Electron Glass Phase with Resilient Zhang-Rice Singlets in LiCu_{3}O_{3}.

LiCu_{3}O_{3} is an antiferromagnetic mixed valence cuprate where trilayers of edge-sharing Cu(II)O (3d^{9}) are sandwiched in between planes of Cu(I) (3d^{10}) ions, with Li stochastically substituting Cu(II). Angle-resolved photoemission spectroscopy (ARPES) and density functional theory reveal two insulating electronic subsystems that are segregated in spite of sharing common oxygen atoms: a Cu d_{z^{2}}/O p_{z} derived valence band (VB) dispersing on the Cu(I) plane, and a Cu 3d_{x^{2}-y^{2}}/O 2p_{x,y} derived Zhang-Rice singlet (ZRS) band dispersing on the Cu(II)O planes. First-principle analysis shows the Li substitution to stabilize the insulating ground state, but only if antiferromagnetic correlations are present. Li further induces substitutional disorder and a 2D electron glass behavior in charge transport, reflected in a large 530 meV Coulomb gap and a linear suppression of VB spectral weight at E_{F} that is observed by ARPES. Surprisingly, the disorder leaves the Cu(II)-derived ZRS largely unaffected. This indicates a local segregation of Li and Cu atoms onto the two separate corner-sharing Cu(II)O_{2} sub-lattices of the edge-sharing Cu(II)O planes, and highlights the ubiquitous resilience of the entangled two hole ZRS entity against impurity scattering.

ISO 4037:2019 VALIDATION OF RADIATION QUALITIES BY MEANS OF HALF-VALUE LAYER AND HP(10) DOSIMETRY.

Radiation qualities were characterised and validated at the fully automated X-ray calibration facility of the Individual Monitoring Service at Helmholtz Zentrum München by using half-value layer and Hp(10) dosimetry approaches specified in the updated ISO 4037:2019 standard. As the ISO 4037 contains a somewhat vague description of the half-value layer procedure, we extended it to be more constrained and thus less subjective in its implementation. We specify both the measurement and data analysis steps performed in order to provide reproducible half-value layer results and compare the results with the Hp(10) dosimetry-based validation approach specified in the ISO 4037 as an alternative for field validation. Finally, we discuss the implications of our results and the extended procedure on validation and the recent changes to the ISO 4037.

A FULLY AUTOMATED SECONDARY STANDARD X-RAY CALIBRATION FACILITY FOR PERSONAL DOSEMETERS.

The individual monitoring service at the Helmholtz Zentrum München has extended the calibration facilities provided at the Munich IAEA/WHO secondary standard dosimetry laboratory with a new fully automated X-ray calibration facility for the calibration of personal dosemeters according to the ISO 4037 standard series. This work describes the X-ray irradiation system and the automated dosemeter transport system as well as the measurements performed to characterize the photon fields and to ascertain conformity to the ISO standard. Standard uncertainties of the radiation quantities provided by the system are given together with a discussion of some of the problems that are encountered in fulfilling the requirements of a matched field according to the latest drafts of the ISO 4037-1 standard.

SIMULATION OF OSL AND TLD DOSEMETER RESPONSE FOR THE DEVELOPMENT OF NEW EXTREMITY DOSEMETERS.

The individual monitoring service at the Helmholtz Zentrum München is currently developing a new eye lens dosemeter to be integrated in radiation protection glasses and a new ring dosemeter using a new BeOSL detector element for extremity dosimetry developed by Dosimetrics. In the design process for the new eye lens dosemeter, MCNP6 Monte Carlo simulations were used to model the energy and angular response of new dosemeters before ordering the expensive tools for injection molding. This study describes the simulation of the dosemeter and detector, and the involved calculations do obtain the response in terms of the radiation protection quantity Hp(3). Simulations were carried out also for existing whole body dosemeters and TLD rings in order to verify the MC tools. With the final dosemeter prototypes becoming available earlier this year, all MC models could be verified and show very good agreement with experimental data.

Identification of macrolide- and rifampicin-resistant Rhodococcus equi in environmental samples from equine breeding farms in central Kentucky during 2018.

