ABSTRACT
Objective@#To discuss the difference between pyrophosphoric acid method and infrared spectrophotometry for the determination of silica content in dust.@*Methods@#The content of silica in the laboratory comparison samples organized by CDC Occupational Health Institute in China in 2018, and purchased quality control samples were determined by pyrophosphate method. Meanwhile, the samples were qualitatively and quantitatively analyzed by infrared spectrophotometry, and the results obtained by the two methods were compared.@*Results@#Four samples (062C1、062C2、GDOHZKTG012-1、GDOHZKTG012-2) were detected by pyrophosphate method and infrared spectrophotometry. The results of pyrophosphate method were 55.49%, 5.24%, 4.90% and 54.72%, respectively. The results of infrared spectrophotometry were 0.91%, 1.87%, 1.29% and 1.16% respectively.@*Conclusion@#The content of silica in dust determined by pyrophosphate method is higher than that by infrared spectrophotometry.
ABSTRACT
OBJECTIVE: To compare the results of occupational health risk of 2-butoxyethanol(2-BE) by two risk assessment methods. METHODS: Occupational health investigation and detecting 2-BE level in workplace were carried out in a bicycle manufacturing factory in Tianjin City, a printing factory in Shenzhen City and an automobile manufacturing factory in Beijing City. The occupational health risk of 2-BE was assessed by Singapore's semi-quantitative risk assessment model and occupational hazards risk assessment index method. The risk classification results of the 2 risk assessment methods were compared and analyzed. RESULTS: The results of Singapore's semi-quantitative risk assessment method showed that all the 2-BE risk ratios of the decals workshop in the bicycle manufacturing factory, the binding and printing workshops of the printing factory, the spray finishing and the intermediate painting and the electrophoresis workshops of the automobile manufacturing factory were 0.4. The classification of 2-BE risk ratios belongs to low risk level. The results of occupational hazards risk assessment index method showed that the risk ratios of decals workshop in the bicycle manufacturing factory, the binding and printing of the printing factory, the spray finishing and the intermediate painting and the electrophoresis of the automobile manufacturing factory were 0.4, 0.4 and 0.2, respectively, which correspondence to low, low and negligible risk classification, respectively. The two methods were consistent with the appraisal positions of decals post in the bicycle manufacturing factory and the evaluation of binding and printing positions of a printing factory, although the risk assessment results of key positions in the paint shop of an automobile manufacturing industry were inconsistent. CONCLUSION: The occupational hazard risk assessment index method takes into account of the health effects, exposure conditions and operating conditions, and can comprehensively and accurately assess the occupational health risks caused by 2-BE.
ABSTRACT
Objective@#To establish a elution solution-liquid chromatography method for determination of p-Phenylene diamine (PPD) in workplace air.@*Methods@#p-Phenylene diamine (PPD) in the air of workplace was collected with glass fiber filters coated with dilute sulfuric acid and extracted with an aqueous EDTA solution. The target toxicant was separated with the C18 column and analyzed with UV detector, identified by retention time, and quantified by peak area.@*Results@#The linear range of PPD in the air of workplace was 2.00~10.00 μg/ml, with a correlation coefficient of 0.999 96. The limit of detection was 0.07 μg/ml. The lower limit of quantification was 0.23 μg/ml. The minimum detectable concentration was 0.003 1 mg/m3 under 45.0 L sampling volume and 2.0 ml extraction solution volume. The within-run precision of different PPD concentrations was 0.15%~2.3% and the between-run precisions was 1.4%~2.6%; The extraction efficiencies was 91.4%~95.4%; The average collection efficiencies was 96.6%; The samples could be stored for 7 days isolation of air. The potential coexistence of m-Phenylene diamine and o-Phenylene diamine with p-Phenylene diamine (PPD) in the air did not interfere with the results of determination.@*Conclusion@#This method has high sensitivity, precision, accuracy and lower limit of detection and it is applicable for determination of p-Phenylene diamine (PPD) in workplace air.
