In situ coarsening study of inverse micelle-prepared Pt nanoparticles supported on γ-Al2O3: pretreatment and environmental effects.

The thermal stability of inverse micelle prepared Pt nanoparticles (NPs) supported on nanocrystalline γ-Al(2)O(3) was monitored in situ under different chemical environments (H(2), O(2), H(2)O) via extended X-ray absorption fine-structure spectroscopy (EXAFS) and ex situ via scanning transmission electron microscopy (STEM). Drastic differences in the stability of identically synthesized NP samples were observed upon exposure to two different pre-treatments. In particular, exposure to O(2) at 400 °C before high temperature annealing in H(2) (800 °C) was found to result in the stabilization of the inverse micelle prepared Pt NPs, reaching a maximum overall size after moderate coarsening of ∼1 nm. Interestingly, when an analogous sample was pre-treated in H(2) at ∼400 °C, a final size of ∼5 nm was reached at 800 °C. The beneficial role of oxygen in the stabilization of small Pt NPs was also observed in situ during annealing treatments in O(2) at 450 °C for several hours. In particular, while NPs of 0.5 ± 0.1 nm initial average size did not display any significant sintering (0.6 ± 0.2 nm final size), an analogous thermal treatment in hydrogen leads to NP coarsening (1.2 ± 0.3 nm). The same sample pre-dosed and annealed in an atmosphere containing water only displayed moderate sintering (0.8 ± 0.3 nm). Our data suggest that PtO(x) species, possibly modifying the NP/support interface, play a role in the stabilization of small Pt NPs. Our study reveals the enhanced thermal stability of inverse micelle prepared Pt NPs and the importance of the sample pre-treatment and annealing environment in the minimization of undesired sintering processes affecting the catalytic performance of nanosized particles.

Clinical response of newly diagnosed HIV seropositive & seronegative pulmonary tuberculosis patients with the RNTCP Short Course regimen in Pune, India.

BACKGROUND & OBJECTIVES: In the Revised National Tuberculosis Control Programme (RNTCP) in India prior to 2005, TB patients were offered standard DOTS regimens without knowledge of HIV status. Consequently such patients did not receive anti-retroviral therapy (ART) and the influence of concomitant HIV infection on the outcome of anti-tuberculosis treatment remained undetermined. This study was conducted to determine the results of treatment of HIV seropositive pulmonary tuberculosis patients with the RNTCP (DOTS) regimens under the programme in comparison with HIV negative patients prior to the availability of free ART in India. METHODS: Between September 2000 and July 2006, 283 newly diagnosed pulmonary TB patients were enrolled in the study at the TB Outpatient Department at the Talera Hospital in the Pimpri Chinchwad Municipal Corporation area at Pune (Maharashtra): they included 121 HIV seropositive and 162 HIV seronegative patients. They were treated for tuberculosis as per the RNTCP in India. This study was predominantly conducted in the period before the free ART become available in Pune. RESULTS: At the end of 6 months of anti-TB treatment, 62 per cent of the HIV seropositive and 92 per cent of the HIV negative smear negative patients completed treatment and were asymptomatic; among smear positive patients, 70 per cent of the HIV-seropositive and 81 per cent of HIV seronegative pulmonary TB patients were cured. Considering the results in the smear positive and smear negative cases together, treatment success rates were substantially lower in HIV positive patients than in HIV negative patients, (66% vs 85%). Further, 29 per cent of HIV seropositive and 1 per cent of the HIV seronegative patients expired during treatment. During the entire period of 30 months, including 6 months of treatment and 24 months of follow up, 61 (51%) of 121 HIV positive patients died; correspondingly there were 6 (4%) deaths among HIV negative patients. INTERPRETATION & CONCLUSIONS: The HIV seropositive TB patients responded poorly to the RNTCP regimens as evidenced by lower success rates with chemotherapy and high mortality rates during treatment and follow up. There is a need to streamline the identification and management of HIV associated TB patients in the programme with provision of ART to achieve high cure rates for TB, reducing mortality rates and ensuring a better quality of life.

Density functional theory based screening of ternary alkali-transition metal borohydrides: a computational material design project.

We present a computational screening study of ternary metal borohydrides for reversible hydrogen storage based on density functional theory. We investigate the stability and decomposition of alloys containing 1 alkali metal atom, Li, Na, or K (M(1)); and 1 alkali, alkaline earth or 3d/4d transition metal atom (M(2)) plus two to five (BH(4))(-) groups, i.e., M(1)M(2)(BH(4))(2-5), using a number of model structures with trigonal, tetrahedral, octahedral, and free coordination of the metal borohydride complexes. Of the over 700 investigated structures, about 20 were predicted to form potentially stable alloys with promising decomposition energies. The M(1)(Al/Mn/Fe)(BH(4))(4), (Li/Na)Zn(BH(4))(3), and (Na/K)(Ni/Co)(BH(4))(3) alloys are found to be the most promising, followed by selected M(1)(Nb/Rh)(BH(4))(4) alloys.

