RESUMEN
Copper contaminant generated from mining and industrial smelting poses potential risks to human health. Biochar, as a low-energy and cost-effective biomaterial, holds value in Cu remediation. Spectral Induced Polarization (SIP) technique is employed in this study to monitor the Cu remediation processes of by biochar in column experiments. Cation exchange at low Cu2+ concentrations and surface complexation at high Cu2+ concentrations are identified as the major mechanisms for copper retention on biochar. The normalized chargeability (mn) from SIP signals linearly decreased (R2 = 0.776) with copper retention under 60 mg/L Cu influent; while mn linearly increases (R2 = 0.907, 0.852) under high 300 and 700 mg/L Cu influents. The characteristic polarizing unit sizes (primarily the pores adsorbing Cu2+) calculated from Schwartz equation match well with experimental results by mercury intrusion porosimetry (MIP). It is revealed that Cu2+ was driven to small pores (â¼3 µm) given high concentration gradient (influent Cu2+ concentration of 700 mg/L). Comparing to activated carbon, biochar is identified as an ideal adsorbent for Cu remediation, given its high adsorption capacity, cost-effectiveness, carbon-sink ability, and high sensitivity to SIP responses - the latter facilitates its performance assessment.
Asunto(s)
Carbón Orgánico , Cobre , Cobre/química , Carbón Orgánico/química , Adsorción , Restauración y Remediación Ambiental/métodos , Contaminantes Químicos del Agua/química , Contaminantes Químicos del Agua/análisisRESUMEN
The municipal solid waste (MSW) landfill in Hangzhou, China utilized zeolite and activated carbon (AC) as permeable reactive barrier (PRB) fill materials to remediate groundwater contaminated with MSW leachates containing ammonium, chemical oxygen demand (COD), and heavy metals. The spectral induced polarization (SIP) technique was chosen for monitoring the PRB because of its sensitivity to pore fluid chemistry and mineral-fluid interface composition. During the experiment, authentic groundwater collected from the landfill site was used to permeate two columns filled with zeolite and AC, and the SIP responses were measured at the inlet and outlet over a frequency range of 0.01-1000 Hz. The results showed that zeolite had a higher adsorption capacity for COD (7.08 mg/g) and ammonium (9.15 mg/g) compared to AC (COD: 2.75 mg/g, ammonium: 1.68 mg/g). Cation exchange was found to be the mechanism of ammonium adsorption for both zeolite and AC, while FTIR results indicated that π-complexation, π-π interaction, and electrostatic attraction were the main mechanisms of COD adsorption. The Cole-Cole model was used to fit the SIP responses and determine the relaxation time (τ) and normalized chargeability (mn). The calculated characteristic diameters of zeolite and AC based on the Schwarz equation and relaxation time (τ) matched the pore sizes observed from SEM and MIP, providing valuable information on contaminant distribution. The mn of zeolite was positively linear with adsorbed ammonium (R2 = 0.9074) and COD (R2 = 0.8877), while the mn of AC was negatively linear with adsorbed ammonium (R2 = 0.8192) and COD (R2 = 0.7916), suggesting that mn could serve as a surrogate for contaminant saturation. The laboratory-based real-time non-invasive SIP results showed good performance in monitoring saturation and provide a strong foundation for future field PRB monitoring.