Review in anaerobic digestion of food waste.

Due to the special property of food waste (FW), anaerobic digestion of food waste is facing many challenges like foaming, acidification, ammonia nitrogen and (NH4+-N) inhibition which resulted in a low biogas yield. A better understanding on the problems exiting in the FW anaerobic digestion would enhance the bio-energy recovery and increase the stable operation. Meanwhile, to overcome the bottle necks, pretreatment, co-digestion and additives is proposed as well as the solutions to improve biogas yield in FW digestion system. At last, future research directions regarding FW anaerobic digestion were proposed.

Deep-eutectic-solvent modulation of self-assembled multi-responsive films based on polyvinyl alcohol/cellulose nanocrystal and grape skin red for highly sensitive food monitoring.

To enhance the mechanics performance, sensitivity and response range of multi-responsive photonic films, herein, a facile method for fabricating multi-responsive films is demonstrated using the evaporative self-assembly of a mixture of grape skin red (GSR), cellulose nanocrystal (CNC), polyvinyl alcohol (PVA) and deep eutectic solvent (DES). The prepared materials exhibited excellent thermal stability, strain properties, solvent resistance, ultraviolet (UV) resistance and antioxidant activity. Compared to a pure PVA film, the presence of GSR strengthened the antioxidant property of the film by 240.1 % and provided excellent UV barrier capability. The additional cross-linking of DES and CNC promoted more efficient phase fusion, yielding a film strain of 41.5 %. The addition of hydrophilic compound GSR, wetting and swelling due to the DES and the surface inhomogeneity of the films rendered the multi-responsive films high sensitivity, wide response range and multi-cyclic stability in environments with varying pH and humidity. A sample application showed that a PVA/CNC/DES film has the potential to differentiate between fresh, sub-fresh and fully spoiled shrimps. The above results help in designing intelligent thin film materials that integrate antioxidant properties, which help in monitoring the changes in food freshness and food packaging.

Ammonium nitrogen removal in batch cultures treating digested piggery wastewater with microalgae Oedogonium sp.

Due to the nutrient characteristics of the high concentration of available ammonium in digested piggery wastewater (DPW), microalgae can be used to treat DPW before its final discharge. Four green microalgae (Hydrodictyaceae reticulatum Lag, Scenedesmus obliquus, Oedogonium sp. and Chlorella pyrenoidosa) and three blue-green algae (Anabaena flos-aquae, Oscillatoria amoena Gom and Spirulina platensis) were used to remove the nutrients (N, P, C), especially ammonium nitrogen (NH4(+)-N), from diluted DPW with 300 mg/L algae density in batch tests. The microalgae with the best NH4(+)-N nutrient removal was then selected for further optimization of the variables to improve NH4(+)-N removal efficiency using a central composite design (CCD) experiment. Taking into account the nutrient removal efficiency, Oedogonium sp. showed the best performance (reduction of 95.9% NH4(+)-N, 92.9% total phosphorus (TP) and 62.5% chemical oxygen demand (COD)) based on the results of the batch tests. The CCD results suggested that the optimal values of variables were initial Oedogonium sp. density of 399.2 mg/L and DPW diluted by 16.3, while the predicted value of NH4(+)-N removal efficiency obtained was 97.0%.

Enhancing anaerobic digestion of sulphate wastewater by adding nano-zero valent iron.

In this paper, the effects of nano-zero valent iron (nZVI) on anaerobic digestion of sulphate wastewater with different SO42-/COD ratios, including the COD removal rate, methane yield, intermediate products and the change of microbial community structure, were investigated. The results showed that nZVI could effectively enhance the treatment efficiency and methane yield. Compared with the control group without nZVI, the methane yield increased from 348.6833 to 1007.05 mL CH4/gCODremoval with 4 g nZVI loading at SO42-/COD = 0.1. nZVI could make electron flow from sulphate reduction to methane production, which increased methane yield even at high sulphate concentration. The microbial community analysis showed that adding nZVI could increase the abundance of acetoclastic methanogens, which accelerated hydrolysis acidification.

Insight into the differences in carbon dots prepared from fish scales using conventional hydrothermal and microwave methods.

