Investigation of mild steel corrosion inhibition in acidic media by Viola extract based on bulk and nanometer size.

In the present work, the inhibition performance of Viola extract based on bulk and nano size as a green corrosion inhibitor on mild steel in 0.5 M phosphoric acid and 1M hydrochloric acid solutions is investigated using different techniques (potentiodynamic polarization, electrochemical impedance spectroscopy (EIS) and Optical microscopy). The gained results demonstrated that various concentrations of Viola Extract (bulk and nano) inhibited the corrosion of the alloy in both of the acid solutions. The temperature impact on corrosion rate without/with this extract was examined. Certain thermodynamic parameters were determined based on the temperature impact on inhibition and corrosion processes. The adsorption mechanism of the extract on the alloy was explored using the Langmuir adsorption isotherm. A mixed mode of adsorption was observed, wherein the nano-sized extract in 1.0 M HCl predominantly underwent chemisorption, while the bulk-sized extract in 1.0 M HCl and both bulk and nano-sized extracts in 0.5 M H3PO4 were primarily subjected to physisorption. Scanning electron microscopy (SEM) and Optical microscopy analyses were employed to scrutinize alloys' surface morphology.

Experimental and theoretical investigation of mild steel corrosion control in acidic solution by Ranunculus arvensis and Glycine max extracts as novel green inhibitors.

In the present research, the ability of Ranunculus arvensis (RA) and Glycine max (GM) extracts as green corrosion inhibitors of mild steel (MS) in 1 M HCl was investigated. The inhibiting potential of RA and GM was analysed employing electrochemical impedance spectroscopy (EIS), polarization curves, potentiometry, and theoretical investigations. An enhancement in the inhibition efficiency (I.E) with increasing inhibitors concentrations indicated by EIS data and polarization curves. According to obtained results both extracts indicated inhibitory effect, with their effectiveness following the order of RA > GM. In addition, the interactions between the inhibitors on the MS surface were assessed using B3LYP/6-311g(d,p) theory level in liquid water phase. The interaction energies for three orientations of RA and GM depicted that inhibitors have located parallel to the alloy surface. The preferred complex orientation is one in which the maximum number of inhibitor donor atoms interacted with the alloy surface. Finally, experimental and theoretical results were in accordance which confirmed the inhibition effect of RA and GM extracts.

Characterization of a Laser Surface-Treated Martensitic Stainless Steel.

Laser surface treatment was carried out on AISI 416 machinable martensitic stainless steel containing 0.225 wt.% sulfur. Nd:YAG laser with a 2.2-KW continuous wave was used. The aim was to compare the physical and chemical properties achieved by this type of selective surface treatment with those achieved by the conventional treatment. Laser power of different values (700 and 1000 W) with four corresponding different laser scanning speeds (0.5, 1, 2, and 3 m•min-1) was adopted to reach the optimum conditions for impact toughness, wear, and corrosion resistance for laser heat treated (LHT) samples. The 0 °C impact energy of LHT samples indicated higher values compared to the conventionally heat treated (CHT) samples. This was accompanied by the formation of a hard surface layer and a soft interior base metal. Microhardness was studied to determine the variation of hardness values with respect to the depth under the treated surface. The wear resistance at the surface was enhanced considerably. Microstructure examination was characterized using optical and scanning electron microscopes. The corrosion behavior of the LHT samples was also studied and its correlation with the microstructures was determined. The corrosion data was obtained in 3.5% NaCl solution at room temperature by means of a potentiodynamic polarization technique.

Novel Polarizing Method for Light Microscopy.

A test of the qualities of polarizing filters was performed for a set of specimens including a bulk Nicol prism, standard polaroids, and special polyvinyl alcohol (PVA)-iodine thin-film filters coated on both sides by vertically oriented carbon nanotubes. The residual transmission of polarizing filters depending on the incidence angle of polarized light was examined in detail. The superior quality of polarizing film filters treated with carbon nanotubes was found. This fact allows us to propose a new application for polarizing films with carbon nanotubes for a polarizing cover glass. In such a way the cover glass may serve as an analyzer in a light polarizing microscope. Some features of optical scheme arrangement for the polarizing technique are discussed. The polarizing cover glass allows elimination of depolarization of light, which is inserted in a microscope objective. Test results of the proposed polarizing technique attest to the efficiency of using the polarizing cover glass. The new scheme for polaroid arrangement shows image-contrast enhancement by several percent in comparison with the standard layout.

Fundamental studies for the proton polarization technique in neutron protein crystallography.

The isotope effect in conventional neutron protein crystallography (NPC) can be eliminated by the proton polarization technique (ppt). Furthermore, the ppt can improve detection sensitivity of hydrogen (relative neutron scattering length of hydrogen) by approximately eight times in comparison with conventional NPC. Several technical difficulties, however, should be overcome in order to perform the ppt. In this paper, two fundamental studies to realise ppt are presented: preliminary trials using high-pressure flash freezing has shown the advantage of making bulk water amorphous without destroying the single crystal; and X-ray diffraction and liquid-chromatography/mass-spectrometry analyses of standard proteins after introducing radical molecules into protein crystals have shown that radical molecules could be distributed non-specifically around proteins, which is essential for better proton polarization.