RESUMEN
The unprecedented nature of the Deepwater Horizon oil spill required the application of research methods to estimate the rate at which oil was escaping from the well in the deep sea, its disposition after it entered the ocean, and total reservoir depletion. Here, we review what advances were made in scientific understanding of quantification of flow rates during deep sea oil well blowouts. We assess the degree to which a consensus was reached on the flow rate of the well by comparing in situ observations of the leaking well with a time-dependent flow rate model derived from pressure readings taken after the Macondo well was shut in for the well integrity test. Model simulations also proved valuable for predicting the effect of partial deployment of the blowout preventer rams on flow rate. Taken together, the scientific analyses support flow rates in the range of â¼50,000-70,000 barrels/d, perhaps modestly decreasing over the duration of the oil spill, for a total release of â¼5.0 million barrels of oil, not accounting for BP's collection effort. By quantifying the amount of oil at different locations (wellhead, ocean surface, and atmosphere), we conclude that just over 2 million barrels of oil (after accounting for containment) and all of the released methane remained in the deep sea. By better understanding the fate of the hydrocarbons, the total discharge can be partitioned into separate components that pose threats to deep sea vs. coastal ecosystems, allowing responders in future events to scale their actions accordingly.
RESUMEN
Marine seismic surveys are under increasing scrutiny because of concern that they may disturb or otherwise harm marine mammals and impede their communications. Most of the energy from seismic surveys is low frequency, so concerns are particularly focused on baleen whales. Extensive mitigation efforts accompany seismic surveys, including visual and acoustic monitoring, but the possibility remains that not all animals in an area can be observed and located. One potential way to improve mitigation efforts is to utilize the seismic hydrophone streamer to detect and locate calling baleen whales. This study describes a method to localize low frequency sound sources with data recoded by a streamer. Beamforming is used to estimate the angle of arriving energy relative to sub-arrays of the streamer which constrains the horizontal propagation velocity to each sub-array for a given trial location. A grid search method is then used to minimize the time residual for relative arrival times along the streamer estimated by cross correlation. Results from both simulation and experiment are shown and data from the marine mammal observers and the passive acoustic monitoring conducted simultaneously with the seismic survey are used to verify the analysis.
Asunto(s)
Acústica , Monitoreo del Ambiente/métodos , Geología/métodos , Ruido/efectos adversos , Vocalización Animal , Ballenas/fisiología , Acústica/instrumentación , Animales , Simulación por Computador , Exposición a Riesgos Ambientales/efectos adversos , Monitoreo del Ambiente/instrumentación , Geología/instrumentación , Análisis Numérico Asistido por Computador , Procesamiento de Señales Asistido por Computador , Espectrografía del Sonido , Transductores , Ballenas/clasificaciónRESUMEN
Shallow water marine seismic surveys are necessary to understand a range of Earth processes in coastal environments, including those that represent major hazards to society such as earthquakes, tsunamis, and sea-level rise. Predicting the acoustic radiation of seismic sources in shallow water, which is required for compliance with regulations designed to limit impacts on protected marine species, is a significant challenge in this environment because of variable reflectivity due to local geology, and the susceptibility of relatively small bathymetric features to focus or shadow acoustic energy. We use data from the R/V Marcus G. Langseth's towed hydrophone streamer to estimate the acoustic radiation of the ship's seismic source during a large survey of the shallow shelf off the coast of New Jersey. We use the results to estimate the distances from the source to acoustic levels of regulatory significance, and use bathymetric data from the ship's multibeam system to explore the relationships between seafloor depth and slope and the measured acoustic radiation patterns. We demonstrate that existing models significantly overestimate mitigation radii, but that the variability of received levels in shallow water suggest that in situ real-time measurements would help improve these estimates, and that post-cruise revisions of received levels are valuable in accurately determining the potential acoustic impact of a seismic survey.
Asunto(s)
Acústica/instrumentación , Geología/instrumentación , Procesamiento de Señales Asistido por Computador/instrumentación , Geología/métodos , Humanos , New Jersey , Técnicas Fotoacústicas/instrumentación , Agua de Mar , SonidoRESUMEN
To fully understand the environmental and ecological impacts of the Deepwater Horizon disaster, an accurate estimate of the total oil released is required. We used optical plume velocimetry to estimate the velocity of fluids issuing from the damaged well both before and after the collapsed riser pipe was removed. We then calculated the volumetric flow rate under a range of assumptions. With a liquid oil fraction of 0.4, we estimated that the average flow rate from 22 April 2010 to 3 June 2010 was 5.6 × 10(4) ± 21% barrels/day (1.0 × 10(-1) meter(3)/second), excluding secondary leaks. After the riser was removed, the flow was 6.8 × 10(4) ± 19% barrels/day (1.2 × 10(-1) meters(3)/second). Taking into account the oil collected at the seafloor, this suggests that 4.4 × 10(6) ± 20% barrels of oil (7.0 × 10(5) meters(3)) was released into the ocean.
RESUMEN
Hydrothermal flow through seafloor black smoker vents is typically turbulent and vigorous, with speeds often exceeding 1 m/s. Although theory predicts that these flows will generate sound, the prevailing view has been that black smokers are essentially silent. Here we present the first unambiguous field recordings showing that these vents radiate significant acoustic energy. The sounds contain a broadband component and narrowband tones which are indicative of resonance. The amplitude of the broadband component shows tidal modulation which is indicative of discharge rate variations related to the mechanics of tidal loading. Vent sounds will provide researchers with new ways to study flow through sulfide structures, and may provide some local organisms with behavioral or navigational cues.