The preparation of carbon dots (CDs) from waste fish scales is an attractive and high-value transformation. In this study, fish scales were used as a precursor to prepare CDs, and the effects of hydrothermal and microwave methods on their fluorescence properties and structures were evaluated. The microwave method was more conducive to the self-doping of nitrogen due to rapid and uniform heating. However, the low temperature associated with the microwave method resulted in insufficient dissolution of the organic matter in the fish scales, resulting in incomplete dehydration and condensation and the formation of nanosheet-like CDs, whose emission behavior had no significant correlation with excitation. Although the CDs prepared using the conventional hydrothermal method showed lower nitrogen doping, the relative pyrrolic nitrogen content was higher, which was beneficial in improving their quantum yield. Additionally, the controllable high temperature and sealed environment used in the conventional hydrothermal method promoted dehydration and condensation of the organic matter in the fish scales to form CDs with a higher degree of carbonization, uniform size, and higher C = O/COOH content. CDs prepared using the conventional hydrothermal method exhibited higher quantum yields and excitation wavelength-dependent emission behavior.

Preparation of biodegradable composite films based on carboxymethylated holocellulose from wheat straw.

Holocellulose was extracted from wheat straw and catalytically transformed into carboxymethylated holocellulose (CMHCS) to prepare a biodegradable composite film. By changing the type and amount of catalyst, the carboxymethylation of the holocellulose was optimized with respect to the degree of substitution (DS). A high DS of 2.46 was achieved in the presence of a cocatalyst composed of polyethylene glycol and cetyltrimethylammonium bromide. The effect of DS on the properties of CMHCS-derived biodegradable composite films was further investigated. Compared to pristine holocellulose, the mechanical properties of the composite film were significantly improved and increased with increasing DS. The tensile strength, elongation at break, and Young's modulus increased from 6.58 MPa, 51.4 %, and 26.13 MPa for the unmodified holocellulose-based composite film to 14.81 MPa, 89.36 %, and 81.73 MPa for the film derived from the CMHCS with a DS of 2.46. The biodegradability of the composite film was assessed under soil burial biodisintegration conditions and reached 71.5 % degradation after 45 d. Additionally, a possible degradation process for the composite film was proposed. The results indicated that the CMHCS-derived composite film has good comprehensive performance, and CMHCS is expected to be applied in the field of biodegradable composite materials.

Anaerobic digestion of sulphate wastewater mediated by biochar.

In this paper, the influences of biochar on the anaerobic digestion of sulphate wastewater, including the COD removal rate, methane yield, intermediate products and the change of microbial community structure, were investigated. The results showed that sulphate could promote the anaerobic digestion with the SO42-/COD ratio increasing from 0 to 0.1, while the activity of MPB was inhibited, which led to the decrease of COD removal rate and methane yield with the SO42-/COD ratio increasing from 0.1 to 2. At 1 g biochar loading, 344.97 mL CH4/gCODremoval was obtained compared with the control group (220.70 CH4/gCODremoval) at 2 of SO42-/COD. Biochar could also reduce the secondary accumulation of NH4+-N and TVFA. Meanwhile, methanogenic microorganisms were selectively enriched especially for methanobacterium, methanosaeta and methanolinea, while the growth of SRB was inhibited with biochar addition.

Influence of surfactant on CO2 adsorption of amine-functionalized MCM-41.

Concerning the increasing greenhouse effect, the development of efficient CO2 adsorbents is very important. In this study, the influence of surfactant on the adsorption performance of amine-functionalized MCM-41 was analysed. The results showed that the residual amount of surfactant in MCM-41 was gradually decreased with the increase of calcination temperature which improved the pore structure. The maximum adsorption capacity (5.495 mmol/g) appeared at PEI-MCM-41-100°C indicated that the adsorption capacity could be improved under the function of surfactant. By calculating the diffusion coefficient of CO2 adsorption process in PEI-MCM-41-100/200/300/400/550°C, the diffusion resistance of CO2 was the lowest in PEI-MCM-41-100°C, which directly proved that the synergism of surfactant and organic amine could reduce the diffusion resistance of CO2 in the pore.

Oxidative conversion of lignin isolated from wheat straw into aromatic compound catalyzed by NaOH/NaAlO2.

