Nanoconfinement effects on water in narrow graphene-based slit pores as revealed by THz spectroscopy.

The properties of water at interfaces have long been known to differ from those of bulk water in many distinctive ways. More recently, specific confinement effects different from mere interfacial effects have been discovered upon enclosing water in very narrow cylindrical pores and planar surfaces as offered by nanotubes and slit pores, respectively. Using experimental and theoretical THz spectroscopy, we elucidate nanoconfinement effects on the H-bond network of stratified water lamellae that are hosted within graphene-based two-dimensional pores. Characteristic confinement-induced changes of the THz response are traced back to the level of structural dynamics, notably distinct resonances due to intralayer and interlayer H-bonds at correspondingly low and high intermolecular stretching frequencies and impact of dangling (free) OH bonds at the water-graphene interface that enormously broaden the librational band in sufficiently narrow pores. The interplay of these molecular effects causes characteristic changes of the THz lineshape upon nanoconfining water.

Computational investigation of the role of ventricular remodelling in HFpEF: The key to phenotype dissection.

Recent clinical studies have reported that heart failure with preserved ejection fraction (HFpEF) can be divided into two phenotypes based on the range of ejection fraction (EF), namely HFpEF with higher EF and HFpEF with lower EF. These phenotypes exhibit distinct left ventricle (LV) remodelling patterns and dynamics. However, the influence of LV remodelling on various LV functional indices and the underlying mechanics for these two phenotypes are not well understood. To address these issues, this study employs a coupled finite element analysis (FEA) framework to analyse the impact of various ventricular remodelling patterns, specifically concentric remodelling (CR), concentric hypertrophy (CH), and eccentric hypertrophy (EH), with and without LV wall thickening on LV functional indices. Further, the geometries with a moderate level of remodelling from each pattern are subjected to fibre stiffening and contractile impairment to examine their effect in replicating the different features of HFpEF. The results show that with severe CR, LV could exhibit the characteristics of HFpEF with higher EF, as observed in recent clinical studies. Controlled fibre stiffening can simultaneously increase the end-diastolic pressure (EDP) and reduce the peak longitudinal strain (ell) without significant reduction in EF, facilitating the moderate CR geometries to fit into this phenotype. Similarly, fibre stiffening can assist the CH and 'EH with wall thickening' cases to replicate HFpEF with lower EF. These findings suggest that potential treatment for these two phenotypes should target the bio-origins of their distinct ventricular remodelling patterns and the extent of myocardial stiffening.

Graphene Oxide Dielectric Permittivity at GHz and Its Applications for Wireless Humidity Sensing.

In this work, the relative dielectric permittivity of graphene oxide (GO), both its real and imaginary parts, have been measured under various humidity conditions at GHz. It is demonstrated that the relative dielectric permittivity increases with increasing humidity due to water uptake. This finding is very different to that at a couple of MHz or lower frequency, where the relative dielectric permittivity increases with decreasing humidity. This GO electrical property was used to create a battery-free wireless radio-frequency identification (RFID) humidity sensor by coating printed graphene antenna with the GO layer. The resonance frequency as well as the backscattering phase of such GO/graphene antenna become sensitive to the surrounding humidity and can be detected by the RFID reader. This enables battery-free wireless monitoring of the local humidity with digital identification attached to any location or item and paves the way for low-cost efficient sensors for Internet of Things (IoTs) applications.

Tunable sieving of ions using graphene oxide membranes.

Graphene oxide membranes show exceptional molecular permeation properties, with promise for many applications. However, their use in ion sieving and desalination technologies is limited by a permeation cutoff of ∼9 Š(ref. 4), which is larger than the diameters of hydrated ions of common salts. The cutoff is determined by the interlayer spacing (d) of ∼13.5 Å, typical for graphene oxide laminates that swell in water. Achieving smaller d for the laminates immersed in water has proved to be a challenge. Here, we describe how to control d by physical confinement and achieve accurate and tunable ion sieving. Membranes with d from ∼9.8 Što 6.4 Šare demonstrated, providing a sieve size smaller than the diameters of hydrated ions. In this regime, ion permeation is found to be thermally activated with energy barriers of ∼10-100 kJ mol-1 depending on d. Importantly, permeation rates decrease exponentially with decreasing sieve size but water transport is weakly affected (by a factor of <2). The latter is attributed to a low barrier for the entry of water molecules and large slip lengths inside graphene capillaries. Building on these findings, we demonstrate a simple scalable method to obtain graphene-based membranes with limited swelling, which exhibit 97% rejection for NaCl.