ABSTRACT
Objective@#To study the effect of p-phenylenediamine (PPD) on liver and kidney function in occupational exposed workers.@*Methods@#Workers in a hair dye production enterprise which used p-phenylenediamine as a raw material for production were selected as the main research population. Then we conducted a questionnaire survey on the basic conditions of workers and conducted occupational health checkups on general health status, liver and kidney function. Occupational health examination assessment results were tested in Taizhou Cancer Hospital. All data was built using EpiData 3.1 software, and statistical analysis was performed using software SPSS 20.0.@*Results@#The liver function indicators including direct bilirubin, prealbumin, total protein, and white protein, globulin, aspartate aminotransferase, glutamyl transpeptidase, and total bilirubin in the workers exposed to high concentration of PPD were at high normal values, and these indicators were significantly different from low PPD concentration group (P<0.05) . The serum creatinine and serum uric acid in the renal function index were significantly higher in workers exposed to PPD than in workers exposed to low concentrations and in the control group (P<0.05) .@*Conclusion@#Occupational exposed to PPD may have a hazard to the workers’ liver and kidney function. Long-term occupational exposure to PPD may lead to increased cumulative exposure of workers, which may cause potential chronic liver and kidney damage in occupationally exposed populations.
ABSTRACT
<p><b>OBJECTIVE</b>To establish a gas chromatography method for determination of methyl propyl ketone in the air of workplace.</p><p><b>METHODS</b>Methyl propyl ketone in the air of workplace was collected with activated carbon tubes and desorbed with carbon disulfide before sample loading. The target toxicant was separated with the capillary column and detected with a hydrogen flame ionization detector, identified by retention time, and quantified by peak area.</p><p><b>RESULTS</b>The linear range of methyl propyl ketone in the air of workplace was 202.5∼4 860.0 µg/ml, with a correlation coefficient of 0.999 98. The limit of detection was 1.5 µg/ml. The lower limit of quantification was 5.0 µg/ml. The minimum detectable concentration was 1.0 mg/m(3) under 1.5 L sampling volume and 1.0 ml desorption solution volume. The relative standard deviation of different methyl propyl ketone concentrations was 1.42%∼1.65%, and the recovery rate was 94.9%∼ 97.9%.</p><p><b>CONCLUSION</b>This method has high sensitivity, precision, and accuracy, and it is applicable for determination of methyl propyl ketone in the air of workplace.</p>
Subject(s)
Air , Air Pollutants, Occupational , Carbon Disulfide , Chromatography, Gas , Methods , Pentanones , WorkplaceABSTRACT
<p><b>OBJECTIVE</b>To calculate the consequence of acute ammonia poisoning accident which was caused by the leak of liquefied ammonia storage tank, so as to provide theoretical basis for working out the counterplan of accidents.</p><p><b>METHOD</b>The amount of liquefied ammonia to be reserved, the pressure and temperature inside the tank were inputted; based on the physical chemistry principle, the evaporating amount was calculated; and using the proper diffusion model, the size of ammonia cloud, percentages of death and depth range of the poisonous gas etc was calculated.</p><p><b>RESULTS</b>Assuming the leaky tank had liquefied ammonia 50 t, the pressure and the temperature were 2.5 MPa and 30 degrees C respectively, the evaporating amount and the size of ammonia cloud were calculated. The radiuses, of the ammonia released cloud of severe, moderate and mild hazard were 108 m, 216 m, 370 m respectively; if the exposured time was 30 min, the percentage of death would be 50%; if the exposured time was 5 min, the percentage would be 10%; if the exposured time was 2 min, the percentage would be 2.5%. When the stable degree of circumstance was C, the wind speed was 2.3 m/s and the outside concentration of the cloud was 4000 mg/m3, dimension of cloud in X axis was 782 m and in Y axis was 88 m.</p><p><b>CONCLUSION</b>The leaky consequence of liquefied ammonia was very serious. It is necessary to take preventive measures during production, storage, transportation and using of liquefied ammonia.</p>
Subject(s)
Humans , Accidents, Occupational , Ammonia , Poisoning , Pressure , TemperatureABSTRACT
Objective To determine the incidence of pregnancy complicated with heart disease and assess the current obstetric management principles of pregnancy complicated with heart disease. Methods 428 cases of pregnancy complicated with heart disease were reviewed.54 cases were sur- gically corrected heart disease.Results:The incidence of pregnancy complicated with heart dis- ease,during January,1973 to December,1982 and January,1983 to December,1992,were 1.2% (254/21 221) and 0.9% (174/18 726)respectively.The ratio of rheumatic heart disease and congenital heart disease were 4:1 and 1:2 in two periods.There were 37 cases of heart failure and 4 cases of ma- ternal deaths occured.No heart failure and maternal death occured in cases with surgically corrected heart disease.In the two periods,the cesarean section rate were 16.9%(43/254),and 33.3% (58/74) ,P