G3. No entanto, G1 e G4 apresentaram valores menores de degradação do colágeno em relação aos grupos G2 e G3. Os dados mostraram que a MOD degradada é um preditor significativo para explicar os valores obtidos pelo ICTP ELISA. Conclusão: Os resultados permitem verificar que a proantocianidina a 10% proporcionou menor desgaste dentário e diminuição da degradação da MOD, sugerindo uma boa capacidade de prevenir a erosão dentinária. Também sugere que a perfilometria de contato é uma boa estratégia para quantificar o desgaste da dentina (AU)
Subject(s)
Preventive Health Services , Tooth Erosion , Proanthocyanidins , Dentin , Tooth WearABSTRACT
Abstract Proanthocyanidin has been shown to be efficient in inhibiting matrix metalloproteinases. Objective The aim of this in situ study was to evaluate the protective effect of Proanthocyanidin-based mouthrinses either with naturally acidic or with a neutral pH applied on dentin subjected to erosion. Methodology Eight volunteers wore one palatal device in two phases (7 days washout) with 16 samples per group (n=8). The groups under study were: First Phase/ G1 - 10% proanthocyanidin mouthrinse (pH 7.0, Experimental group 1 - Purified Grape Seeds Oligomeric Proanthocyanidins), G2 - 10% proanthocyanidin mouthrinse (pH 3.0, Experimental group 2 - Purified Grape Seeds Oligomeric Proanthocyanidins). Second Phase/ G3 - 0.12% chlorhexidine mouthrinse (pH 7.0, Positive control group), G4 - no previous treatment (Negative control group). Each device was subjected to 3 erosive cycles (5 minutes) per day for 5 days. Treatments with different mouthrinses were applied once after the second erosive challenge (5 minutes). Profilometry was used to quantify dentin loss (µm). Results Data were analyzed by repeated measures of ANOVA followed by Fisher's test (p<0.05). G1 (1.17±0.69) and G3 (1.22±0.25) showed significantly lower wear values with no statistical difference between them. G2 (2.99±1.15) and G4 (2.29±1.13) presented higher wear values with no significant differences between them. Conclusion The 10% proanthocyanidin mouthrinse (pH 7.0) could be a good strategy to reduce dentin wear progression.
Subject(s)
Humans , Proanthocyanidins/pharmacology , Dentin/drug effects , Mouthwashes/pharmacology , Tooth Erosion/prevention & controlABSTRACT
Abstract Objective The prevalence of dental erosion has been recently increasing, requiring new preventive and therapeutic approaches. Vegetable oils have been studied in preventive dentistry because they come from a natural, edible, low-cost, and worldwide accessible source. This study aimed to evaluate the protective effect of different vegetable oils, applied in two concentrations, on initial enamel erosion. Material and Methods Initially, the acquired pellicle was formed in situ for 2 hours. Subsequently, the enamel blocks were treated in vitro according to the study group (n=12/per group): GP5 and GP100 - 5% and pure palm oil, respectively; GC5 and GC100 - 5% and pure coconut oil; GSa5 and GSa100 - 5% and pure safflower oil; GSu5 and GSu100 - 5% and pure sunflower oil; GO5 and GO100 - 5% and pure olive oil; CON− - Deionized Water (negative control) and CON+ - Commercial Mouthwash (Elmex® Erosion Protection Dental Rinse, GABA/positive control). Then, the enamel blocks were immersed in artificial saliva for 2 minutes and subjected to short-term acid exposure in 0.5% citric acid, pH 2.4, for 30 seconds, to promote enamel surface softening. The response variable was the percentage of surface hardness loss [((SHi - SHf) / SHf )×100]. Data were analyzed by one-way ANOVA and Tukey's test (p<0.05). Results Enamel blocks of GP100 presented similar hardness loss to GSu100 (p>0.05) and less than the other groups (p<0.05). There was no difference between GP5, GC5, GC100, GSa5, GSu100, GSa100, GSu5, GO5, GO100, CON− and CON+. Conclusion Palm oil seems to be a promising alternative for preventing enamel erosion. However, further studies are necessary to evaluate a long-term erosive cycling.