Relation between implant/abutment vertical misfit and torque loss of abutment screws
Braz. dent. j
;
19(4): 358-363, 2008. ilus, tab
Article
in English
| LILACS
| ID: lil-504201
ABSTRACT
This study investigated whether there is a direct correlation between the level of vertical misfit at the abutment/implant interface and torque losses (detorque) in abutment screws. A work model was obtained from a metal matrix with five 3.75 x 9 mm external hex implants with standard platform (4.1 mm). Four frameworks were waxed using UCLA type abutments and one-piece cast in commercially pure titanium. The misfit was analyzed with a comparator microscope after 20 Ncm torque. The highest value of misfit observed per abutment was used. The torque required to loose the screw was evaluated using a digital torque meter. The torque loss values, measured by the torque meter, were assumed as percentage of initial torque (100 percent) given to abutment screws. Pearson's correlation (α=0.05) between the misfit values (29.08 ± 8.78 µm) and the percentage of detorque (50.71 ± 11.37 percent) showed no statistically significant correlation (p=0.295). Within the limitations of this study, it may be concluded that great vertical misfits dot not necessarily implies in higher detorque values.
RESUMO
Este trabalho teve como objetivo correlacionar o nível de desajuste vertical pilar/implante a perda do torque aplicado (destorque). Um modelo de trabalho foi obtido a partir de uma matriz metálica com cinco implantes tipo hexágono externo (Titamax, Neodent, Curitiba, Brasil) com plataforma regular (4,1 mm). Sobre esta matriz, quatro infra-estruturas foram enceradas utilizando pilares tipo UCLA e fundidas em monobloco com titânio comercialmente puro (Tritan grau I, Dentaurum, Alemanha). Os desajustes foram analisados com um microscópio óptico comparador (Mytutoyo, Japão) após torque de 20 Ncm. O maior valor de desajuste observado por pilar foi utilizado. O valor do torque de desaperto, avaliado com um torquímetro digital (TQ-680, Instrutherm, Brasil), foi calculado em porcentagem do valor do torque inicial (100 por cento) dado aos parafusos protéticos. O teste de correlação de Pearson (p<0,05), entre os valores de desajuste (29,08 ± 8,78 µm) e as porcentagens da perda de torque (50,71 ± 11,37 por cento), não mostrou correlação estatisticamente significante (p=0,295) entre tais fatores. Dentro das limitações do estudo, pode ser concluído que não necessariamente grandes valores de desajustes verticais implicarão em grades perdas de torque.
Full text:
Available
Index:
LILACS (Americas)
Main subject:
Dental Implants
/
Dental Abutments
/
Dental Prosthesis Retention
/
Dental Prosthesis, Implant-Supported
/
Dental Restoration Failure
/
Dental Implantation, Endosseous
Type of study:
Prognostic study
Language:
English
Journal:
Braz. dent. j
Journal subject:
Dentistry
Year:
2008
Type:
Article
/
Project document
Affiliation country:
Brazil
Institution/Affiliation country:
Federal University of Rio Grande do Norte/BR
/
Federal University of Uberlândia/BR
/
University of São Paulo/BR
Similar
MEDLINE
...
LILACS
LIS