Stability and intrinsic dissolution of vacuum compression molded amorphous solid dispersions of efavirenz.

In this study, the stability and intrinsic dissolution of vacuum compression molded (VCM) amorphous solid dispersions (ASDs) of efavirenz (EFV) were investigated in relation to its solubility limits in seven polymers determined by the melting point depression (MPD) method. The extrapolated solubility limits of EFV at 22 °C ranged from 3 to 68% (w/w) with PVOH being the only polymer suggesting immiscibility with EFV according to both MPD and Hansen solubility parameters (HSPs). All ASDs with EFV loadings below or close to their calculated solubility limit did not show any signs of crystallization upon conditioning for 7 months at either 22 or 37 °C and 23 or 75% relative humidity. However, all ASDs with EFV loading above the solubility limit crystallized at high humidity, while the ASDs with cellulose derived carrier polymers proved kinetically stable at low humidity over 7 months. While the EFV intrinsic dissolution rates from the VCM ASDs were partly depending on the polymer dissolution rate, no correlation was observed between EFV matrix crystallization and its miscibility in the polymer. Altogether, the observations of the study underline the importance of combining preformulation miscibility determination and dissolution studies to rationally decide on both stability and viability of ASD formulations.

Evaluation of the microbiological safety and sensory quality of a sliced cured-smoked pork product with protective cultures addition and modified atmosphere packaging.

The aim of this study was to evaluate the effect of two protective lactic acid bacteria cultures combined with modified atmosphere packaging on the survival/growth of Listeria innocua 2030c (as a surrogate for Listeria monocytogenes) and on sensory attributes of ready-to-eat 'lombo' over storage time. Sliced 'lombo', a traditional cured-smoked pork loin, was inoculated with L. innocua 2030c, Lactobacillus sakei ST153 (isolated from 'salpicão') and BLC35 culture (with Lactobacillus curvatus, Staphylococcus xylosus and Pediococcus acidilactici; CHR Hansen) as protective cultures. Samples were packed in two modified atmosphere packaging conditions (20% CO2/80% N2 and 40% CO2/60% N2) and stored at 5 ℃ for 124 days. Both cultures led to a reduction of 1-2 log CFU/g of L. innocua 2030c after 12 h; however, at the end of storage only Lb. sakei ST153 maintained this antilisterial effect, which was more evident at 40% CO2/60% N2. The influence of cultures addition and modified atmosphere packaging conditions on the sensory characteristics of the product were not significant. Thus, Lb. sakei ST153 combined with modified atmosphere packaging is a strong candidate to be used in a biopreservation strategy maintaining the traditional sensory quality of cured-smoked pork products and increasing their safety with respect to Listeria spp.

Vacuum sealing drainage: A novel treatment method for primary cutaneous Mycobacterium intracellulare infection.

The incidence of primary cutaneous Mycobacterium intracellulare infection is very low. We report a case of primary cutaneous M. intracellulare infection which presented as painful erythematous swelling of the right upper limb without systemic involvement. A novel technique of vacuum sealing drainage was successfully implemented after antimycobacterial treatment proved ineffective at the end of 3 months. Our technique also revealed some additional practical advantages.

Development of an environmentally acceptable volatile organic compounds recovery and reuse system based on vacuum spray flash with dibasic acid esters as absorbents.

We used dibasic acid esters as the absorbent for a volatile organic compounds (VOC) recovery and reuse system geared mainly toward VOCs from painting and presswork. The system consists of three elements: absorption using dibasic acid esters, separation by vacuum spray flash method, and recovery by condensation. The concentration of both ethyl acetate (EtAc) and isopropyl alcohol (IPA) decreased around 90% at room temperature. Vacuum spray flash was found as a useful process for cost-effective and energy-effective VOC removal system. The difference in the dissolubility parameters (Hansen constant) between dibasic acid esters and VOCs and the boiling point of VOCs was the main contributor to the separation behavior.