RESUMO
Our objectives were to compare the antifungal activity of 5 lignosulfonates, and 2 chitosans against fungi isolated from spoiled hay, and assess the effects of an optimized lignosulfonate, chitosan, and propionic acid (PRP) on high-moisture alfalfa hay. In experiment 1, we determined the minimum inhibitory concentration and minimum fungicidal concentration of 4 sodium lignosulfonates, 1 magnesium lignosulfonate, 2 chitosans, and PRP (positive control) against Aspergillus amoenus, Mucor circinelloides, Penicillium solitum, and Debaromyces hansenii at pH 4 and 6. Among sodium lignosulfonates, the one from Sappi Ltd. (NaSP) was the most antifungal at pH 4. However, chitosans had the strongest fungicidal activity with the exception of M. circinelloides at both pH 4 and 6. PRP had more antifungal effects than NaSP and was only better than chitosans for M. circinelloides. In experiment 2, we evaluated the effects of 3 additives (ADV): optimized NaSP (NaSP-O, UMaine), naïve chitosan (ChNv, Sigma-Aldrich), and PRP on high-moisture alfalfa hay. The experimental design was a randomized complete block design replicated 5 times. Treatment design was the factorial combination of 3 ADV× 5 doses (0, 0.25, 0.5, 1, and 2% w/w fresh basis). Additives were added to 35 g of sterile alfalfa hay (71.5 ± 0.23% DM), inoculated with a mixture of previously isolated spoilage fungi (5.8 log cfu/fresh g), and aerobically incubated in vitro for 23 d (25°C). After incubation, DM losses were reduced by doses as low as 0.25% for both NaSP-O and PRP (x¯=1.61) vs. untreated hay (24.0%), partially due to the decrease of mold and yeast counts as their doses increased. Also, hay NH3-N was lower in NaSP-O and PRP, with doses as low as 0.25%, relative to untreated hay (x¯=1.13 vs. 7.80% of N, respectively). Both NaSP-O and PRP increased digestible DM recovery (x¯=69.7) and total volatile fatty acids (x¯=94.3), with doses as low as 0.25%, compared with untreated hay (52.7% and 83.8 mM, respectively). However, ChNv did not decrease mold nor yeast counts (x¯=6.59 and x¯=6.16 log cfu/fresh g, respectively) and did not prevent DM losses relative to untreated hay. Overall, when using an alfalfa hay substrate in vitro, NaSP-O was able to prevent fungal spoilage to a similar extent to PRP. Thus, further studies are warranted to develop NaSP-O as a hay preservative under field conditions.
In our first experiment, we assessed the antifungal activity of two major types of byproducts, one known as lignosulfonates (5 types), which are generated by paper mills, and another known as chitosans (2 types), which are generated from shellfish. These were tested against four fungi isolated from spoiled hay. We observed that acidic conditions are not necessary for chitosans but are crucial to activate the antifungal properties of lignosulfonates. Also, we found that sodium lignosulfonate from Sappi Ltd. was the most antifungal relative to other sodium lignosulfonates from other manufacturers. Chitosans had stronger fungicidal activity than propionic acid or lignosulfonates against all but one mold tested. In our second experiment, we compared the best treatments from experiment 1 against propionic acid using alfalfa hay as a substrate to grow the same fungi tested in experiment 1. None of the doses of chitosan prevented spoilage on high moisture hay, showing results similar to untreated hay. In contrast, an optimized sodium lignosulfonate and propionic acid prevented fungal spoilage of alfalfa hay with doses as low as 0.25%.