Quantum dots at room temperature carved out from few-layer graphene.

We present graphene quantum dots endowed with addition energies as large as 1.6 eV, fabricated by the controlled rupture of a graphene sheet subjected to a large electron current in air. The size of the quantum dot islands is estimated to be in the 1 nm range. The large addition energies allow for Coulomb blockade at room temperature, with possible application to single-electron devices.

Lattice expansion in seamless bilayer graphene constrictions at high bias.

Our understanding of sp(2) carbon nanostructures is still emerging and is important for the development of high performance all carbon devices. For example, in terms of the structural behavior of graphene or bilayer graphene at high bias, little to nothing is known. To this end, we investigated bilayer graphene constrictions with closed edges (seamless) at high bias using in situ atomic resolution transmission electron microscopy. We directly observe a highly localized anomalously large lattice expansion inside the constriction. Both the current density and lattice expansion increase as the bilayer graphene constriction narrows. As the constriction width decreases below 10 nm, shortly before failure, the current density rises to 4 × 10(9) A cm(-2) and the constriction exhibits a lattice expansion with a uniaxial component showing an expansion approaching 5% and an isotropic component showing an expansion exceeding 1%. The origin of the lattice expansion is hard to fully ascribe to thermal expansion. Impact ionization is a process in which charge carriers transfer from bonding states to antibonding states, thus weakening bonds. The altered character of C-C bonds by impact ionization could explain the anomalously large lattice expansion we observe in seamless bilayer graphene constrictions. Moreover, impact ionization might also contribute to the observed anisotropy in the lattice expansion, although strain is probably the predominant factor.

Room-temperature gating of molecular junctions using few-layer graphene nanogap electrodes.

We report on a method to fabricate and measure gateable molecular junctions that are stable at room temperature. The devices are made by depositing molecules inside a few-layer graphene nanogap, formed by feedback controlled electroburning. The gaps have separations on the order of 1-2 nm as estimated from a Simmons model for tunneling. The molecular junctions display gateable I-V-characteristics at room temperature.

Structured graphene devices for mass transport.

The reversible atomic-mass transport along graphene devices has been achieved. The motion of Al and Au in the form of atoms or clusters is driven by applying an electric field between the metal electrodes that contact the graphene sheet. It is shown that Al moves in the direction of the applied electric field whereas Au tends to diffuse in all directions. The control of the motion of Al is further demonstrated by achieving a 90° turn, using a graphene device patterned in a crossroads configuration. The controlled motion of Al is attributed to the charge transfer from Al onto the graphene so that the Al is effectively charged and can be accelerated by the applied electric field. To get further insight into the actuation mechanism, theoretical simulations of individual Al and Au impurities on a perfect graphene sheet were performed. The direct (electrostatic) force was found to be ∼1 pN and dominant over the wind force. These findings hold promise for practical use in future mass transport in complex circuits.

Thermal decomposition of ferrocene as a method for production of single-walled carbon nanotubes without additional carbon sources.

A new method to grow bulk quantities of single-walled carbon nanotubes (SWCNTs) by a catalytic chemical vapor deposition (CVD) process with the possibility of varying the pressure has been developed and is reported in this paper. Thermal decomposition of ferrocene provides both catalytic particles and carbon sources for SWCNT growth using Ar as a carrier gas. Upon an increase in the pressure, the mean diameter of the SWCNTs decreases. In fact, high abundances of SWCNT with diameters as small as 0.7 nm, which is the limit for stable caps with isolated pentagons, can be obtained. An additional advantage of this method is that as no external carbon sources are required, SWCNT synthesis can be achieved at temperatures as low as 650 degrees C.

Transport properties of graphene in the high-current limit.

We present a detailed study of the high-current transport properties of graphene devices patterned in a four-point configuration. The current tends to saturate as the voltage across graphene is increased but never reaches the complete saturation as in metallic nanotubes. Measurements are compared to a model based on the Boltzmann equation, which includes electron-scattering processes due to charged and neutral impurities, and graphene optical phonons. The saturation is incomplete because of the competition between disorder and optical phonon scattering.

Electron counting spectroscopy of CdSe quantum dots.

We report on the electronic properties of semiconducting CdSe quantum dots that can be filled or emptied with many electrons. To accomplish that, we employ a device layout where the investigated quantum dot is attached to only one electrode, a carbon nanotube. Measurements consist of detecting individual electrons transferred onto the quantum dot (by monitoring the nanotube resistance) while sweeping the electrochemical potential of the dot with a gate. This technique allows us to detect the energy gap of the semiconducting quantum dot and to access many electronic levels. We exploit the latter finding to study the statistical aspects of the spectrum of the quantum dot. The measured spectrum distribution approaches the bimodal Wigner distribution, which is the most basic prediction of the random matrix theory applied to quantum dots.

Subnanometer motion of cargoes driven by thermal gradients along carbon nanotubes.

An important issue in nanoelectromechanical systems is developing small electrically driven motors. We report on an artificial nanofabricated motor in which one short carbon nanotube moves relative to another coaxial nanotube. A cargo is attached to an ablated outer wall of a multiwalled carbon nanotube that can rotate and/or translate along the inner nanotube. The motion is actuated by imposing a thermal gradient along the nanotube, which allows for subnanometer displacements, as opposed to an electromigration or random walk effect.