Rhodococcus equi causes severe pneumonia in foals and is most often recognized in people as an opportunistic pathogen. Longitudinal studies examining antimicrobial-resistant R. equi from environmental samples are lacking. We hypothesized that antimicrobial-resistant R. equi would be detectable in the ground (pasture soil or stall bedding) and air at breeding farms with previous documentation of foals infected with resistant isolates, and that concentrations of resistant isolates would increase over time during the foaling season. In this prospective cohort study, ground and air samples were collected from stalls and paddocks in January, March, May and July of 2018 at 10 horse-breeding farms with history of foal pneumonia attributed to macrolide- or Rifampicin-resistant R. equi. Environmental samples were cultured in the presence and absence of macrolides and Rifampicin to select for resistant organisms. Data were analyzed with linear mixed-effects and Hurdle models. Concentrations of total R. equi in bedding or air of stalls were significantly (P < 0.05) higher in January than other months. The proportion of resistant R. equi in soil samples from paddocks was significantly (P < 0.05) higher than stall bedding during all months. For each month, air samples from paddocks had a significantly (P < 0.05) higher proportion of resistant isolates than those from stalls. Fifty-five percent of resistant soil isolates and 34% of resistant air isolates were considered virulent by identification of the vapA gene. Concentrations of resistant R. equi isolates did not increase over time during the foaling season. Antimicrobial-resistant R. equi can persist in the environment at farms with a history of pneumonia caused by resistant R. equi infections, and exposure to resistant isolates in paddocks and stalls appears stable during the foaling season. Resistant isolates in the environment not only pose a risk for disease but also can serve as a repository for dissemination of resistance genes.

Observation of changes in urinary excretion of thorium in humans following ingestion of a therapeutic soil.

The study investigated the changes in urinary thorium excretion by humans following ingestion of a therapeutic soil, which contains about 10 ppm of thorium. This well-known healing earth in Germany has been considered as an alternative medicine for diarrhoea and gastric hyper-acidity. Six adult volunteers ingested this therapeutic soil in varying quantities for 1-15 days at levels approximating those described in the package insert of the medicine (10-60 g of soil per day). The subjects ingested about 0.1-0.6 mg of thorium daily, which is 100-600 times higher than the normal daily intake of about 1 microg thorium in Germany. All 24-h urine samples collected from the subjects during pre-ingestion, ingestion and post-ingestion periods of the soil were analyzed for (232)Th using inductively coupled plasma mass spectrometry (ICP-MS). The measured excretion values varied in a wide range. Apparently, the high thorium amounts administered did not increase the (232)Th excretion in urine as expected, suggesting that this soil ingestion will not result in a considerably higher and harmful uptake of thorium into the human body.

Measurement techniques for tracer kinetic studies with stable isotopes of zirconium.

Biokinetic models are used in radiation protection to assess internal radiation doses. Experiments with stable isotopes as tracers can be performed to obtain characteristic parameters of these models. Two methods for the measurement of zirconium isotopes in human biological samples are presented--thermal ionisation mass spectrometry (TIMS) and proton nuclear activation analysis (PNA). Descriptions include sample preparation, operating conditions, relative uncertainties and method detection limits as well as important properties of both methods.

SECONDARY STANDARD CALIBRATION, MEASUREMENT AND IRRADIATION CAPABILITIES OF THE INDIVIDUAL MONITORING SERVICE AT THE HELMHOLTZ ZENTRUM MÜNCHEN: ASPECTS OF UNCERTAINTY AND AUTOMATION.

The individual monitoring service at the Helmholtz Zentrum München has adopted the recommendations of the ISO 4037 and 6980 standards series as base of its dosimetric systems for X-ray, gamma and beta dosimetry. These standards define technical requirements for radiation spectra and measurement processes, but leave flexibility in the implementation of irradiations as well as in the resulting uncertainty in dose or dose rate. This article provides an example for their practical implementation in the Munich IAEA/WHO secondary standard dosimetry laboratory. It focusses on two aspects: automation issues and uncertainties in calibration.

Differences in exhaled gas profiles between patients with type 2 diabetes and healthy controls.

AIMS: Recent advances in analytical technology allow the detection of several hundred volatile organic compounds (VOCs) in human exhaled air, many of which reflect unidentified endogenous pathways. This study was performed to determine whether a breath gas analysis using proton transfer reaction-mass spectrometry (PTR-MS) could serve as a noninvasive method to distinguish between patients with type 2 diabetes mellitus and healthy controls. METHODS: Breath and room air samples were measured from 21 patients with insulin-treated type 2 diabetes and 26 healthy controls. VOCs in the mass range of 20-200 atomic mass units were analyzed using PTR-MS. RESULTS: We identified eight masses characteristic of endogenous VOCs that showed significant differences in the gas profiles of patients with type 2 diabetes and healthy control subjects. Using these VOCs for linear discriminant analysis, the sensitivity and specificity were found to be 90% and 92%, respectively. CONCLUSIONS: These results suggest that it is possible to separate patients with diabetes mellitus type 2 from healthy controls by multivariate analysis of exhaled endogenous VOCs. This is a first step towards the development of a noninvasive test using breath gas of at-risk persons and making it an attractive option for large-scale testing of at-risk populations. However, the establishment of exhaled volatiles as metabolic markers requires additional confirmatory investigations.