Efficient yeast ChIP-Seq using multiplex short-read DNA sequencing.

BACKGROUND: Short-read high-throughput DNA sequencing technologies provide new tools to answer biological questions. However, high cost and low throughput limit their widespread use, particularly in organisms with smaller genomes such as S. cerevisiae. Although ChIP-Seq in mammalian cell lines is replacing array-based ChIP-chip as the standard for transcription factor binding studies, ChIP-Seq in yeast is still underutilized compared to ChIP-chip. We developed a multiplex barcoding system that allows simultaneous sequencing and analysis of multiple samples using Illumina's platform. We applied this method to analyze the chromosomal distributions of three yeast DNA binding proteins (Ste12, Cse4 and RNA PolII) and a reference sample (input DNA) in a single experiment and demonstrate its utility for rapid and accurate results at reduced costs. RESULTS: We developed a barcoding ChIP-Seq method for the concurrent analysis of transcription factor binding sites in yeast. Our multiplex strategy generated high quality data that was indistinguishable from data obtained with non-barcoded libraries. None of the barcoded adapters induced differences relative to a non-barcoded adapter when applied to the same DNA sample. We used this method to map the binding sites for Cse4, Ste12 and Pol II throughout the yeast genome and we found 148 binding targets for Cse4, 823 targets for Ste12 and 2508 targets for PolII. Cse4 was strongly bound to all yeast centromeres as expected and the remaining non-centromeric targets correspond to highly expressed genes in rich media. The presence of Cse4 non-centromeric binding sites was not reported previously. CONCLUSION: We designed a multiplex short-read DNA sequencing method to perform efficient ChIP-Seq in yeast and other small genome model organisms. This method produces accurate results with higher throughput and reduced cost. Given constant improvements in high-throughput sequencing technologies, increasing multiplexing will be possible to further decrease costs per sample and to accelerate the completion of large consortium projects such as modENCODE.

PeakSeq enables systematic scoring of ChIP-seq experiments relative to controls.

Chromatin immunoprecipitation (ChIP) followed by tag sequencing (ChIP-seq) using high-throughput next-generation instrumentation is fast, replacing chromatin immunoprecipitation followed by genome tiling array analysis (ChIP-chip) as the preferred approach for mapping of sites of transcription-factor binding and chromatin modification. Using two deeply sequenced data sets for human RNA polymerase II and STAT1, each with matching input-DNA controls, we describe a general scoring approach to address unique challenges in ChIP-seq data analysis. Our approach is based on the observation that sites of potential binding are strongly correlated with signal peaks in the control, likely revealing features of open chromatin. We develop a two-pass strategy called PeakSeq to compensate for this. A two-pass strategy compensates for signal caused by open chromatin, as revealed by inclusion of the controls. The first pass identifies putative binding sites and compensates for genomic variation in the 'mappability' of sequences. The second pass filters out sites not significantly enriched compared to the normalized control, computing precise enrichments and significances. Our scoring procedure enables us to optimize experimental design by estimating the depth of sequencing required for a desired level of coverage and demonstrating that more than two replicates provides only a marginal gain in information.