India's Revised National Tuberculosis Control Programme: looking beyond detection and cure.

SETTING: Pune District, Maharashtra State, India. OBJECTIVES: To examine delays experienced by patients in accessing directly observed treatment. DESIGN: Data were collected from 117 new sputum-positive patients using a semi-structured interview schedule. RESULTS: Patient delays as well as diagnostic and treatment delays, which reflect the performance of a National TB Programme, were minimal. Provider delays, however, contributed significantly to delayed entry into India's Revised National TB Control Programme (RNTCP). Patients had to resort to multiple contacts with providers due to limitations of these providers in diagnosing or directing patients to the RNTCP. Patients who consulted a private provider participating in the public-private mix (PPM) were more likely to be suspected (OR 2.63, 90% CI 1.04-6.64) and referred (OR 6.8, 95%CI 2.08-22.21) to the RNTCP. Once the patients entered the RNTCP, the response of the system was rapid, with diagnosis offered and treatment initiated within on average 7 days. CONCLUSION: Interventions aimed at providers to encourage early suspicion and referral to the RNTCP, such as the PPM, are more important in improving patient access to TB care than those focusing on reducing patient delays.

Isotopic study of intraseasonal variations of plant transpiration: an alternative means to characterise the dry phases of monsoon.

The isotopic characteristics of plant transpired water are strongly controlled by soil evaporation process, primarily by relative humidity. The monsoon system is characterised by large variability of several atmospheric parameters; the primary one being the rainfall, which in turn, modulates the relative humidity. Due to the strong dependency of transpiration on relative humidity, it is expected that this process would vary in accordance with the active and break periods of the monsoon season, which are known to produce cycles of humid and relatively dry phases during a monsoon season. To study the transpiration process, an experiment was conducted wherein rainwater and transpired water were collected from a few plants and analyzed for their isotopic ratios during the summer monsoon seasons of 2016 and 2017. The difference between the isotopic characteristics of the transpired water and rain water is expected to be nominally positive, however, a large variability was observed. This difference is found to be high (low) during the reduced (enhanced) humidity conditions and varies in tandem with the break and active phases of the monsoon season. This characteristic feature may thus be used to delineate the dry and wet phases of monsoon on local to regional scale.

Atmospheric controls on the precipitation isotopes over the Andaman Islands, Bay of Bengal.

Isotopic analysis of precipitation over the Andaman Island, Bay of Bengal was carried out for the year 2012 and 2013 in order to study the atmospheric controls on rainwater isotopic variations. The oxygen and hydrogen isotopic compositions are typical of the tropical marine sites but show significant variations depending on the ocean-atmosphere conditions; maximum depletion was observed during the tropical cyclones. The isotopic composition of rainwater seems to be controlled by the dynamical nature of the moisture rather than the individual rain events. Precipitation isotopes undergo systematic depletions in response to the organized convection occurring over a large area and are modulated by the integrated effect of convective activities. Precipitation isotopes appear to be linked with the monsoon intraseasonal variability in addition to synoptic scale fluctuations. During the early to mid monsoon the amount effect arose primarily due to rain re-evaporation but in the later phase it was driven by moisture convergence rather than evaporation. Amount effect had distinct characteristics in these two years, which appeared to be modulated by the intraseasonal variability of monsoon. It is shown that the variable nature of amount effect limits our ability to reconstruct the past-monsoon rainfall variability on annual to sub-annual time scale.

Thermal coarsening of supported palladium combustion catalysts.

An essential property of combustion catalysts is long-term (>8000 h) stability at high temperatures in an environment (approximately 1 atm of both oxygen and water vapor) that aggressively promotes sintering of the supporting oxide and coarsening of the active component. Extrapolation of accelerated coarsening rate measurements, determined from shorter exposures at higher temperatures, can be made with more confidence if the physical processes of the coarsening and sintering processes were well understood. The current work examines in detail the coarsening of a high-weight-loaded palladium catalyst supported by silica-stabilized alumina at 900 degrees C in such an aggressive environment. The results of this investigation showed that the Pd particle size distribution was consistently log-normal for time periods from 100 to 4000 h, the mean particle growth rate was roughly inverse second-order in mean particle diameter, and the support not only sintered but also underwent phase transformation. The results implicate both coalescence and Ostwald ripening as important coarsening processes.