RESUMEN
Oxaliplatin loaded PLAGA microspheres have been prepared by solvent extraction process. Parameters affecting the release kinetics in vitro have been studied in order to design specific release profiles suitable for direct intra-tumoral injection. By varying the nature and the relative proportions of different polymers we managed to prepare microspheres with good encapsulation efficiency (75-90%) and four different release profiles: zero order kinetics (type II) and the classical sigmoïd release profile with three different sizes of plateau and burst. These results, if correlated with in vivo activity, are promising to enhance effectiveness of local tumor treatment.
Asunto(s)
Antineoplásicos/administración & dosificación , Ácido Láctico/química , Compuestos Organoplatinos/administración & dosificación , Ácido Poliglicólico/química , Polímeros/química , Preparaciones de Acción Retardada , Composición de Medicamentos , Excipientes , Cinética , Microscopía Electrónica de Rastreo , Microesferas , Oxaliplatino , Tamaño de la Partícula , Copolímero de Ácido Poliláctico-Ácido Poliglicólico , SolubilidadRESUMEN
The determination of in vitro release kinetics of peptides from poly(d,l-lactide-co-glycolide) (PLGA) microspheres generally requires optimization of the test conditions for a given formulation. This is particularly important when in vitro/in vivo correlation should be determined. Here, the somatostatin analogue vapreotide pamoate, an octapeptide, was microencapsulated into PLGA 50:50 by spray-drying. The solubility of this peptide and its in vitro release kinetics from the microspheres were studied in various test media. The solubility of vapreotide pamoate was approximately 20-40 microg/ml in 67 mM phosphate buffer saline (PBS) at pH 7.4, but increased to approximately 500-1000 microg/ml at a pH of 3.5. At low pH, the solubility increased with the buffer concentration (1-66 mM). Very importantly, proteins (aqueous bovine serum albumin (BSA) solution or human serum) appeared to solubilize the peptide pamoate, resulting in solubilities ranging from 900 to 6100 microg/ml. The release rate was also greatly affected by the medium composition. Typically, in PBS of pH 7.4, only 33+/-1% of the peptide were released within 4 days, whereas 53+/-2 and 61+/-0.9% were released in 1% BSA solution and serum, respectively. The type of medium was found critical for the estimation of the in vivo release. The in vivo release kinetics of vapreotide pamoate from PLGA microspheres following administration to rats were qualitatively in good agreement with those obtained in vitro using serum as release medium. Finally, sterilization by gamma-irradiation had only a minor effect on the in vivo pharmacokinetics.