Lignin was isolated from wheat straw via organosolv process and further transferred to monophenolic compounds via oxidative conversion. Wheat straw lignin (WSL) with purity at 91.4 wt% was acquired in the presence of heterogeneous and recyclable catalyst of Amberlyst-45. WSL was characterized by infrared spectrometer (IR), nuclear magnetic resonance spectroscopy (NMR) including 1H NMR and 13C NMR spectra. The results showed that WSL possesses typical syringyl (S), guaiacyl (G), and p-hydroxyphenyl (H) units, and it is mainly composed of S and G units. The product distribution was dependent on the composition of WSL. Derivatives from S and G units were found to be the main products. The oxidative conversion of WSL was performed by varying oxidant and catalyst. Both the formation of monophenolic compounds and aromatic aldehydes were enhanced by combining oxidants and catalysts. The composite catalyst composed of NaOH/NaAlO2 was effective for the oxidation of WSL in the presence of nitrobenzene and atmospheric pressure air. The total yield of monophenolic compounds reached up 18.1%, and yields at 6.3 and 5.7% for syringaldehyde and vanillin were achieved, respectively.

Preparing high purity white carbon black from rice husk.

In this paper, rice husk (RH) was used as raw material to prepare white carbon black, and the key technological parameters of preparing white carbon black from RH were studied through single-factor test, orthogonal experiment, and response surface analysis. Meanwhile, the characteristic of white carbon black was also analyzed. Through orthogonal experiment analysis, it was confirmed that the order of factors affecting the purity of white carbon black was calcination temperature > alkali treatment time > final pH > surfactant. Based on the response surface optimization analysis, the optimum parameters for preparation of white carbon black were as follows: calcination temperature 610°C, alkali treatment time of 2.3 hr, final pH of 10, CTMAB was used as the surfactant. Under this condition, the purity of silica prepared could be reached to 99.39%, and the particle size was uniform, spherical, and well dispersed, which satisfied the requirements of GB/T 34698-2017 standard.

Nutrients removal from the secondary effluents of municipal domestic wastewater by Oscillatoria tenuis and subsequent co-digestion with pig manure.

Batch experiments were carried out to investigate the performance of Oscillatoria tenuis to remove nitrogen, phosphorus and chemical oxygen demand (COD) from secondary effluents of municipal domestic wastewater. Meanwhile the potential of biogas production by collected O. tenuis co-digested with pig manure was also investigated. O. tenuis had a biomass productivity of 150 mg L-1 d-1, a removal rate of [Formula: see text] (96.1%), total phosphorus (82.9%) and COD (92.6%) within 7 d at an aeration rate of 1.0 L/min. The biochemical methane potential (BMP) test for O. tenuis fermented with pig manure was evaluated at three different ratios. The cumulative methane yield was 183 mL CH4/gVSadd at a mixing ratio (MR) of 3.0, 191 mL CH4/gVSadd at a MR of 2.0 and 84 mL CH4/gVSadd at a MR of 1.0. The maximum methane yield appeared at the ratio of 2.0. Meanwhile, acid-, alkali- and thermal-pretreatments were applied to raw microalgae biomass to promote biogas production. The highest methane productivity (256 mL CH4/gVSadd) was achieved by the thermal-pretreatment at 120°C, which was about 1.5 times higher than the non-pretreatment group (191 mL CH4/g VSadd).

Study on the adsorption of nitrogen and phosphorus from biogas slurry by NaCl-modified zeolite.

A NaCl-modified zeolite was used to simultaneously remove nitrogen and phosphate from biogas slurry. The effect of pH, contact time and dosage of absorbants on the removal efficiency of nitrogen and phosphate were studied. The results showed that the highest removal efficiency of NH4+-N (92.13%) and PO43--P (90.3%) were achieved at pH 8. While the zeolite doses ranged from 0.5 to 5 g/100 ml, NH4+-N and PO43--P removal efficiencies ranged from 5.19% to 94.94% and 72.16% to 91.63% respectively. The adsorption isotherms of N and P removal with NaCl-modified zeolite were well described by Langmuir models, suggesting the homogeneous sorption mechanisms. While through intra-particle diffusion model to analyze the influence of contact time, it showed that the adsorption process of NH4+-N and PO43--P followed the second step of intra-particle diffusion model. The surface diffusion adsorption step was very fast which was finished in a short time.