RESUMEN
Uranium mining and milling activities raise environmental concerns due to the release of radioactive and other toxic elements. Their long-term management thus requires a knowledge of past events coupled with a good understanding of the geochemical mechanisms regulating the mobility of residual radionuclides. This article presents the results on the traces of anthropic activity linked to previous uranium (U) mining activities in the vicinity of the Rophin tailings storage site (Puy de Dôme, France). Several complementary approaches were developed based on a study of the site's history and records, as well as on a radiological and chemical characterization of soil cores and a dendrochronology. Gamma survey measurements of the wetland downstream of the Rophin site revealed a level of 1050 nSv.h-1. Soil cores extracted in the wetland showed U concentrations of up to 1855 mg.kg-1, which appears to be associated with the presence of a whitish silt loam (WSL) soil layer located below an organic topsoil layer. Records, corroborated by prior aerial photographs and analyses of 137Cs and 14C activities, suggest the discharge of U mineral particles while the site was being operated. Moreover, lead isotope ratios indicate that contamination in the WSL layer can be discriminated by a larger contribution of radiogenic lead to total lead. The dendroanalysis correlate U emissions from Rophin with the site's history. Oak tree rings located downstream of the site contain uranium concentrations ten times higher than values measured on unaffected trees. Moreover, the highest U concentrations were recorded not only for the operating period, but more surprisingly for the recent site renovations as well. This integrated approach corroborates that U mineral particles were initially transported as mineral particles in Rophin's watershed and that a majority of the deposited uranium appears to have been trapped in the topsoil layer, with high organic matter content.
Asunto(s)
Monitoreo de Radiación , Uranio , Francia , Minería , Suelo , Uranio/análisisRESUMEN
A new rapid protocol for 226Ra separation and preconcentration in natural water samples was developed before its determination by Inductively Coupled Plasma Mass Spectrometry (ICP-MS). For this purpose, the commercially available Ra specific resin AnaLig® Ra-01 was used. This resin shows a high selectivity for radium in a large range of acid concentrations and no affinity or possible elution of 226Ra interfering elements. The distribution coefficients of Ra and other elements over a wide range of acid (HCl and HNO3) concentrations were obtained. Due to the high radium selectivity, the new developed protocol uses only 50â¯mg of dry resin and its performance was evaluated using 100â¯mL of three natural waters with different ionic strengths, spiked with a known quantity of 226Ra. Radium was successfully separated and preconcentrated yielding recoveries ranging between 72% and 86%. In parallel with the characterisation of the resin sorption properties, a detailed study of polyatomic interferences was performed on our ICP-MS allowing to identify the prominent elements favouring interferences at m/zâ¯=â¯226. Furthermore, a 226Ra sensitivity comparison between different ICP-MS instruments and configurations was done in order to determine high sensitivity conditions for radium analysis.
Asunto(s)
Radio (Elemento)/análisis , Contaminantes Radiactivos del Agua/análisis , Espectrofotometría Atómica , Análisis EspectralRESUMEN
The French Atomic Energy Commission has carried out several experiments for the study of minor-actinide transmutation processes in high intensity thermal neutron flux. In this context a Cm sample enriched in (248)Cm (â¼97%) was irradiated in a thermal neutron flux at the High Flux Reactor (HFR) of the Laue-Langevin Institute (ILL). The precise and accurate determination of Cf isotope ratios and of (249)Bk/(248)Cm and (249)Cf/(248)Cm elemental ratios in the (248)Cm irradiated sample is crucial for the calculation of actinide neutron capture cross-sections. This work describes an analytical procedure for the separation and the isotope ratio measurement of Bk and Cf in the irradiated sample. The Bk and Cf separation is based on a lanthanides separation protocol previously developed by the laboratory. Well-defined retention times for Bk and Cf were obtained by coupling the Ionic Chromatography (IC) with an ICP-QMS. All conditions of element separation by IC and the different steps of the analytical protocol in order to obtain the isotopic and elemental ratios are presented. Relative uncertainties of Cf isotopic ratios range from 0.3% to 0.5% and the uncertainty of the (249)Bk/(248)Cm and (249)Cf/(248)Cm elemental ratios are respectively 6.1% and 3.2%. This level of uncertainty for both isotopic and elemental ratios is in perfect agreement with the requirement for transmutation studies.