ABSTRACT
OBJECTIVE: To compare the International Prostate Symptom Score (IPSS) and novel Visual Prostate Symptom Score (VPSS) in patients with lower urinary tract symptoms (LUTS), to correlate scores with uroflowmetry and prostate volume and assess patient perceptions regarding pain prior to, and after prostate biopsy. Materials and methods: Patients with LUTS who had an indication for transrectal ultrasound (TRUS) biopsy were included. Patients completed the IPSS-, VPSS- and prostate biopsy pain assessment questionnaires. Assessment included uroflowmetry, post- void residual volume and prostate volume (measured with TRUS). RESULTS: One hundred men were included. There were statistically significant correlations between the VPSS score and IPSS score (correlation coefficient (r) = 0.802); VPSS and Qmax (r = -0.311); VPSS and. Qave (r = -0.344); prostate volume with VPSS (r = 0.194) and Qmax (r = -0.260). The VPSS was quicker to complete than the IPSS (mean 100 vs. 165 seconds). The mean anticipated pain score before biopsy was 2.8 (range 0-6), and after biopsy (experienced pain) it was 1.8 (range 0-5). The pain during biopsy was less than expected in 67% of patients. CONCLUSION: In men with LUTS scheduled to undergo prostate biopsy, the VPSS score correlated positively with the IPSS score. Men with limited education take less time to complete the VPSS. Patient's perception of expected pain or discomfort during TRUSguided prostate biopsy was significantly higher than the pain actually experienced during biopsy. Men with lower education level had significantly higher expectation of pain prior to biopsy, but similar pain during biopsy
Subject(s)
Humans , Male , Adult , Aged , Prostatic Diseases/diagnosis , Pain Perception , Endoscopic Ultrasound-Guided Fine Needle Aspiration , Severity of Illness Index , Prospective Studies , Visual Analog Scale , Middle AgedABSTRACT
PURPOSE: To design a simple, cost-effective system for gaining rapid and accurate calyceal access during percutaneous nephrolithotomy (PCNL). MATERIALS AND METHODS: The design consists of a low-cost, light-weight, portable mechanical gantry with a needle guiding device. Using C-arm fluoroscopy, two images of the contrast-filled renal collecting system are obtained: at 0-degrees (perpendicular to the kidney) and 20-degrees. These images are relayed to a laptop computer containing the software and graphic user interface for selecting the targeted calyx. The software provides numerical settings for the 3 axes of the gantry, which are used to position the needle guiding device. The needle is advanced through the guide to the depth calculated by the software, thus puncturing the targeted calyx. Testing of the system was performed on 2 target types: 1) radiolucent plastic tubes the approximate size of a renal calyx (5 or 10 mm in diameter, 30 mm in length); and 2) foam-occluded, contrast-filled porcine kidneys. RESULTS: Tests using target type 1 with 10 mm diameter (n = 14) and 5 mm diameter (n = 7) tubes resulted in a 100 percent targeting success rate, with a mean procedure duration of 10 minutes. Tests using target type 2 (n = 2) were both successful, with accurate puncturing of the selected renal calyx, and a mean procedure duration of 15 minutes. CONCLUSIONS: The mechanical gantry system described in this paper is low-cost, portable, light-weight, and simple to set up and operate. C-arm fluoroscopy is limited to two images, thus reducing radiation exposure significantly. Testing of the system showed an extremely high degree of accuracy in gaining precise access to a targeted renal calyx.